Question about 1988 Mazda B2200

1 Answer

Wont start..no spark computer problem? - 1988 Mazda B2200

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Mazda Master
  • 14,036 Answers

Many things will cause no spark bad distributor cap or rotor.bad plug wires.ignition timing to far advanced cause by loose distributor.could have faulty ignition coil or module.check ignition fuse.probably could be faulty PCM i would have it checked out.could have bad crankshaft sensor.

Posted on Aug 01, 2013

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

If my chevy tracker 2004 cranks good but wont start , which relay do you think I need to change.. is it the crank relay? or fuel pump relay?


I don't know what kind of damage you may have done? Can you communicate with computer, check applicable trouble codes, anything? If you can't communicate with computer, start, there.
You can check the basics, if you haven't already. With engine cranking check for spark at the spark plugs. If spark everywhere, use a gage and check proper fuel pressure.

Dec 01, 2016 | Cars & Trucks

1 Answer

We bought a 03 chevy venture have had it two weeks an it wont start......we put new fuel pump in it. Drove it around it was fine went to store it wont start....i am wheelchair bound could use help


There are numerous reasons for a vehicle not to start. You need to determine if the engine is getting fuel and spark. If one or the other is not present, there will be a no start. Remove a spark plug wire and ground it to the engine. Crank engine over and you should see a spark coming from the boot to the engine. If no spark present, possible crank sensor/ignition module/wiring/computer problem. If spark present, suspect fuel delivery problem. Fuel pump/relay/injector problem/wiring/computer. There can be a considerable amount of diagnostics needed to isolate the problem and correct it.

Feb 22, 2016 | Cars & Trucks

1 Answer

How do I reset computer


you need to find overheat cause
and then see if there was damage from that.
the ECU does NOT need a reset
but if h3LL bent.
you can 3 ways, like all cars. modern.
1: push reset on the scan tool button.
2: pull the ecu memory fuse for 5min.
3; PULL BATTERY NEG LUG AND BRICKs the NAV AND RADIO.

Your call.

#2 elaborated
IG-COIL fuse 20
DOme fuse 37 both in junction box. same names
rests PCM and immoblizer if opted

01591701-3527-4726-9235-28403a2972c4.jpg

Sep 11, 2015 | 2007 Suzuki SX4

1 Answer

91 pulsar n13 has spark has fuel wont start


If spark and fuel ok, the only other thing needed will be compression. Make sure the timing belt has not broken or jumped

May 17, 2015 | Nissan Pulsar Cars & Trucks

1 Answer

My 1997 dodge dakota v6 3.9 auto 4x4 wont start replaced the ecu computer it will crank but wont start


Check for spark, and for fuel at the manifold. The ECU will not prevent you from cranking, but it does control fuel and spark.

Jan 10, 2015 | Dodge Cars & Trucks

1 Answer

How to fix a1998 buick century to start fuel filter new and airfilter turning over but not starting gets gas


Did you check for spark? It sounds like you're not getting spark. Check for spark. If you are not getting spark then it sounds like you might have to replace the coil packs. Is it running a L4 engine? If its running a standard chevy L4 its probably the coil packs. Try to replace them check again for spark.

May 25, 2012 | 1998 Buick Century

1 Answer

Dakota wont start


your pickup coil could be the problem. not geting enough spark or sparking all the time

Apr 09, 2010 | 1996 Dodge Dakota

1 Answer

Car turns over great getting fuel and spark but wont start


Spark without fuel = just spark. :) Are you getting fuel movement? You could have a bad/clogged fuel filter, bad fuel pump - could be a few things. Check to make sure you're getting fuel.

-KC GTO Dad

Sep 16, 2009 | 1994 Honda Accord

1 Answer

My V8 eb has spark but wont start


make people you loaned car to pay for check coil!!!

Jun 25, 2009 | 1983 Ford Fairmont

1 Answer

97 blazer cranks but wont start,when does start runs great


Your next step in diagnosis your problem should be to check for spark, you'll have to use a spark tester for this, simply removing a spark plug and looking at it WILL NOT WORK, a spark tester looks similar to a spark plug but it has about a 3/4" gap.

Another thing you should check is the voltage of the battery with a multimeter while cranking the engine, if it drops below 9.6v your computer will turn off and your injectors wont fire and neither will your plugs.
If you don't have a multimeter just try jump starting the vehicle.

Hope this helps

Feb 22, 2009 | 1997 Chevrolet Blazer

Not finding what you are looking for?
Cars & Trucks Logo

127 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...