SOURCE: 1993 chevy van g20 water pump replacement
you will need some fairly long wrenchs 15mm-16mm to get leverage on the spring loaded serp tesiner put a wrench on the pulley near the belt ? also loosen the 4 fan bolts on the water pump before you remove the belt ? ther are 7 fan shroud bolts you can split the fan shroud ? 2 bolts on the lower right and 2 on the left ? after you do this then you should be down to pulling off the fan and pulley just slides off ? then remove the 4 waterpump mounting boltss, scrape the old gaskets ? when this is done all you have left is to installthe fan studs from the old pump? you do this by screwing down 2 nuts on the stud then with 2 wrenchs lock the nuts together ? then unscrew the bottom nut ? keep doing that till all 4 are replaced? install the gaskets and add some silicone and reverse the process ? hope this helps repost thumbs up !!
SOURCE: We have a 1993 Chevy C1500 with a 5.7 that is
something is creating alot of air to pass over the 02 sensor.
Low compression
Big vacuum leak.
Weak ignition
IAC stuck a little open.
TPS that is saying your foot is on the gas when it is not.
EGR stuck open a little.
Too low an idle
Weak spark plugs
Bad fuel pressure regulator
No vacuum to the fuel pressure regulator.
Bad coolant temp sensor.
What are the readings. Need to know the co and the hc reading in order to know if you have a misfire or an over fueling issue. All 5 reading are really needed to diagnose fuel related issues sight unseen
SOURCE: what is the timing set at on a chevy 350 5.7l 1993
zero
Testimonial: "worked great. Thank you"
SOURCE: where is the fuel filter
Hi!!
PCV valve located under engine cover, top of engine, mounted in passenger side valve cover
Fuel filter is located Under vehicle, passenger side, below seating area, front of fuel tank, mounted on chassis
DON'T FORGET TO RATE THIS POST!!
262 views
Usually answered in minutes!
×