Question about Cars & Trucks

1 Answer

2002 seat leon 1.4 The engine warning light

2002 seat leon 1.4 The engine warning light flashes for a few seconds and will stop and then come back. Along with this there is a small rattle from the engine that comes and goes. similar to the sound of a bottom end bering but not as loud or frequent.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Cars & Trucks Master
  • 1,013 Answers

I bet you have a bad spark plug or ignition coil (or distributor wire). It sounds like a cylinder is misfiring, causing the error message, then when it fires up again the code is cleared and the message goes away.

Posted on Jul 31, 2013

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 54 Answers

SOURCE: renault espace race 2.2cdi year 01

sounds lke the egr valve. may not happen again but probably better to get a diagnostic check done anyway.

Posted on Aug 22, 2008

  • 350 Answers

SOURCE: renualt espace race 2001 2.2cdi

hi sally go to get the fault code read as the ecu will store it it will tell you where to look and just get back in touch if you need more information as for the guest with undocumented codes there is a web site key into goggle engine codes and follow the trail best of luck paul

Posted on Oct 14, 2008

  • 1 Answer

SOURCE: dasboard lights flash and warning beep operates (Seat Leon 2001)

flashing dashboard lights when the ignition is turned off

Posted on Jan 20, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2002 seat leon, engine died while driving ? :o(


Do a compression test. Your engine may need an overhaul.

Jul 20, 2014 | 2000 Seat Leon

2 Answers

In my 2006 ford fusion 2.3L whenever I put my key in the ignition and turn it a weird solid ringing sound start and stops 5 seconds later hat could it be?


Not surprisingly, many others have experienced problems with the ignition switch on this car. Historically, it is not a sound, but that the key is stuck in the ignition. http://repairpal.com/key-will-not-come-out-of-ignition-570 Your problem sounds different, but it may be related. Although I do not recommend the fix in the link above, it is possible the previous owner of your car did perform this fix and it has resulted in the problem you now have. My better guess is that the chime/buzzer has failed due to moisture or dirt and is no longer producing the sound that it should, but instead is altered to the ringing you describe.To disable follow these instructions:

1. Turn the ignition switch to the RUN (or ON) position. (DO NOT
START THE ENGINE)
2. Wait until the safety belt warning light turns off. (Approximately 1
minute)
Step 3 must be completed within 50 seconds after the safety belt
warning light turns off.
3. For the seating position being disabled, at a moderate speed, buckle
then unbuckle the safety belt 9 times, ending in the unbuckled state.
(Step 3 must be completed within 50 seconds after the safety belt
warning light turns off.)
After Step 3, the safety belt warning light will be turned on for three
seconds.
4. Within 10 seconds of the light turning on, at a moderate speed, buckle
then unbuckle the safety belt.
This will disable the BeltMinder feature for that seating position if it
is currently enabled. As confirmation, the safety belt warning light will
flash 4 times per second for 3 seconds.
This will enable the BeltMinder feature for that seating position if it
is currently disabled. As confirmation, the safety belt warning light will
flash 4 times per second for 3 seconds, followed by 3 seconds with the
light off, then followed by the safety belt warning light flashing 4 times
per second for 3 seconds again.
I hope this helps. Good luck.

Jun 12, 2014 | 2006 Ford Fusion

1 Answer

Where is the fuel filter location on a seat leon s 1.4 litre petrol


The light is not due to any clogged filter issue, you have an engine fault in one of the sensors most likely.

Mar 21, 2014 | 2000 Seat Leon

2 Answers

Why does my seat leon fr flash 20mph and bleep when driving over 20mph


U HAVE ACTIVATED SPEED WARNING!!USE MANUAL TO DEACTIVATE!!

Dec 21, 2013 | 2006 Seat Leon 2.0

1 Answer

Seat leon cupra r oil warning light


Before you run aengine anymore remove the oil light switch and check it with a gauge in the oil light switch is faulty ,what engine is this a diesel or a petrol

May 20, 2013 | Cars & Trucks

2 Answers

Dasboard lights flash and warning beep operates (Seat Leon 2001)


flashing dashboard lights when the ignition is turned off

Dec 01, 2009 | 2001 Volkswagen Golf

1 Answer

Audible seatbelt warning keeps on sounding on my 2005 f150 ford truck


From the F-150 Forums, since I just bought one and this worked!

This is straight from my 2009 f150 owners guide

Preperation
1. the parking brake is set
2. truck in park
3. ignition switch is in off position
4. both seat belts are unbuckled

Disable Belt-Minder
1. turn the ignition switch to the on position, DO NOT START THE ENGINE.
2. wait until the safety belt warning light turns off. (approximately 1 minute).
* step 3 must be completed within 50 secs after the safety belt warning light turns off.
3. buckle then unbuckle the seat belt nine times, ending in the seat belt unbuckled.
* after step 3 the restraint warning light, (airbag light) will turn on for three (3) seconds.
4. within approximately seven (7) seconds of the light turning off, buckle then unbuckle the safety belt.
* the restraint system warning light will flash four, (4) times per second for 3 seconds for confirmation

you can do this for the passenger side also!!!


*NOTE
in step 3. after three times buckling and unbuckling the restraint warning light lit up in my truck. SO I WENT TO THE NEXT STEP, (STEP 4). waited 3 seconds and i buckled and unbuckled.

in the buckle /unbuckle procedure do it some what slowly and watch for the light. it may not take 9 times.
__________________

May 08, 2009 | 2005 Ford F-150

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

259 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...