Question about Cars & Trucks

Open Question

No brake lights on nissan cabstar. checked bulbs, switch and fuse.

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 651 Answers

SOURCE: Non working brake lights in Nissan Altima

make sure the button is working, it may need to be replaced. with your foot off the brake peddle, it is on upper part of brake peddle arm. when you let off brake peddle it pushes button in to shut lights off. it may just be stuck in, spray a little lubracant on it if it's stuck and push in manually several times to loosen.

Posted on Dec 01, 2008

  • 104 Answers

SOURCE: No brake lights on 95 Suburban

Disconnect electrical connector to brake switch brake located near brake pedal. Check for twelve volts or power with a test light on one side. If power, get a piece of wire, strip the ends and plug into each end of connector. If brake lights works, switch is bad. If not, check bulbs and power in the brake light socket. If no power, check to make sure power is leaving the trafficator switch as the brake light switch is depress or bypass. Check for broken or bad connection along circuit. If all good, you could have a trafficator switch problem. Oh, are the hazard and trafficators working in the rear? If they are, the trafficator switch is bad because the brake switch sends power there, then out to the back through the left and right rear trafficator wires.

Posted on Jun 14, 2009

  • 4 Answers

SOURCE: nissan almera brake lights not working,checked

Check the brake light switch under the dash at the brake peddle and make sure its working if it does not close when you depress the brake peddle the lights will not work You may hve to remove the lower cover for the dash to get at the switch

Posted on Sep 03, 2009

  • 1986 Answers

SOURCE: brake lights don't come on. checked fuse box,

look up above your brake pedal and you will see the switch.. It will either between the firewall and the pedal arm (switch moves in when you brake).. Or it will be between the pedal arm and the dash (switch moves out when you brake)

Posted on Oct 08, 2009

  • 484 Answers

SOURCE: 1989 Toyota Camry. No brake lights.

It could be the relay, which is a yellow box located under the carpeting in the trunk on the left side. It is a problem common to your model. Also, check the brake switch's (behind the brake pedal) functionality (12V present with key at ACC or ON and continuity between wires when button engaged).

i hope this helps
-matthew

Posted on Oct 26, 2009

Testimonial: "Wow! I would have never found the problem without you guys. It was the relay located in the trunk. Thanks!"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2007 Nissan Versa brake lights not working................. fuse is ok. All other lights are working


Did you check the bulbs ? If they are Ok,then check you brake light switch which is under your brake pedal. Good luck

Jan 09, 2011 | 2007 Nissan Versa 1.8 Sl Hatchback

1 Answer

3.5s v6 2004 nissan quest. brake lights not working.Already check fuse. kish.


First, replace bulbs and then check brake light switch, which is located near the top of the brake pedal. Use a voltimeter or test light to verify that there's voltage at the switch connector. It's not bad idea to replace brake light switch. Also make sure the brake pedal is correctly adjusted.

Aug 10, 2010 | 2004 Nissan Quest

1 Answer

No brake lights


One of three things: bulbs burnt out, brake switch bad, or no power to lights.

Take the bulbs out and test for continuity or replace. Check fuses, and/or check brake light switch typically located on the brake pedal shaft.

Jun 15, 2010 | 1995 Nissan Altima

2 Answers

All of the bulbs for the brake lights are new all


Brake light switch, think it should be under the brake pedal. when brakes are applied, the pedal compresses the switch, which makes the brake lights come on.

Dec 31, 2009 | 1994 Nissan Altima

1 Answer

'97 nissan altima, brake lights not working, wire


Lets keep it simple if the wiring harness is in good condition lets not look at that... first check your fuse if the fuse is good... check for power... if you have power coming and going from the fuse then check your brake switch ( located under the dash) attached to brake pedal. Please make sure your light bulbs are both good also. If your brake light switch is good and you have tried everything else it is either going to be in your 4 way switch or wiring harness

Aug 23, 2009 | 1995 Nissan Altima

1 Answer

Nissan almera brake lights not working,checked fuse okay,changed bulbs still not working i don`t whats wrong.


Check the brake light switch under the dash at the brake peddle and make sure its working if it does not close when you depress the brake peddle the lights will not work You may hve to remove the lower cover for the dash to get at the switch

Aug 15, 2009 | 2003 Nissan Altima

2 Answers

I have a 2001 Nissan Altima, brake lights not working. Fuses okay and brake switch okay. What else can I look for?


there is a plastic plug that push the brake swith and they usually brake after many years , check that , and also check all the light bolbs

Aug 02, 2009 | 2003 Nissan Altima

1 Answer

Brake lights went out, changed bulbs, checked fuse, still wont work


You have to check the brake light switch which should be around the brake pedal on the upperside.
Ones located rremove the wires tht go to the switch and jump them by using a piece of wire, thn check if the brake lights come 'on'. If they do , thn its the switch tht may need replacing or even sometimes adjusting inorder to operate.
Hope this helps.

May 10, 2009 | 2002 Nissan Xterra

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

101 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...