Question about Mazda Cars & Trucks

2 Answers

2010 Mazda 6, room fuse. A few weeks ago, my radio, interior dome lights and power locks all stopped working at the same time. Come to find out the fuse labeled "room" was blown. Replaced it and didn't have an issue until a couple days ago when it happened again. Replaced the fuse and was fine until today. Any thoughts on why the room fuse would keep blowing?

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 1 Answer

I just had the same trouble in a 02 mazda millennia. found the SHORT.it was in the wiring of the drivers sun visor lights. no kidding, too simple. I hope yours is as easy to fix,,

Posted on Mar 07, 2014

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 542 Answers

The fuse is doing its job. There is a surge of power going down the line from somewhere. Have you added anything to your car? Was you turning anything on or off when it happen.?

Posted on Aug 22, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 65 Answers

SOURCE: Keyless Entry and Remote

I have had this problem take you drivers door put your key and un-lock from the out side with key (NO) then open the door push un-lock from the inside button and then set from you remote and it should set if not push un-lock then lock and then do the un-lock with the key. Let me know if that works. what my car did was locked from the inside and I had the problem were it would not work till I un-locked from the out side plus I had to go to radio shack and change the battery from the control.
Hope good happens.
Nikki2913

Posted on Dec 29, 2008

motor1258
  • 6674 Answers

SOURCE: 2006 Dodge ram 2500 diesel Quad, door locks

Try checking under hood in power distribution box for blown fuses also, or bad connection to it.

Posted on Mar 13, 2009

  • 12 Answers

SOURCE: Blown Fuse / Electrical problem??

There is a short curcuit in the circuit that fuse protects. Is the radio original equipment or is it an aftermarket radio that has been replaced before? If it has been "worked on" by anyone lately or is not OEM, I would concentrate some there 1st to find the wire being "grounded or shorted". Also, check the door switches to see if they are loose or causing a wire to short against the door jamb. If you can't find the cause of the short, take it to an ASE certified electrical specialist, they will know how to diagnose and repair it. Electrical problems are extremely difficult to diagnose without seeing the car and therefore the price to fix the problem would be difficult to predict as well. But a specialist would likely find the problem in the least amount of time, and though their rates may be higher/hour, the outcome may still be quite a bit lower because they will find the problem faster due to their higher competence. Best wishes!

Posted on May 10, 2009

  • 122 Answers

SOURCE: 2003 ford escape, fuse keeps blowing for door locks, radio and dome light. y

check for a shorted to ground positive wire repair as nesseacry

Posted on Jun 04, 2009

  • 632 Answers

SOURCE: 2000 vw beetle the pwr windows, pwr trunk, pwr

The easy part of this problem is knowing what it is, the difficult part is finding where it's shorting out. With the meters of wire and harness it would be discouraging thinking about it. Knowing VW took a lot of time engineering to avoid this simple problems, there are conditions that couldn't prevent this.

First off, have you recently installed an aftermarket part that hooks up to the wiring system e.g. radio, gauges, gps or other electronic accessory? Something added that needed a harness moved to make it fit or needed splicing a wire to power it up?

There are times when doing electrical work, the person doing it doesn't realize while stripping insulation from new wire that a strand of wire fell in a switch, fuse terminal causing a short in it's circuit.
You'd need to clean the fuse area with a clean paint brush to dust off any metal debris. Another way is by simply using a digital VOM with continuity tone to single out which component is causing it to blow the fuse.

Another suggestion is use a VAG 1552 scan tool or equivalent. This will also help pinpoint which component to look at and narrow the search area.

If you're a DIY kind of person and want to know how your vehicle works, wanting to get a little more involved. You'll need a Windows based laptop and purchase a ROSS-Tech software by clicking on the address.

Posted on Jun 19, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Por favor, necesito diagrama de caja de fusibles para Mazda B2300 del 2001


Mazda B-Series (2001) - fuse box diagram Year of production: 2001

Interior fuse panel

Mazda B-Series - fuse box -
interior fuse panel Number Ampere rating [A] Description 1 5 Power Mirror 2 10 Blower Motor Relay, Air Bag Diagnostic Monitor, Passive Deactivation (PAD) Module 3 7,5 Trailer Tow Connector (LH Stop/Turn) 5 10 4×4 Control Module 7 7,5 Trailer Tow Connector (LH Stop/Turn) 9 7,5 Stoplamp Switch 10 7,5 Cruise Control Servo/Amplifier Assy., GEM/CTM, Shift Lock Actuator, Blend Door Actuator, A/C Heater Control Assy., Turn Signals 11 7,5 Instrument Cluster, Main Light Switch, RABS Resistor 13 20 Brake Pedal Position Switch 14 20 RABS Module 10 4WABS Mod., 4WABS Main Relay 16 30 W/W Motor, Wiper Hi-Lo Relay, Wiper Run/Park Relay, Washer Pump Relay 17 25 Cigar Lighter, Data Link Connector (DLC) 19 25 PCM Power Diode, Ignition, PATS 20 7,5 GEM/CTM, Radio 21 20 Flasher 22 20 Auxiliary Power Point 24 7,5 Clutch Pedal Position (CPP) Switch, Starter Interrupt Relay 26 10 Battery Saver Relay, 4×4 Electronic Shift Relay, Interior Lamp Relay, 4×4 Elec. Shift Control Module, Dome/Map Lamp, Instrument Illumination Dimming Module, Restraint Control Module, GEM/CTM, Instrument Cluster 28 7,5 GEM/CTM System, Radio 29 15 Radio 33 15 Headlights, DRL Module, Instrument Cluster 35 15 ISA Horn Relay if not Equipped with Truck Security Module

Engine compartment fuse block

Mazda B-Series - fuse box -
engine compartment Number Ampere rating [A] Description 1 50 I/P Fuse Panel 6 50 ABS Pump Motor 7 30 Powertrain Control Module 8 20 Power Door Locks and Remote Entry 11 50 Starter Relay Ignition Switch 12 10 PCM Memory 13 20 4×4 Motor 16 40 Blower Motor 21 10 PCM Memory 23 20 Fuel Pump Motor 24 30 Headlights 25 10 A/C Clurtch 28 30 4WABS Module 30 15 Trailer Tow 31 20 Fog Lamps, Day Time Running Lamps (DRL) 33 15 Park Lamp 38 10 Left Headlamp Low Beam 41 - Heated Oxygen Sensors 42 10 Right Headlamp Low Beam 45A - Wiper High/Low 45B - Wiper Park/Run 46A 46B - Front Washer Pump 47A 48A - Fog Lamp 48B - Fog Lamp Relay 49 - Full Starter 50A 50B - Fuel Pump 53 - Powertrain Control Module (PCM) Diode 54 - Powertrain Control Module (PCM) Diode 55 - Blower 56A - A/C Clutch Solenoid 56B - Trailer Tow

Jul 04, 2017 | Mazda Cars & Trucks

1 Answer

No dash, radio or door activated interior lights. Checked fuses already


Dash lights (Gone?) - FSB Forums - FullSizeBronco.com

www.fullsizebronco.com/forum/21.../198643-dash-lights-gone.html
Sep 7, 2011 - Fully rotating the shaft counterclockwise past a notch activates theinterior lights within the vehicles. ... No aftermarket stereo, the dash lights stopped working, and my taillights ... 8 15 Courtesy/Dome/Cargo Lamps, Electric Outside Mirrors, ... 12 20 C.B. Power Door Locks, Electronic Shift Motor 4WD, Power ...

Radio died, remote system not working, door locks will not work ...

www.topix.com > Chrysler Sebring
Aug 13, 2008 - So what all is not working at this time is: Door locks (with remote it only ... My lights on the dash dim some times and if I hit a bump the radio goes off, ... All the fuses are good, but still no power to the radio, interior lights, push ...

2009 Chrysler Town and Country No Dash instrument cluster lights ...

forum.chryslerminivan.net/.../55281-2009-Chrysler-Town-and-Country-...

Jan 13, 2014 - 10 posts - ‎5 authors

Dec 21, 2015 | Cars & Trucks

1 Answer

99 Durango- after battery change chg that dome light, radio and tripometer stopped working.


didnjt i see this question a few days ago ,i think they blew a fuse connecting up a secondary power source by the sound of it

Nov 21, 2013 | Dodge Cars & Trucks

1 Answer

Why does my room fuse keep blowing


Now you have a big Short, will be a good ide to Run the scanner/computer and fix it. Do not waste time+money. Remember the electronic vehicle is complicated now.
see the diagram attached.fb2b20d0-ca04-4fbe-a0f3-cba7c3144854.jpg

Jul 27, 2013 | 2000 Mazda 626

1 Answer

Interior lights and radio stopped working and locks won't lock unless keys are in ignition


Hi Laura, Im glad to help!

Laura, anytime a fuse is blowing that means that the power side of the circuit is shorting out against something that's metal, it also can be a part itself that's shorting out. This is a very time consuming issue to find and can wind up costing you an arm and a leg. Call me Al 314-374-5218. Shorts are very common but must be traced down on the circuit fuse that is blowing. Hope this helps and have an awesome day Laura.

Apr 02, 2013 | 1999 Mazda Millenia

1 Answer

I accidentally hooked up the battery, reversing the polarity. I corrected the screw-up, but now the radio and interior lights will not come on. Fuses look good. any suggestions on fixing the radio &...


Ouch! Okay, do you have a volt meter? If so you need to check the voltage at your fuse box to make sure that you are getting power to fuse panel If you are getting power to the panel, then you have to diagnose the power issue from the fuse panel to the radio and dome lights. All the lights not working? The radio may have an in-line fuse as well. If you don't have a volt meter, go get one.

Jan 25, 2011 | 2001 Mazda MPV

1 Answer

WHAT IS A BTN FUSE ON A 1992 MAZDA MPV . IT HAS SOMETHING TO DO WITH THE HEADLIGHTS OR DIMMER SWITCH I THINK


BTN stands for Body/Tail/iNterior. It protects the HAZARD, ANTENNA, ROOM, STOP, ILLUM and ABS fuses in the cabin fuse box, which in turn protect the hazard lights, antenna, ECU memory, brake lights, tail lights2.gif, ABS, power locks, clock, horn, illumination, stereo, HVAC, interior lights and alarm. smile.gif __________________

Jul 21, 2009 | 1992 Mazda MPV

2 Answers

Electrical problem


I just had the same issues. No headlights, interior lights, power door locks, radio controls on steering wheel, or dash lights. Pulled every fuse in cab and under hood, not a one was bad. I disconnected the battery terminals for a few minutes. When I reconnected them every thing was working.

Jun 28, 2008 | 2001 Dodge Dakota

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

2,771 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

Marvin
Marvin

Level 3 Expert

84625 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...