Question about 2005 Mercedes-Benz Viano 3.2

Open Question

Electric sliding door repair, where to find the door-closed-switch (if any)

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Electric door won't stay closed. It closes and then reopens itself. How to fix?


Check the Door connections.
Tests/Procedures: 1. Access and inspect the right power sliding door contact switch for contamination, alignment and/or damaged terminals of the contact and address it as needed.

2. Check the circuits of the right sliding door contact switch on the door side of the contact for a potential open or short running between the contact switch and detent switch connections and address the circuits as needed.

3. Check the signal of the detent switch with an ohmmeter by measuring resistance between the contact terminals 1 and 3 on the door side of the sliding contact switch. When thedoor handle is operated, the ohmmeter should indicating momentary continuity. The door handle should only need to be moved in 10 degree increments to the value of the detent switch to change.

May 04, 2015 | Ford Windstar Cars & Trucks

1 Answer

Driver side sliding door on 04 freestar van non power wont open after opening and closing the fuel door


There is obviously a switch on the fuel door that prevents the sliding door from operating while the fuel door is open. Look for that switch and spray some electrical cleaner (or even "Brake Kleen" from an auto parts store). Both evaporate quickly without leaving residue. The switch is probably "gunky."

Mar 23, 2015 | 2004 Ford Freestar

1 Answer

Electric sliding passenger door of Toyota Raum won't open when front door is closed either by pulling handle or pushing switch on dashboard.


Although the attached video is for a Toyota Sienna, the basic troubleshooting and repair is somewhat the same...and one-way this d.i.y. chose to tackle the problem himself. I do recommend purchasing or downloading a service repair manual specific to your vehicle for added tech support and will be a helpful resource should other mechanical issues arise.
Toyota Sienna Power Sliding Door Repair

Jun 03, 2014 | 2012 Toyota Prius v

1 Answer

Power sliding door pontiac montana


Check to make sure there is no rocks and or dirt in the track path, spray WD40 or other lube on the rollers and moving parts.
Most of the time these will be the fix, however, the switch could be bad. You may wish to shop around for a more affordable repair shop! There mite be two electrical contacts on the door and pillar, will look like two metal buttons, clean all these contacts.
Good luck!

Oct 21, 2013 | Cars & Trucks

1 Answer

Side door won't open with electric switch


Check the fuse, if it's blown, replace it. Check the switch as well. If this was at all helpful, please rate. Thanks for asking.

Jun 30, 2010 | 2005 Dodge Caravan

1 Answer

Car Electrics


Very complicated discription , hard to understand if you are not a mechanic.
But anyway , sounds like a bad door switch , I don't remember if it's separate switch or it is part of a door lock. Most likely part of a door lock.
Start from checking door wire harness(broken wire) between door and the body (door opens and closes , harness bends back and forht).
If it's ok , check door locks.
The light doesn't go off because it doesn't see door closed , same reason for glass , won't close up.

May 26, 2010 | 1996 BMW 318

1 Answer

2001 Toyota Sienna r.h. sliding door ''rear latch switch'' location


To start, the noun "''rear latch switch'' is incorrect. It's actually called "Slide Door Lock". It's located on page BO-20 of the Toyota Repair Manual for the 2001 Sienna. There are two door locks on one sliding door. One in the front and one in the rear. Obviously, you want the one in the rear. The location for the "Slide Door Lock" (which also contains an electric switch) is in the rear of the sliding door located mid way up door. You can see (sliding door opened from the back) it without dissembling the door. And, the lock is made up of plastic (dirty white in color).

Mar 06, 2010 | 2001 Toyota Sienna

2 Answers

I hit passenger sliding door on garage door while


the door is out of adjustment. you could also have something bent. those are very heavy doors and I would recommend to take it to a honda dealer only for repairs. I helped a gentleman in your exact same situation and it took a 20 year tech all day to get it right.

Feb 05, 2010 | 2005 Honda Odyssey

1 Answer

My 2000 Honda Odyssey minivan's automatic sliding door on the driver side has stopped working. The passenger side works fine. The fuse is good. I tried a reset process posted online involving removing the...


I had a 2002 Odyssey with the same problem. I cleaned around the micro switch at the bottom rear of the door and checked the door roller bracket screws. The screws were loose so I tightened them and also sprayed the switch with electrical contact cleaner (special stuff that leaves no residue). Apparently this helped the contacts in the switch to close properly and the door was able to reset and work. Good luck.

Dec 27, 2008 | 2002 Honda Odyssey

Not finding what you are looking for?
2005 Mercedes-Benz Viano 3.2 Logo

Related Topics:

317 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75005 Answers

Michael Contreras
Michael Contreras

Level 2 Expert

166 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...