A warning light came on in my 2010 Fusion yesterday just after 10 am and the manual read:Airbag readiness: If this light fails to illuminate when the ignition is turned to on, continues to flash or remains on, contact your authorized dealer as soon as possible. A chime will sound when there is a malfunction in the indicator light. But the light went off at 9 this morning while I was driving to work. Should I bother to conatact the dealership?
SOURCE: ford focus ignition warning light
hi with the engine running at idle .get a multimeter and check for a voltage of between 13.5 volts and 14.7 at the battery terminals lower than 13.5 or higher than 14.7 replace alternator.
SOURCE: ESP/ABS warning lights illuminates
the abs switch could be going bad or the relay for it could be weak.the relay is under the hood.have it checked taking care of one problem could solve the other
SOURCE: Ford Fusion 04 Engine Management Light
I had a 2002 model 1.4 Fiesta, same problem Engine management light or
ECA, electronic accelaration Control (EAC), it needs a ford dealer to do
a computer diagnostic, most likely that it will need replaced.
Mt friend who is a mechanic for ford said that it was a common factory
fault and is very common in 1.4 zetec /duratec petrol models.
I now have a 2007 Fusion and was quick to see if this problem had been sorted on this model, and it has!!
Hope this helps!!
SOURCE: warning chime continues to chime as I drive
My guess is a faulty switch at door for turning off interior lights/door closed, which is giving chime that door is still open
SOURCE: how to reset airbag light on 2008 ford fusion
Here's a quick check list for most common cost of SRS / Air bag problem.
Dirty contacts on driver and passenger seat belt buckles
Dirty contacts on seat belt connectors (under seats)
Dirty contacts on driver and passenger sides weight sensors (under seat)
Seat covers
Weight on passenger seat
(Example: grocery package trigger SRS / Air Bag light on the way home.)
I recommend you to pass an vacuum over the contacts and use CRC electronic parts cleaner to rule out connectivity problem.
I DO NOT disconnecting the negative battery connector to clean the code(s)
Without the code(s) the dealer will takes "BILLABLE" time to reproduce the problem.
======
Please rate me answer if it is useful to you.
Cheers,
Mustgo
159 views
Usually answered in minutes!
×