Question about 2004 Jeep Grand Cherokee

1 Answer

2004 jeep reset computer

M 2004 jeep wont shift out of first gear i checked the transmission fluid and its good, i notice the battery was going out, would that effect the oem from allowing it to shift?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Prodigy:

    An expert who has answered 500 questions.

  • Jeep Expert
  • 652 Answers

Yes

Posted on Nov 19, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

leetamara
  • 702 Answers

SOURCE: Transmission wont shift into reverse

By the grayish color, fluid being thick, and metal shavings, the clutches are pretty much worn out. It's time to either rebuilding your transmission or just installing a good used one. The fluid normally should be a reddish color. The gray is from the actual clutch material going away.

Posted on Aug 17, 2008

garyq1970
  • 73 Answers

SOURCE: 2001 jeep grand cherokee transmission revving-codes p1757, p1762

P1757 1T CCM 1996-2003 Cherokee, Grand Cherokee A/T Governor Pressure Above 3 PSI In Gear At 0 MPH Conditions: Engine started; vehicle driven to a speed over 30 mph, and the PCM detected the Governor Pressure Sensor was more than 3 psi with the requested pressure at 0 psi (95% duty cycle command) for 2.65 seconds. The fault must occur twice on one trip to set the code. Possible Causes: Check for the presence of other A/T related trouble codes Governor pressure Sensor is damaged or has failed Governor pressure Sensor VREF (5v) circuit is open or shorted Transmission valve body is leaking, damaged or has failed PCM has failed P1762 1T CCM 1996-2003 Cherokee, Grand Cherokee A/T Governor Pressure Sensor Offset Volts Too High/Low Conditions: Key on or engine running. Gear selector in Park or Neutral. PCM detected an out-of-range Governor Pressure Sensor signal for 1.3 seconds. The fault must occur 3 times on one trip to set a code. Possible Causes: Governor pressure Sensor VREF (5v) circuit is open Governor pressure Sensor ground circuit is open P/N switch is damaged or has failed (not operating properly) Transmission fluid has excessive debris or it is contaminated PCM has failed

Posted on Nov 17, 2008

  • 159 Answers

SOURCE: 1995 jeep grand cherokee auto trans prob

sounds like the transmission is in "limp"mode it allows you to drive even though there is a problem with the transmission,the code 21 is probably a transmission manufature control code and not engine go to autozone and they can scan it for free,if you just had transmission fluid changed recently if you used anything other than what the manufature calls for like atf+4 then this is your problem,flush the system and do a fluid and filter change with correct fluid as by what the owners manual,or dealer calls for,don't rely on autozone to get it right.

Posted on Dec 25, 2008

  • 6982 Answers

SOURCE: 02 jeep liberty won't shift into 3rd or 4th gear.

Ratio codes generally indicate a pressure loss & slipping which the computer reads as a gear ratio problem. Likely you need a rebuild.

Posted on Mar 16, 2009

  • 6982 Answers

SOURCE: 2004 Jeep Grandcherokee - Transmission Maintenance

I'm going to guess since you didn't mention which fluid...Transmission?
First find out which unit you have (usually an id tag on it somewhere ) Then look up what kind and how much fluid in your owners manual (usually around four quarts...unit holds more but you can't remove it from the pan) Remove all pan bolts and lower pan. (some units have a drain plug, use it first if you have one ) you will see the filter attached to the valve body. remove it and install the new one, Make sure all gasket material is removed from pan and trans. Clean any metal etc from pan and internal magnet (there is always some in there but should not be a ton of it) Then put pan and gasket back. Make sure you can turn each fastener easily to make sure they are not cross threaded and only tighten them after they are all in there. Bolts do not have to be tightened down like they never should be removed again (snug then a little bit more)tighten in an X pattern not a circle.Replace about half of the fluid with car off, then put in remainder while running. Put your foot on the brake and shift to reverse then drive a few times then check fluid level.Low is bad, a tiny bit (less than half inch) over is OK.
Drive for a short ride, check again for leaks and re-tighten if any are found.
If trans was exceptionally dirty and yours has a drain plug, I recommend that you use a generic oil on the first change, then in a week, drain oil again and re-fill with good brand name stuff. and perhaps a bottle of lucas conditioner.
Good luck!

Posted on May 14, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Want shift into. Hi gean


i take it is a automatic check gearbox transmission fluid or the torque converter may be at fault

Jan 24, 2016 | Cars & Trucks

1 Answer

My jeep wont shift out of passing gear unless i let if the gas


try checking your transmission fluid level , low fluid will cause shifting problems

Jul 31, 2012 | 1996 Jeep Grand Cherokee

1 Answer

Gear shift locks and car will not start


For Automatic transmission problem,click the link below:---- Automatic transmission troubleshooting:----

http://howtobyme.blogspot.com/2011/11/automatic-transmission-will-not-go-into.html

---------
Automatic transmission shift lever issues?-------

http://technoanswers.blogspot.com/2012/01/automatic-transmission-shift-lever-hard.html

-----------
AUTOMATIC TRANSMISSION FLUID LEVEL? --

http://schematicsdiagram.blogspot.com/2011/07/how-to-check-automatic-transmission.html

--------------

AUTOMATIC TRANSMISSION FLUID AND FILTER?

http://schematicsdiagram.blogspot.com/2011/07/how-to-change-automatic-transmission.html

-----------
Transmission fault light on car dash?

http://schematicsdiagram.blogspot.com/2011/12/transmission-fault-light-on-car-dash.html

--------
Transmission shifting problem?

http://schematicsdiagram.blogspot.com/2012/01/transmission-shifting-problem-on-toyota.html

--------
Transmission Slips out of 2nd gear?

http://repairhelpcenter.blogspot.in/2012/02/transmission-slips-out-of-2nd-gear.html

-----------
OD light flashing and transmission fluid leaking?

http://repairhelpcenter.blogspot.in/2012/02/od-light-flashing-and-transmission.html

----------
Why Transmission fluid leaks near radiator?

http://repairhelpcenter.blogspot.in/2012/02/transmission-fluid-leaks-near-radiator.html

----------
Transmission fluid leaking?

http://technoanswers.blogspot.in/2012/02/ford-windstar-transmission-fluid.html

-------------
****** wont go in reverse?

http://technoanswers.blogspot.in/2012/02/dodge-neon-wont-go-in-reverse.html

-------------
Automatic transmission will not go into reverse?

http://technoanswers.blogspot.in/2012/02/dodge-automatic-transmission-will-not.html

----------
Transmission is making buzzing noise?

http://technoanswers.blogspot.in/2012/02/transmission-is-making-buzzing-noise.html

-----------

This will help.

Thanks.

Feb 19, 2012 | 1999 Toyota Camry

1 Answer

Shifting in higher gears


For Automatic transmission problem,Check the list of help links below.click the link below:----Automatic transmission troubleshooting:----

http://howtobyme.blogspot.com/2011/11/automatic-transmission-will-not-go-into.html

---------
Automatic transmission shift lever issues?-------

http://technoanswers.blogspot.com/2012/01/automatic-transmission-shift-lever-hard.html

-----------
AUTOMATIC TRANSMISSION FLUID LEVEL? --

http://schematicsdiagram.blogspot.com/2011/07/how-to-check-automatic-transmission.html

--------------

AUTOMATIC TRANSMISSION FLUID AND FILTER?

http://schematicsdiagram.blogspot.com/2011/07/how-to-change-automatic-transmission.html

-----------
Transmission fault light on car dash?

http://schematicsdiagram.blogspot.com/2011/12/transmission-fault-light-on-car-dash.html

--------
Transmission shifting problem?

http://schematicsdiagram.blogspot.com/2012/01/transmission-shifting-problem-on-toyota.html

--------
Transmission Slips out of 2nd gear?

http://repairhelpcenter.blogspot.in/2012/02/transmission-slips-out-of-2nd-gear.html

-----------
OD light flashing and transmission fluid leaking?

http://repairhelpcenter.blogspot.in/2012/02/od-light-flashing-and-transmission.html

----------
Why Transmission fluid leaks near radiator?

http://repairhelpcenter.blogspot.in/2012/02/transmission-fluid-leaks-near-radiator.html

----------
transmission fluid leaking?

http://technoanswers.blogspot.in/2012/02/ford-windstar-transmission-fluid.html

-------------
****** wont go in reverse?

http://technoanswers.blogspot.in/2012/02/dodge-neon-wont-go-in-reverse.html

-------------
Automatic transmission will not go into reverse?

http://technoanswers.blogspot.in/2012/02/dodge-automatic-transmission-will-not.html

----------
Transmission is making buzzing noise?

http://technoanswers.blogspot.in/2012/02/transmission-is-making-buzzing-noise.html

-----------

This will help.

Thanks.

Feb 09, 2012 | 2000 Isuzu Rodeo

2 Answers

My jeep wont move in any gear


If your transmission is low on fluid it won't move the vehicle. Sounds like you had just enough fluid to get first gear going.

Feb 22, 2010 | 1995 Jeep Grand Cherokee

1 Answer

My 1999 jeep cherokee wont shift into a higher gear ?


IF ALL OF THE POSITIONS ON THE (PRNDL) TRANSMISSION INDICATOR, ON THE DASHBOARD ARE CIRCLED THEN IT MAY BE THE TRANS RANGE SENSOR. THERE MAY BE A RECALL ON THIS VEHICLE TOO, ASK YOUR LOCAL DODGE DEALER ABOUT THIS. BUT FIRST, CHECK THE TRANSMISSION FLUID FOR CORRECT LEVEL AND SEE IF IT SMELLS BURNED. IF IT SMELLS BURNED, THEN HAVE THE TRANSMISSION SERVICED WITH NEW FLUID AND A FILTER. I HOPE THIS HELPS. THANKS FOR USING FIX-YA AND FOR ANY COMMENTS YOU MAY HAVE. PLEASE KEEP ME POSTED. GOOD LUCK

Sep 18, 2009 | 1999 Jeep Cherokee

2 Answers

I have a playmouth grand voyager 1999 3L,my transmission will not shift up in gear.On drive or reverse it goes well but will not shift.I think it could be an electrique problem,cause the transmission looks...


Your trans is stuck in safe mode, you are only using 2nd gear, this means it is not shifting but staying at a gear so you will not damage the trans. This is an electrical setting , however usually comes from the computer receiving bad information , rough shift, however it can be reset. Remove the positive battery cable for 30 minutes then see if it shifts, also check your fluid level, it can go into safe mode from low fluid if you made a turn and the trans slipped from low fluid . If your trans goes back into safe mode again have it checked, most important, do not drive over 45 mph or allow your rpms to raise over 3 , I have seen many motor problems that spawned from this type of trans problem, if not corrected.

Good Luck

Aug 16, 2009 | 1999 Plymouth Grand Voyager

1 Answer

Transmission wont shift until about 4000rpms from 1st to 2nd gea


Have a code check done and see if speed sensor or controller is working properly. if bought from a dealer, get it back there asap...they can't sell it in that condition!!...No test drive before you ploped down your money?

Apr 16, 2009 | 2004 Jeep Grand Cherokee

1 Answer

Transmission wont shift into reverse


By the grayish color, fluid being thick, and metal shavings, the clutches are pretty much worn out. It's time to either rebuilding your transmission or just installing a good used one. The fluid normally should be a reddish color. The gray is from the actual clutch material going away.

Jul 22, 2008 | 2001 Jeep Grand Cherokee

Not finding what you are looking for?
2004 Jeep Grand Cherokee Logo

165 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...