Question about Cars & Trucks
Posted by Anonymous on
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
You have to drain the water out of the fuel tank. There should be instructions on how to do that in your owner's manual. The sensor is in the tank. Hope this helps.
Posted on Dec 29, 2009
SOURCE: RA HOLDEN RODEO, 07 model.
Hi. If your car dies after you turn the key ignition to start and engine will only stays on when you hold down the accelerator then dies if you take out your foot to the accelerator. This is a fuel filter problem. You need to replace that one.
Posted on Sep 25, 2010
I also have a Chevy Captiva 2L Diesel but with the auto box. The MPG on that one is abysmally bad! I bought it a few weeks ago with just under 30K miles on the clock (2007 model), and it returns around 230 miles on a full tank! That's around 17 MPG and probably on par with a Hummer!!
I was expecting the auto box to be less efficient than the manual of course but not to consume twice as much. Anyone out there with any ideas as to why this could be? I was actually already checking under the car to see if it loses fuel... We live in the suburbs and our trips can be considered a mix of urban and extra urban (they are admittedly on the short side and from a cold winter start; still, this doesn't justify the extremely low MPG). The car seems adequately powered for its weight and considering the small'ish engine and auto box.
Posted on Dec 31, 2010
SOURCE: need directions to fit towbar
there is a standard tow bar and a 2000kg for genuine tow bars
you need to remove both tail lights,the bumper bar and reinforcement bracket, spare wheel and exhaust hangars on rear mufflers, remove the tie down bracket on LHS chassis rail(dont need this or the bolts that hold it on), so you can then bolt in place either of the 2 tow bars.
genuine wiring patch harness for trailer plug is my suggestion since its plug straight into vehicle and interfaces with vehicle, goes in right hand rear compartment remove lid then remove box, interface connector for trailer harness is there.
instructions can be printed out from dealers if you ask
some new kits dont come with instructions in kits because information is on dealer computers
there is a template to print out to cut hole in bumper bar for tounge area of tow bar, uses centre square dimple in bar but its a bit wider.
Posted on Sep 07, 2011
Tips for a great answer:
Aug 03, 2017 | Holden Cars & Trucks
Jun 14, 2017 | Holden Cars & Trucks
Jan 19, 2017 | Holden Cars & Trucks
Aug 28, 2016 | Holden Cars & Trucks
Aug 05, 2016 | Holden Cars & Trucks
Jul 23, 2016 | Holden Cars & Trucks
Jun 02, 2016 | Holden Cars & Trucks
Mar 05, 2015 | Holden Cars & Trucks
Dec 14, 2014 | Holden Cars & Trucks
Oct 13, 2011 | Cars & Trucks
May 22, 2018 | Cars & Trucks
255 people viewed this question
Usually answered in minutes!