Question about 2002 Kia Rio

1 Answer

2000 kia spectra has intermittant clunk under drivers side floor board

Posted by on

Ad

1 Answer

Check exhaust system
Heat Shield on Converter

Posted on Aug 01, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 15 Answers

SOURCE: 2006 kia spectra intermitent popping noise

a bering in the disck is gone

Posted on Jan 27, 2009

  • 12 Answers

SOURCE: floor behind driver seat is wet.

For sure there's a leak somewhere.
check if there's no damage or defects in the door rubbers, check if you can find another wet areas to help you find the leak.
There's a few holes in the floor covered with plastic caps, check if there some missing and if they're not damaged.

Posted on May 02, 2009

  • 2 Answers

SOURCE: disable drivers side airbag

may 2007 there was a recall for undeployed air bags and tensioners also recalled forclockspring installation and in april 2002 air bag-after Deployment Inspection/Replacement. found all this inf on alldatadity.com

Posted on May 12, 2009

  • 4102 Answers

SOURCE: 2000 Kia timing belt specs

this should be the info your looking for.

remove timing cover, on the left cam sprocket(closer to inside of vehicle) you will see the letter (I)for intake and a notch above it on the valve cover align those marks.Next on the right cam sprocket you will see the letter (E) for exhaust and a notch above it on the valve cover align those marks.Last you have a notch on your crank sprocket, align that notch with the arrow just above it.Align all marks then turn belt to revolutions and see if marks are stilled aligned if not try again until you get it right.If so put everything back together and "happy driving!"

Let me know if you need further assistance ok

Posted on Aug 18, 2009

turboKia
  • 55 Answers

SOURCE: How do you replace a Drivers side headlight bulb 2006 kia spectra

Helps to remove the battery, but small ahbds can do it.

Directly behind the lens is a big round cap ... twist it off. The bulb is held in place with a spring that locks in to a notch in the holder. When handling the new bulb, don't touch the glass. The oil from your skin will cause it to shatter when turned on.

Posted on Oct 23, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Clutch just replaced on 2009 Kia spectra clunk now when taking off first gear


check that the cable is still properly attached to the pedal

Sep 02, 2016 | 2009 Kia Spectra

1 Answer

How do I install the alternator on a 2003 KIA Spectra?


I just replaced the alternator on my 2003 Kia Spectra, not an easy job. It has to be removed from under the vehicle. First, after disconnecting the battery, remove the "locking" bolt on the topside of the alternator, along with the adjusting bolt (both metric 12mm). This is done from the topside, (rear, right side of the engine compartment). From under the vehicle, loosen the bolt that holds the alternator. At this point you have to decide whether to loosen the exhaust manifold or motor mount. I choose the motor mount. I loosened the mount and used a floor jack to raise the engine, only needed about an inch. Good luck.

Oct 10, 2014 | 2003 Kia Spectra

1 Answer

Clunking under driver floor board


Your Sequoia is a 4 x 4, right? Check your front drive shaft. It is probably the u-joint is fried and needs rebuilt.

Mar 28, 2014 | Toyota Sequoia Cars & Trucks

1 Answer

It's a 02 Kia spectra GS the heater is not working


CHECK THE ACTUATOR UNDER PASSENGER SIDE FLOOR BOARD IN DASH THE CABLE COMES OFF FOR TEMP BLEND DOOR I WOULD CHECK THAT IF YOUR COOLANT LEVEL IS FULL SNF YOU HAVE NO LEAKS

Jan 16, 2011 | 2002 Kia Spectra

1 Answer

Where is the blower motor resistor on the kia spectra 2005


On the passenger side, up under the dash. I removed the glove box but not so sure that was necessary but better to do and not have to then to struggle unnecessary. The blower is above where a passengers right foot is and there is a black air chamber close to the fire wall. The resister is screwed into this about where the passenger's left foot would be. It is difficult to see because there is a small black piece of molded plastic hanging down to protect that no one accidentally kicks it hanging in front of it from your line of vision. A short stubby screwdriver is good for this as a long handled driver may **** up against the floor board and not give you the right angle to take the screws out.

Nov 13, 2010 | 2005 Kia Spectra

1 Answer

How do you install a driver seat in 2003 kia spectra?


just undo the bolts, the nuts are captive which means they are welded into the floor.

Apr 06, 2009 | 2003 Kia Spectra

1 Answer

Kia spectra starter


It is attached to the bell housing on the drivers side. The starter is located in the back of the engine, under the intake manifold.

Jul 15, 2008 | 2002 Kia Spectra

Not finding what you are looking for?
2002 Kia Rio Logo

Related Topics:

43 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

76109 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8270 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...