Question about Cars & Trucks

Open Question

Pulse Lightspeed 2 handbook - Cars & Trucks

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have no injector impluse


no injector pulse - DodgeForum.com

dodgeforum.com/forum/2nd-gen-ram.../269362-no-injector-pulse.html
Nov 21, 2010 - no injector pulse 2nd Gen Ram Tech. ... but was running and driving fine before. as far as i can tell i have no injector pulse. tested with a noid ... No spark AND no fuel injector pulse ONLY when van is cold ...
Nov 18, 2013
2000 ram 1500 Has spark but no injector pulse wont start ...
Jun 25, 2013
v10 RAM no start....frustrated
Sep 19, 2011
help - no spark, no injector pulse, no run
Oct 30, 2009
More results from dodgeforum.com

No injector pulse 02 Ram 1500 - DodgeTalk : Dodge Car Forums ...

www.dodgetalk.com > ... > 3G Dodge RAM - General Talk
May 30, 2012 - No injector pulse 02 Ram 1500 3G Dodge RAM - General Talk

Oct 23, 2015 | Dodge Cars & Trucks

1 Answer

Citroen c2 fuse box diagram under cashboard


you must look for the printed indication in the fuse box. Remember there 2 fuse box, inside from vehicle+ outside in the motor near to the battery, look them
God bless you

Jul 25, 2013 | Cars & Trucks

1 Answer

No injector pulse


1991 this make you OBD1 . You can access a code by jumping 2 terminals together.The injector pulse is from the PCM . If you have no pulse you need to troubleshoot for spark first . If you dont have spark do spark first then injector pulse comes on. If no injector pulse check fuse in engine junction box.Use a volt meter check grounds at PCM. If all else checks out good replace PCM. You may also want to check the TPS. If this sensor short out in the WOT position you also wont get injector pulse.SO disconnect the TPS. and recheck for injector pulse

Feb 23, 2012 | 1991 Chevrolet Caprice

1 Answer

I need to install a centrodyne pulse divider in my 2007 dodge caravan to go with my centrodyne silent 610 taxi meter.


Call Lee at Centrodyne he will help you.
The pulse is most easily found on the transmission at the VSS output. It is a connector with two wires, you want the DG/V. Run that to the pulse divider green wire. From the meter, tie the white in the 2 stand cable to the pulse output. Hook up power and ground then calibrate the meter. You should end up in the 33,000 range for calibration.

Feb 05, 2011 | 2000 Dodge Caravan

1 Answer

My 01 sable starts and dies and thats all it does due 2 injector pulse gets weak but if i unplug all of them it has good pulse but if i even plug any one of them it looses pulse after a few seconds


Check all injectors with a needle stethoscope. Unplug electrical connector of bad injectors, and check the signal with (injector check light). The light must pulse. If not might be a bad computer. If yes replace bad injectors with new one. Hope will help.
This is a free advice. Do not rate me.

Sep 08, 2010 | 2001 Mercury Sable

1 Answer

1992 3.9 fuelinjector fuses?


under drivers seat to rear of 2 tin covered relays 1 for fuel pump 1 for pulse injetors and spark [must have twin contacts inside] if wrong relay you will either get spark no injector pulse or pulse injector no spark [had similar prob myself]

Nov 20, 2009 | Land Rover Range Rover Cars & Trucks

2 Answers

No injection pulse


looking at the schematics, well the PCM controls the pulse width to the injectors , BUT , there is a injector coil fuse , its #2 in your kick panel fuse box , a 20 amp , check it , sure hope that fix ya . that would be sweet .

J5

Jan 15, 2009 | 1992 Buick Century

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...