Question about Ford Cars & Trucks

Open Question

2012 ford e350 van. where is the rear blower motor resistor?

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

mutthu273
  • 3 Answers

SOURCE: location of blower motor resistor

in china

Posted on Jun 16, 2008

emissionwiz
  • 75005 Answers

SOURCE: blower motor resistor

It is under the hood in the heater case (passenger side), the right side of the case near the firewall as you face the engine.

Posted on Sep 02, 2008

  • 321 Answers

SOURCE: Will a rear end out of E350 Ford interchange with a Chevy 3500 dually

Is the c/k 3500 4 wheel drive?If it is 4WD,you must retain the same gear ratios for both front and rear axles,or the transfer case will be damaged.If it is 2 wheel drive,you can install any gear you like.I believe the Ford E350 rear axle is a Dana 70,as i have rebuilt 2 of that model,along with Dana 60's.The Ford unit likely will not be a bolt in.It will probably require professionally welding new mount brackets on the Ford axle housing.The width needs to be measured from inside the brake backing plate to the other brake backing plate to see if it will physically fit.Good luck.

Posted on Sep 13, 2008

  • 270 Answers

SOURCE: Location of the rear blower

The blower motor resistor gets very hot, so it is always located in a position where the blower can keep it cool. Inside the box with the blower but accessed from the outside, usually with two screws holding it in.

Posted on Jul 06, 2009

  • 1341 Answers

SOURCE: 1994 ford e350 cargo van, blower motor not working

check if there is any voltage reading at the fan blower wiring when activated,if there is an it still does not work then you may need a replacement blower...

Posted on Sep 05, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Blower does not work in rear AC 2012 E-150 Van. Suggestions?


check fuse ,if it is good check to see if there is power to the blower if not replace blower motor , if not check for bad relay

Aug 27, 2014 | 2012 Ford E-Series Wagon E-150 XL...

1 Answer

Where is the heater resistor fuse located on 2001 E350 ford van


The heater blower fuse controls power through the resistor, Ford have a habit of fitting the resistor in the air supply tube from the motor, so it is an airflow to help keep it cool.

Jan 05, 2014 | Cars & Trucks

1 Answer

I have a 1994 Ford e350 club wagon van.When i start the vanand turn the heat on it stay on for approx mins then starts blowing cold ar. blower motor, blower motor resistor, thermastat,control switch have...


is your heater core hooked up, on most vehicles there are two hose on the left side under the hood that goes thru the fire wall if they are not there then that,s your problem bad heater core.

Sep 17, 2012 | 2002 Ford E350

1 Answer

2002 ford e350 van. I have no air coming through the rear vents but the blower motor is working great.


Sounds like it could be a blend door problem. Common among dual a/c Fords. Try disconnecting the battery for a few minutes. Sometimes this will reset the blend door actuators. If this doesn't work then the actuator will need to be replaced.

Jul 03, 2011 | 2002 Ford E350

1 Answer

Front blower motor will not work in 1994 f 350 van all fuses are good no power anywhere (at switch, resistor, or blower motor in any position


check the 50 amp fuse in teh engine compartment fuse/realy box. Also check the blower motor relay that the fuse protects.
Alos, check fuse 9, 15 amp in fuse panel in truck.

Test by applying 12 volts to teh orange/red wire at teh blower motor connector. Use a 10 or 12 gauge wire with a 25 or 30 amp fuse in line.

report back

Jan 11, 2011 | 2002 Ford E350

1 Answer

My 2002 ford E 250 econoline van's problem, the blower motor speed when turned to any speed does not work. I have no heat until the motor has been running for an hour or so in the winter. When the blower...


The blower motor resistor is what controls the speeds of the blower motor. It is under the battery tray.. you have to remove it to see the resistor, and there is 1 bolt holding it to the truck, with a (2 wire) plug going to it.

Dec 22, 2010 | 2002 Ford E350

2 Answers

Hi, My blower on my E350 1994 Ford is not working anymore... Where is it? Perhaps I can replace it myself. HELP !!!


i have a 2000 Ford E350 1 ton Van the heat works in front but blows cold air in rear. Would the problem be a blower heater switch and where is it? I hope I don't have to take off the whole dash.

Jan 28, 2010 | 2002 Ford E350

1 Answer

1994 ford e350 cargo van, blower motor not working


check if there is any voltage reading at the fan blower wiring when activated,if there is an it still does not work then you may need a replacement blower...

Sep 04, 2009 | 2002 Ford E350

3 Answers

2003 ford van e350 rear air vent is not blowing


Try this article. I have the same problem and I think it is the vacuum motor that controls the door for changing from hot/cold in the rear heater box (located inside behind the L rear wheel)

https://www.fleet.ford.com/truckbbas/non-html/Q19.PDF

Jul 08, 2009 | 2002 Ford E350

1 Answer

I have a 2000 ford E350 van with front and rear air. the front blower motor runs at low speed, The front blower still runs on low even when the knob is set on medium or high. I do not know where the...


it's either the blower motor switch or blower motor resister. Resistor ?Heater Blower Motor Switch Removal Remove the battery (10655) ; refer to Section 414-01 . Remove the battery tray. Remove the screws. Remove the battery tray. Disconnect the heater blower motor switch resistor connector. Remove the heater blower motor switch resistor (18591). Remove the two screws. Remove the heater blower motor switch resistor. ----------------------------------- Switches Removal Disconnect the battery ground cable. Remove the center trim panel; refer to Section 501-12 . Remove the control assembly. Remove the screws. Remove the control assembly. Remove the A/C-heater function selector switch knob. Disconnect the vacuum harness connector. Disconnect the A/C-heater function selector switch connector. Remove the A/C-heater function selector switch. Remove the screw. Remove the A/C-heater function selector switch. Remove the temperature control switch knob. Disconnect the temperature control switch connector. Remove the temperature control switch. Remove the screw. Remove the temperature control switch. Remove the heater blower motor switch knob. Disconnect the heater blower motor switch connector. Remove the heater blower motor switch (18578). Remove the screw. Remove the heater blower motor switch. ----------------------------

Mar 31, 2009 | 2007 Ford E-350 Super Duty Length XLT

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

133 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5467 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...