Need size of battery for 2000 ford focus

The 2000 Ford Focus has the Zetec engine, I believe. On the Zetec, the camshaft timing using notches carved out of the REAR end of the camshafts. With the valve cover off, you would need a special tool(we use a metal piece similar to the shape and size of a measuring ruler we all used in k-12 school) to insert into both camshaft rear notches to line up the timing. Other than that just make sure the crank is lined up. Presto!

Note: There are 2 ways those notches can line up, there's "right side up" and "upside down" ... The special tool should ONLY fit into the notches when they are right side up. The thickness of the tool would need to be about 2-3mm(I think).

Good luck!

take number 1spark plug out and put number one piston at top dead center of the chamber that's will be your timing make sure to mark the harmonic balance r

What engine does yours have ? 2.0l Zetec ? You need special tools !

there are special tools needed to time the engine.

the focus has struts, no shocks, use need special tools to replace struts

is difficult you need a press and some special tools as torquemeter to set the nuts to avoid the worn out of the new bearings.try to a local garage.buy the parts by yourself and the cost isnt so high!

Click on the following direct Link.
With the DOHC you will need the Camshaft Sprocket Holding Tool and Camshaft Alignment Tool.

Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!

http://www.2carpros.com/car_repair_information/year/2000/make/ford/model/focus/2000_ford_focus_timing_belt_diagram_marks.htm

there are no marks, special tools are needed when replacing the timing belt.

Special tool required, see a good auto part store for the tool

please helpme i need timing marks for ford focus 2000 16 valvs