Need to remove glove box 1989 S10 - 1996 Chevrolet S-10 Pickup

SOURCE: locating ECM,91 Chevy S10

Usually just remove glovebox...take care with plug and chip pins they easily bend!

SOURCE: remove heater core

on 1992 s10 remove the heater outlets and duck from under instrument panel. Remove air distribution model assembly,heater and seal. Disconnect neg batt cable. Drain eng coolant. Remove hoses at core. Remove rear case screws. Remove heater core from case.

SOURCE: vent door stuck and can't remove glove box

why can't you remove the glove box? You can get at the door from under the dash but it's a ***** to do. try lubing the vent cables unless it uses the vacuum motor, if it uses the vac. motor it will be hard to get to without the glove box being out.

Testimonial: "Thanks! I just don't know how to remove the glovebox."

SOURCE: How to replace glove box Chevrolet 1996 S-10 Pickup

there is a hinge at the bottom. depress the sides of the box at the top nearest to the dash. put the new one on, thats it!

SOURCE: remove golve compartment on 1999 chevy malibu

There's only so many screws that hold the glove box in. Some are inside the glove box and some are underneath. You may need a torx wrench depending on the type of screws holding the glove box in.