Question about 2004 Ford Ranger

Open Question

The gas throttle sticking on 2004 ford ranger

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

localwonder
  • 6784 Answers

SOURCE: 2004 ford ranger edge 3.0L spark plug wire diagram

The diagram you seek is below.


374d96b.jpg

Posted on Jul 26, 2009

  • 4088 Answers

SOURCE: 2004 ford ranger 4.0 litre. motor is missing and burning gas

You should be showing the check engine light. Rent a scanner, read out any code(s) and pursue to repair(s).

Posted on Sep 09, 2009

saailer
  • 1868 Answers

SOURCE: 2004 Ford Ranger EVAP system

Hello! You have a vacuum leak in the vapor canister system...See diagram below...Check vacuum lines for cracks, breaks or loose connections...Pay particular attention to the connections on the purge valve which is located near the gas tank...If vacuum lines check out OK...I would suspect a faulty Evap Canister Purge Valve that is not closing...See picture below...







saailer_114.gif

saailer_174.jpgMOTORCRAFT Part # CX2127 Cost=$65

GURU.................Saailer

Posted on Sep 07, 2011

junkman1249
  • 552 Answers

SOURCE: 1988 FORD RANGER NO START

fuel pump

Posted on Dec 06, 2011

SOURCE: where is the throttle position sensor on a 2004 ford ranger

Give yourself some credit

{Throttle Position} where is the throttle ?

It is on the throttle body of all vehicles

You will need a T20 Torx bit to remove --as well
as a hair dryer to soften the thread locker

Keep in mind that NO CODES TELL YOU WHAT
IS WRONG OR WHAT TO REPLACE --only
component testing does

Posted on Dec 15, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 ranger auto transmission sticks in gear when stopping


A bad torque converter can cause this condition.

May 14, 2014 | 2004 Ford Ranger

1 Answer

Diagram distributor


Wide open as in wide open throttle?? You mean the engine is racing? Something is wrong with the throttle controls, or the throttle valve in the carburetor may be sticking open. Look down the carb throat. At its base will be the throttle valves-"butterfly" valves just like the choke valve on top of carb. The throttle valve should be closed at rest, or at idle, or when gas pedal is not moved. Rotate the throttle lever on the carburetor by hand (when gas pedal is pressed down, the throttle is rotated). The throttle valve at the bottom of the carb should open and close with the throttle lever.
If the valve is sticking, spray some carburetor cleaner down it, and spray the outside clean, too. Work the throttle back and forth to make sure it is free to move.
For a high idle, have the carburetor adjusted. Timing should be checked, too-that can cause a high idle, but wouldn't cause it to go wide open.
Let us know what you find. Good luck.

Dec 07, 2013 | Ford Ranger Cars & Trucks

2 Answers

04 ranger rough idle and gas cap and check engine light on.


check vacuum and then spark plugs and wires

Feb 19, 2013 | 2004 Ford Ranger

1 Answer

Where is the throttle position sensor on a 2004 ford ranger


Give yourself some credit

{Throttle Position} where is the throttle ?

It is on the throttle body of all vehicles

You will need a T20 Torx bit to remove --as well
as a hair dryer to soften the thread locker

Keep in mind that NO CODES TELL YOU WHAT
IS WRONG OR WHAT TO REPLACE --only
component testing does

Dec 15, 2012 | 2004 Ford Ranger

1 Answer

1983 ford ranger 6 cylinder- my idle sticks all the time, i constantly have to tap my gas pedal to bring the rpms down.


If tapping the pedal brings the idle down then try spraying the ends of the throttle cable with a lubricant like WD-40 or something similar and work the cable back and forth as you do it. It's likely getting stiff from time and useage. Don't be shy with it. Hope this helps.

Mar 27, 2011 | 1983 Ford Ranger

1 Answer

2004 ford ranger 4.0 litre. motor is missing and burning gas


You should be showing the check engine light. Rent a scanner, read out any code(s) and pursue to repair(s).

Sep 09, 2009 | 2004 Ford Ranger

1 Answer

1997 ford ranger. the gas pedal is stuck and


check throttle linkage maybe the spring is broken

Aug 30, 2009 | 1996 Ford Explorer

1 Answer

1987 ford ranger idled too high


Try lubricating the throttle body cable , sounds like it is sticking.

Jul 26, 2009 | 1987 Ford Ranger

Not finding what you are looking for?
2004 Ford Ranger Logo

Related Topics:

162 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5471 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...