My power windows won't operate. Ihave checked the

The following components are used to control the power windows:
• Driver door module (DDM)
• Passenger front door module (PDM)
• LH rear door module (LRDM)
• RH rear door module (RRDM)
• Driver door switch assembly (DDSA)
• RH front power window switch
• LH rear power window switch
• RH rear power window switch
• LH front power window motor
• RH front power window motor
• LH rear power window motor
• RH rear power window motor
• Class 2 serial data link
• DR MOD PWR C/B 30 Amp circuit breaker
• DRIVER DR MOD 10 Amp fuse -- DDSA and DDM logic, DDM internal driver operation.
• PSGR DR MOD 10 Amp fuse -- PDM logic and internal driver operation.
• REAR DR MOD 15 Amp fuse -- LRDM and RRDM logic and internal driver operation

didnt specify vehicle -generic answer -pop out switch and test for power and operation if no power to switch will need to check harness -if power to but not after switch replace switch--good switch will need to remove door panel and test window motor /egulator
power window problem Yahoo Video Search Results

check fuse first/ if good check wires at the switch for voltage if all good check for voltage going to window motor if no voltage replace switch if you have voltage (12) v change motor

first thing first check ur fuse for the power window. look at ur car manual to locate the switch box. if the fuse is good check the window motor by removing the door panal then locating it inside the door. use a power tester to see if power is getting to the motor by connecting it to the positive (red) wire connected to the window motor. if its not getting power the change the motor. if it is then you may have a window switch problem. if you have change the motor, switch, and fuse the you make have a wire shortage proble so take it to a payed professional for further advice or service. good luck

first check fuse if good then check to see if there is power from the window switch. If yes then check window motor it's probley bad.If the motor runs then the regulater is shot.

The master switch connector does have circuits that have power on them. The Master switch is not directly connected to the window motors. The switch sends a signal to the Front Electronic Module and the module controls operation of the motor on the driver side. The passenger door window motor is controlled by a different module

I would check the fusible links at the starter motor to see if any fell rubbery which indicates they are burnt out.

the motor in the drivers door is probably bad. check to make sure it has power and ground with a test light at the motor with the wires unpluged.

HI there your problem is the motor . each window has it's sprat
motor . to be shore check the switch by remove it from console .
and with a test light
find the wires cumming out of the switch for driver side door window
see if you have power . you should have power on one wire all
the time with ignition switch in the on bastion .if you have power
as you operate the window switch .put the window is still not going
up or down you need window motor.

good luck re post if you need more help OK

Does the rear window work from the passenger switch?