Question about 2001 Chevrolet Tracker
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
I don't know if your vehicle is a 4 cylinder or 6 cylinder. This will make a difference in the # of cylinders as well as the placement. If it is the 4 c ylinder when you open the hood it says at Autozone.com that the spark plugs are on the front of the motor lined up 1-4. If it is the 6 cylinder then you will have 3 at the front of the motor and 3 at the back of the motor. Regardless it is the same concept. I don't know for this particular vehicle, but it is possible you may have to remove a large plastic engine covering in order to access the spark plugs. What I recommend is to replace the spark plug wires at the same time as the plugs. For all my vehicles I use NGK plugs and NAPA auto parts has the best plug wires I have used - Belden Maxx. Prior to starting you will want to check the "GAP" on each new spark plug. Using a spark plug gap tool available at parts places for about $1. Take the new plug and the non-porcelin end (the end that has the arc) insert the arc into the gap tool at the lowest end and slide the plug around until you reach the corresponding "GAP". For this vehicle it should be .44" (I checked on Autozone's website but you may want to check to be sure. At some of the part's places they may tell you that you don't have to check the gap, but believe me you alway's should. I just did a car where they insisted that I didn't need to check the gap and each plug was not gapped properly. The Arc on the plug has to be specific for your vehicle or you will have too much spark or not enough. After gapping the new plugs you are ready to start. Somewhere on the side of the motor you should see either 4 or 6 wires/cables branching out to the cylinders. Starting with whichever you prefer (do only one at a time to avoid confusion) trace the wire/cable to the cylinder and where it goes to the cylinder a "boot" covers the spark plug. Twist the boot until it comes off . If you are going to replace the plug wires take that one off and match it up to your new set (They will be different lengths). You will need a ratchet and a spark plug socket (available at parts places) The spark plug socket has rubber on the inside to protect the porcelin of the spark plug, and to provide grip. You may or may not need a small extension. Place the spark plug socket over the end of the spark plug and apply pressure until the spark plug begins to loosen. You may have to apply quite a bit of pressure if they are in there tight. Once it is loosened take the old plug out, and place the new plug in the spark plug socket. Don't use the ratchet at this point, just begin to thread the plug in by hand once it is in there as much as you can get it, tighten it down with the ratchet making sure not to over-tighten. Do the other cylinders in the same manner.
Posted on Mar 04, 2009
You need to follow the ac lines from the ac compressor to the ac condensor to the fire wall behind the engine where it goes to the heater box.There are two connections,both at differant locations,a low side that has a screw on red or blue cap with the letter L on it and a high side with a cap that has the letter H on it.The refridgerant goes into the low side.Hope this helps.
Posted on Mar 10, 2009
SOURCE: the clutch on a 2001 chevy tracker ac unit when you turn the ac on it squeals like a bastard...any fix to it? without buying a new clutch at a cost of $976 or ac compressor for $868??? other than the
HI, you can replace the bearings on this clutch and it will save you lots of money. the bearing are shot and dry.
Posted on May 21, 2009
yr gonna have to get the passlock key and punch it into the radio so u can solve ur problem most chevy dealships can assist you with that.
Posted on Jun 18, 2009
Tips for a great answer:
Jan 15, 2015 | 2003 Chevrolet Impala
Apr 10, 2010 | 1999 Chevrolet Tracker
Sep 26, 2009 | 2001 Chevrolet Tracker
Sep 14, 2009 | 2001 Chevrolet Tracker
Jun 15, 2009 | 2003 Chevrolet Tracker
Apr 04, 2009 | 1994 Geo Tracker
Mar 10, 2009 | 2003 Chevrolet Impala
34 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: