Question about Isuzu Rodeo

1 Answer

Gas gauge on 98 rodeo

My gas gauge moves up and down on my 98 rodeo

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Isuzu Master
  • 4,514 Answers

Carry some gas with u til u fix the sending unit

Posted on Jul 31, 2013

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

mcgyver468
  • 710 Answers

SOURCE: Speedometer and gas gauge are giving false readings!

IT SURE SOUND TO ME LIKE YOU ARE MISSING A GROUND TO THESE GAUGES. THIS WILL BE TOUGH TO LOCATE WITHOUT A SCHEMATIC DRAWING TO HELP YOU. YOU MAY BE ABLE TO LOOK UNDER THE DASH FOR A LOOSE WIRE. YOU CAN ALSO CHECK THE FUSE PANEL FOR THE FUSE MARKED GAUGES TO SEE IF IT IS MAKING GOOD CONTACT. HOPE THIS HELPS. BEST OF LUCK. LET ME KNOW PLEASE. THANKS FOR USING FIX-YA!!!!!!!!!!!!

Posted on May 05, 2009

  • 1 Answer

SOURCE: 2001 Rodeo giving false fuel gauge readings

my 2000 rodeo had same problem . i finally found a bad electrical connection in plug inside the lower left kick panel. the plug connection was not staying fully inserted into the other half of the connector the wire and crimped connector would completley come out of the molded plastic plug that had multiple wires inserted in it . i had to route around to the mating wire on the other half of the connector and connected with a sta-kon connector . there are many connections in this circuit you may have to check all of them. the fuel pump / sending unit did not fix my problem so i went checking connections .this was a fault from who ever made the wiring harness
GOOD LUCK AND MAY GOD BLESS YOU !!!!

Posted on Jul 16, 2009

  • 42 Answers

SOURCE: my 98 cavalier z-24 is sucking down the gas. i

Do you smell gas. Sounds like you have a gas leak somewhere. There is no way the motor will use enough gas that you see the gauge move. It should only leak when the key is on. Good luck..

Posted on Nov 20, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Gas gauge stay on full but at idle moves up and down


Replace fuel sender in gas tank, mounted on fuel pump module.

Jan 17, 2014 | Cars & Trucks

1 Answer

1999 Isuzu Rodeo: the amount of gas in truck does not register on the meter. What could the problem be.


There could be a poor connection or an open circuit between the power control module and the fuel gauge sender, or the fuel gauge sender itself is bad. The sender is mounted to the gas tank and usually can be replaced without dropping the tank.

Apr 11, 2011 | 1999 Isuzu Rodeo

2 Answers

My 98 cavalier z-24 is sucking down the gas. i litterally watch the gauge move.


Do you smell gas. Sounds like you have a gas leak somewhere. There is no way the motor will use enough gas that you see the gauge move. It should only leak when the key is on. Good luck..

Nov 20, 2010 | 1998 Chevrolet Cavalier

2 Answers

1998 Isuzu Rodeo 6V, My Gas Guage does not work...what do I need to do?


Hello i had the same issue my gas gauge did not work and i had a bad fuel pump ,i ended up replacing my pump and realized the pump has 2 units attached to it one is the sending unit for the gas and the other the gauge level ,i encountered an issue when i swapped out the old pump for my new pump the gauge did not work any more after replacing,so i investigated after ruling out any wiring defect ,i made sure the pump was properly connected in its self the pump has a connector between the sending unit and the gauge level, and after that i realized the bcm, ECM, or vcm how ever its called (the computer) for my vehicle needed to be re-flashed completely for it to see the new pump... i never would have thought the main computer could not end up just detecting it automatically, all 98 and 99 must under go a re-flashing when any fuel pump is disconnected and replaced... hope that helped...

Aug 20, 2010 | 1999 Isuzu Rodeo

1 Answer

Gas tank/ gas gauge


What does your manual say that it is? Always check in your manual and you will have plenty of information to help solve your questions. However, I want to venture a guess about your gas gauge. You may have a computer mis-read and the new tank install is not interfacing with your computer.

Jun 29, 2009 | 1999 Isuzu Rodeo

1 Answer

Speedometer and gas gauge are giving false readings!


IT SURE SOUND TO ME LIKE YOU ARE MISSING A GROUND TO THESE GAUGES. THIS WILL BE TOUGH TO LOCATE WITHOUT A SCHEMATIC DRAWING TO HELP YOU. YOU MAY BE ABLE TO LOOK UNDER THE DASH FOR A LOOSE WIRE. YOU CAN ALSO CHECK THE FUSE PANEL FOR THE FUSE MARKED GAUGES TO SEE IF IT IS MAKING GOOD CONTACT. HOPE THIS HELPS. BEST OF LUCK. LET ME KNOW PLEASE. THANKS FOR USING FIX-YA!!!!!!!!!!!!

May 05, 2009 | 1998 Isuzu Rodeo

2 Answers

2001 Rodeo giving false fuel gauge readings


The sending unit in your tank is bad replace it.

Oct 21, 2008 | 2001 Isuzu Rodeo

1 Answer

99 honda passport


your sending unit in the gas tank is bad. You most likely already priced a new one that you can only get with a fuel pump. {around 275-300 dolllars}. I found the sending unit by itself on ebay for around 40 dollars. Just go to ebay and type in 98 99 00 01 02 rodeo passport fuel sending unit and that should take you to the guy I'm getting mine from.

Jul 10, 2008 | 1999 Honda Passport

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...