Question about Cars & Trucks

Open Question

My fuel cap wont open on my pt cruiser? - Cars & Trucks

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 401 Answers

SOURCE: 2001 pt cruiser fueling

Sounds as if your vapor recovery system is plugged, although you should have a trouble code if you have this problem. Go to an Autozone and have them pull your codes for you.

Posted on Mar 22, 2009

  • 290 Answers

SOURCE: chrysler pt cruiser fuel filter location?

Under vehicle, center, below seating area, mounted on top of fuel tank, in fuel pump module

Posted on Mar 27, 2009

  • 412 Answers

SOURCE: 2002 PT Cruiser fuel pump and filter

FUEL PUMP IS LOCATED IN FUEL TANK..FILTER IS LOCATED ON TOP OF PUMP MODULE..A NEW PUMP WILL NORMALLY COME WITH THIS FILTER..YOU MUST REMOVE FUEL TANK FROM VEHICLE TO REPLACE THESE COMPONENTS..IF YOUR NOT SURE YOU CAN DO THIS,I WOULD TALK TO A REPAIR SHOP..FUEL CAN BE VERY DANGEROUS

Posted on Jun 23, 2009

  • 534 Answers

SOURCE: my 2001 pt cruiser gurgles when I stop. Have

Ensure coolant system has been properly filled.
Carry out all air bleed operations as specified by the manufacturer- (don't forget to open the heater core supply valve).

Posted on Nov 19, 2009

  • 2 Answers

SOURCE: Ongoing P0441 purge code on 2003 PT Cruiser GT. I

if you have replace the purge solenoid the problem is either the vaccum supply hose is loosing vaccum or the purge side is hose is either blocked or cracked.

Posted on Apr 21, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Pt cruiser shut off and will not start again. what causes this?


if you remove the oil cap you cam see your camshaft(s) on many vehicles. so remove the oil cap and have someone "bump" the ignition over a few times while you look at the camshaft(s) below the oil cap to see if they are turning. if not your pt jumped time. other possibilities if the cams turn are fuel pump fuel filter coil pack went out relay problems but i would start with the first one i mentioned cause pt's are notorious for that.

May 22, 2011 | 2002 Chrysler PT Cruiser

1 Answer

What is involved in a 90000 service for a 2002 PT cruiser


Usually replace spark plugs some require distributor cap and rotor and wires oil and filter transmission service timing belt replace air and fuel filters change coolant and brake fluid and a cabin filter if required in your car

Mar 11, 2011 | 2002 Chrysler PT Cruiser

1 Answer

My 2001 pt cruiser gurgles when I stop. Have


Ensure coolant system has been properly filled.
Carry out all air bleed operations as specified by the manufacturer- (don't forget to open the heater core supply valve).

Nov 18, 2009 | 2001 Chrysler PT Cruiser

2 Answers

I have pt cruiser showing mulfunction cersor light


brand and octain dont matter if your cap isnt on tight it will come on or if you have replaced the cap some times it will come on it will just take a few times of driving it for it to shut off some where around 300 to500 miles

Oct 08, 2009 | 2005 Chrysler PT Cruiser

2 Answers

2005 Pt Cruiser idles rough at stop lights/ poor gas mileage.


i hav a 2003 pt cruiser 2.2 crd touring it wont go over 3000 revs engine light cums on. error code p0243 i hav replaced wastegate solenoids cleaned egr valve cud it be the mass air flow sensor that has a problem thanx

Sep 18, 2009 | 2005 Chrysler PT Cruiser

1 Answer

2006 pt cruiser, check engine light came on. Shortly after, gas cap light. Replaced gas cap and reset. Today bith lights came on again.


are you fueling car with key "on"? That will cause light to come on. Disconnect battery for 1 hour and this will reset "keep alive memory" and clear codes from memory. Drive car for 10 miles so computer can relearn engine parameters. It may run rough during this period.

Jun 03, 2009 | 2006 Chrysler PT Cruiser

1 Answer

2001 pt cruiser no heat


did you check the fluid level by removing the rad. cap? Radiator should be full to top. If Chryslers are low on coolant, the heater will not blow warm air.

Jan 04, 2009 | 2001 Chrysler PT Cruiser

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...