Question about 2004 Suzuki Aerio

1 Answer

How to remove and install alternator on 2001 kia sephia

Posted by on

  • poopitts Apr 02, 2009

    i did all that..now,how do i re move the alternator from behind the motor?

  • poopitts Apr 02, 2009

    no to both questions

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Suzuki Master
  • 2,989 Answers

    1. Remove or disconnect the following:
    2. Negative battery cable
    • Front air intake inlet pipe bolts
    • Top hose from the air intake inlet pipe
    • Air intake inlet pipe clamp and the pipe
    • Alternator B terminal cover cap
    • Alternator B terminal nut and the B terminal lead
    • Alternator L and S electrical connections
    • Alternator pivot bolt and the tensioner mounting bolt, loosen but do not remove
    • Drive belt(s); relieve tension on the belt by rotating the adjustment bolt
    • Alternator tensioner mounting bolt and the belt tensioner
    • Alternator pivot bolt
    1. Loosen the bolt at the base of the adjusting bracket and rotate the bracket up.
    2. Remove or disconnect the following:
      • Alternator

    Posted on Apr 02, 2009

    • 2 more comments 
    • Greg Bernett
      Greg Bernett Apr 02, 2009



      1. Install or connect the following:

      2. Alternator


      • Alternator pivot bolt and hand-tighten at this time


      1. Rotate the adjusting bracket into position, place the belt tensioner into position. And hand-tighten the mounting bolt.
      2. Install or connect the following:

        • Drive belt

      3. Adjust the belt tension by rotating the adjustment bolt. The belt deflection is as follows:

      4. New belt: 0.23–0.31 in. (6–8mm).
      5. Used belt: 0.28–0.35 in. (7–9mm).

      6. Tighten the tensioner bolt to 14–19 ft. lbs. (19–26 Nm) and the pivot bolt to 28–38 ft. lbs. (38–51 Nm).



      1. Install or connect the following:

      2. Alternator L and S electrical connections


      • Alternator B terminal lead and nut
      • Alternator B terminal cover cap
      • Air intake inlet pipe and fasten the clamp
      • Top hose to the air intake inlet pipe
      • Front air intake inlet pipe bolts
      • Negative battery cable
  • Greg Bernett
    Greg Bernett Apr 02, 2009




    Here ya go

  • Greg Bernett
    Greg Bernett Apr 02, 2009

    What is it looking like as far as where you have the most clearance or possibility or rotating it out?



    Do you have the room to get it out?

  • Greg Bernett
    Greg Bernett Apr 03, 2009

    Real quick....this is not an "inappropriate" rating...it is a "thanks for Trying". This is why the folks on here do not respond to some of your questions.



    Thank you.

  • ×

    Ad

    1 Suggested Answer

    6ya6ya
    • 2 Answers

    SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

    Hi there,
    Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

    Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

    Here's a link to this great service

    Good luck!

    Posted on Jan 02, 2017

    Ad

    Add Your Answer

    Uploading: 0%

    my-video-file.mp4

    Complete. Click "Add" to insert your video. Add

    ×

    Loading...
    Loading...

    Related Questions:

    1 Answer

    Good alternator, good battery but my kia sephia 2001 discharge the battery and doesnt start


    could simply be the light not going out in the glove box, trunk etc....

    Jul 19, 2011 | 2001 Kia Sephia

    1 Answer

    Had to jumpstart car. Kills a few minutes after jumper cables are removed but will stay running as long as jumpers cables are on. Replaced alternator, still the same. 2001 Kia Sephia


    Hi, check your stator and charge fuses.
    stator is powered by the 10 amp ECU fuse.
    charge is the 120 amp ALT fuse.
    Thanks for using FixYa.

    jturcotte_658.gif

    Dec 29, 2010 | 2001 Kia Sephia

    1 Answer

    How do you replace an alternator belt in a 2001 kia sephia


    Welcome to FIxYa.com



    Replacement

    1. Remove AC and P'S drive belt, it equipped.

    2. Loosen generator mounting bolt and adjusting bolt.

    3. Remove generator belt.

    4. Install new generator belt and adjust to specification.

    5. Tighten all bolts to specified torque.

    Tightening torque mounting bolt: 27-38 Lb-ft (37- 52 N.m. 3.8 -5.3 kg-m)

    Adjusting bolt: 14 - 18 Lb-ft (19 -26 N.m. 1.9 -2.6 kg-m)

    Image

    6. Install AC and P'S drive belt, if equipped. and adjust to specification.

    leedavidian_148.jpg



    Thank you for using FixYa.com

    Regards, Lee Davidian

    Dec 21, 2010 | 2001 Kia Sephia

    1 Answer

    How do you replace an automatic transmission in a 2001 kia sephia?


    Your best bet to do this would be to get the Haynes or Chilton's repair manual on your vehicle so you have step by step removal and installation instructions as well as adjustment procedures.

    Sep 30, 2010 | 2001 Kia Sephia

    1 Answer

    How do u remove a alternator from a 98 Kia sephia


    Loosen the alternator belt, then remove the two bolts that hold the alternator to the engine block, one is on the top right corner of the alternator and the other is at the bottom right on the back.
    You will have to remove the engine mount bolt, then you can jack up the engine in order for the alternator to fit between the intake manifold and the firewall.

    Sep 12, 2010 | 1998 Kia Sephia

    1 Answer

    How to replace Alternator on 2001 Kia Sephia


    You may try removing the engine mount and slightly raising the engine. It will give you much more room to work. I had to replace the timing belt on mine and I resisted this advice for a while. Once I finally did, the job went much quicker. I placed a jack under the oil pan (with a block of wood between jack and oil pan) and then upped the jack until it just made contact. Then I removed the engine mount directly in front of the serpentine belt. You can then slowly jack the engine up to gain more room. I can't remember where the alternator is on the sephia (up high on the motor or down low). If it's low, you could just lower the jack slowly to gain more room.


    Dec 29, 2008 | 2001 Kia Sephia

    1 Answer

    2001 Sephia, rebuilt alternator, now won't start


    check the alternator see if the silinoid is not sticking.jack it up and have some one put the hand under ste cilinoid and if they feel some kind of movement then it's not the alternator hope that helps

    Jun 30, 2008 | 2001 Kia Sephia

    Not finding what you are looking for?
    2004 Suzuki Aerio Logo

    608 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Suzuki Experts

    Marvin
    Marvin

    Level 3 Expert

    83951 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22441 Answers

    Jeffrey Turcotte
    Jeffrey Turcotte

    Level 3 Expert

    8841 Answers

    Are you a Suzuki Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...