Question about Hyundai Cars & Trucks
Cylinder head torque spec & sequnce hyundai h100
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Tighten in sequence to 29ft.lbs then tighten in sequence to 58ft lbs. then loosen all bolts. Then tighten in sequence to 33ft lbs. then tighten each bolt in sequence 90 degrees then tighten each bolt again 90 degrees
Posted on Jul 26, 2009
BMW cylinder torque setting all models
According to my service manual as follows.
Cyl head to engine block (torx e12 M10 bolts)
Stage 1 30nm (22 ft – lb)
Stage 2 + 90 degrees
Stage 3 + 90 degrees
Cyl head to lower timing chain cover 10nm (89in – lb)
The tightening sequence is from inside to outside crossover as normal. Loosening sequence is from outside to inside crossover. Remember to set torque wrench at low setting and work gradually up through the whole sequence until you get the desired torque.
Posted on Aug 29, 2009
Tips for a great answer:
Jan 11, 2018 | Hyundai Cars & Trucks
Nov 29, 2016 | Hyundai Cars & Trucks
Nov 25, 2016 | Ford F-250 Cars & Trucks
Jul 15, 2016 | Hyundai Cars & Trucks
Dec 29, 2015 | Hyundai Cars & Trucks
Aug 01, 2014 | 2008 Hyundai H100 2.6iD
May 26, 2012 | Hyundai Cars & Trucks
304 people viewed this question
Usually answered in minutes!