SOURCE: 94 Jeep Wrangler intermittently stalls when put in reverse, drive
Take the air inlet hose off where it enters the throttle body and take a look at the throttle plates. It is likely that they’re dirty and have a build-up of carbon deposits. That is the most common cause for stalling that we see in the shop for your vehicle. Sometimes all it takes is a good cleaning to cure the stalling problem. There is an idle speed setting on your Jeep, but to check and/or perform this service step requires the use of a computer scan tool for your vehicle. If the cleaning doesn’t help ask a repair facility to check and reset, if needed, the minimum idle speed on your Jeep.
Thnx.
SOURCE: car stalls when i put it in drive or reverse,
Sounds like your vacuum assist brakes diaghram has sprung a leak. Pull the hose to the assist and plug it with a bolt or something. Then try it.
SOURCE: wont keep idle, car stalls out
I had this same problem on my 2005 monte carlo, took mechanic a while to figure out it was the idle air control valve. They also replace the idle air control motor.
SOURCE: When I pump gas into my 2000 Hyundai Sonata my car
It is possible that when fueling, the fuel is aerated and the pump pulls agitated fuel into the system. you can thry this, fuel up as normal, but wait five or more minutes before starting. see what happens. good luck
127 views
Usually answered in minutes!
×