Question about Cars & Trucks

1 Answer

How do you reset the fuel pump relay after putting in new fuel pump

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 10 Answers

I'm having the same "reset" problem, after replacing the gas filter. Think the battery needs to be disconnected then reconnected, but I can't find the answer anywhere yet. Will call dealer later.

Posted on Aug 29, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 3 Answers

SOURCE: My car is cranking but

1985 buick somerset regal with 4 cyl. feul pump relay is mounted near back of passenger side strut tower top. if you are in front of vehicle it should be the right hand relay of the two.

Posted on Sep 21, 2008

unsivilaudio
  • 25 Answers

SOURCE: Fuel pump will not run, 96 Neon 2.0 SOHC

Personally I wouldnt bother tracing the wire as it is probably not worth your time, and just run a constant 12v from the battery to the relay on like 10ga wire. There is probably a short somewhere in the system which can be a real headache to find.

Also it may sound dumb, but check your fuses, and the fusible links under the hood. Chances are that they are all fine though, especially if you have dash lights.

Posted on Dec 30, 2008

lsteward68
  • 331 Answers

SOURCE: i can get power th the fuel pump when i run a hard wire from the battery to the relay but when i put the relay back in no power to the fuel pump

I have a question. Turn the ignition on you should hear the pump for about 3 seconds. then it should stop. this is normal operation. then when a signal is sent to the ignition that you are going to crank it then it switches on. I can see how this can seem like the pump is not working but after you crank it you should be able to hear the pump for about 1-1.5 seconds after the crank then it will stop. The pump will not turn on until it is told to do so by the computer.

Posted on May 25, 2009

  • 20 Answers

SOURCE: 92 chevy astro van fuel pump and relay

Injectors or Carb? is there fuel presurt to the line near the engine and what is the presure.
The mechanoc was it a shop or buddy at home? Can you hear the fuel pump run when the key is turned on?

Posted on Jun 02, 2009

canbruce75
  • 1776 Answers

SOURCE: how to install fuel pump in chevy 2003 astro van

Go to the autozone website at autozone.com and register your vehicle. It's free and will give you access to an online repair manual for your vehicle. The procedures for changing the fuel pump should be available there. Sure hope this helped and best wishes.

Posted on Aug 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

91 dodge dakota


ford is the only one with a reset button, possibly check the fuse and relay for the fuel pump

Apr 27, 2013 | 1991 Dodge Dakota

1 Answer

Put a new fuel pump in a 2001 blazer. 4.3 vortec. truck will start but idles rough and then stalls. changed fuel filter, cap and rotor, plugs and wires and it made no difference. put it on a scanner and no...


Have you checked the fuel pump relay? I've had to replace the fuel pump in mine a few times now but the relay was one of the problems I had and it was a whole lot cheaper than the fuel pump.

Feb 24, 2013 | 2001 Chevrolet Blazer

1 Answer

Replaced Cam and crank sensors and computer. Now no fuel to the rail. OBT computer says there is no problem. Is there a reset for the relay


You don't give the year make and model, so I will answer this in general terms.
There should be a fuel pump relay that powers the pump. The relay is grounded by the computer for 3 seconds when you turn the key on.
You would need to check that relay for power and ground if the pump does not run.

Dec 19, 2012 | Cars & Trucks

2 Answers

I have a 2006 ford f350 and the fuel pump isnt working is there a shutoff switch


Yes. The switch is usually located around the passengers kickpanel. There should be an access hole to press the button on the switch. Sometimes the part is just above the carpet and sometimes you have to remove the kickpanel. If you are unable to find this switch on the passengers side,then look on the drivers side kickpanel.

Under the hood is a Powerbox. The shutoff switch (inertia switch) gets its power from the Fuel pump Relay after the Ignition is turned on. If resetting the shutoff switch does not help, your fuel pump Relay may be bad. On some Ford models, the horn Relay is the same Relay used for the fuel pump. This would allow you to swap and test before buying a new Relay.

Jul 13, 2011 | 2006 Ford F 350 Super Duty

1 Answer

Same thing


If there is no power to the fuel pump check the relay ( fuel pump relay ) under the hood next to the AC relay they are interchangable.

Aug 27, 2009 | 1997 Cadillac Catera

2 Answers

New fuel pump and still wont start


your fuse maybe blown or your fuel relay may be bad,

Aug 26, 2009 | 2002 Mercury Cougar

1 Answer

Fuel pump continousley runs even when the car is turned off


try disconecting the power from the vehicle all together this should reset it. some vehicles actually have a fule bump switch on them (normally in the trunk)

Jun 20, 2009 | 1984 Ford Crown Victoria

2 Answers

Installed new fuel pump on 1995 gmc sonoma, still won't crank. Will turn over but not crank. Put on new alternator also.


Check the fuel pump relay.
Check the fuel pump auto shutoff switch, push RED reset button.

Apr 09, 2009 | 1995 GMC Sonoma

1 Answer

No power to fuel pump


What you need to do is drop the fuel tank and put a new fuel pump in it. I would drain the gas and put new gas in after you get the pump changed.

Mar 25, 2009 | 1995 Plymouth Grand Voyager

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...