Question about Cars & Trucks

Open Question

Ferrari 360 spider.2004 Will not go into reverse

Ferrari 360 spider.2004 Will not go into reverse and pulling forward while standing in 1 gear ?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: hi i got a ferrari

See if the brake lights go on, had a 360 f1 one of the fuses where gone

Posted on Jan 07, 2010

  • 93 Answers

SOURCE: 2003 Ferrari 360 spider convertible issue

The most common reason for this is low hydraulic fluid. The noise is probably the pump running while empty. When fluid id present it dampens that noise. Behind the rear seat is the combination motor/pump/reservoir. With the top in the DOWN position, fill the reservoir with ATF and cycle the system a few times as far as it will go. Repeat until the reservoir will take no more fluid. If that works, it is only a patch fix. You must now inspect the lines, motor and cylinders for leaks. The fluid does not evaporate. If it is low, you have a leak. Karl at topgunwon.com

Posted on Feb 01, 2010

pappapumpdaf
  • 635 Answers

SOURCE: turbo 350 trans no forward gears but does have reverse

It's either your servo, or your bands.
Either way, the tranny needs a good cheap shop repair.
I'd just get a warrantied salvage yard tranny if I were you and save a few hundred bucks.

Posted on Mar 07, 2010

  • 12 Answers

SOURCE: Ferrari 360 dead battery

Correct, the battery is in the passenger footwell under the aluminum plate. It is perfectly fine to charge the battery here, but it is not recommended to jump start. Also, it is possible to get in the trunk without having power. There is an emergency release pull tab under the drivers side dash. Quite easy to use, actually I normally use this in lieu of the normal electric release.

Posted on Mar 28, 2010

  • 129 Answers

SOURCE: need a ferrari radio manual (made by becker) for a

Do you need it to have it or do you have a question on function

Posted on Nov 17, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to change worn spider gears


new spider gears or possibly u-joints in your rear drive shaft. Or it could just be a cheap rear i have a jeep and its done it since i first bought it.

Aug 15, 2012 | 2001 Ford F250 Super Duty Super Cab

1 Answer

Ferrari 360 Fi spider instrument back lighting doesn't work, fuses are checked ok , what to do?


Time to open up the cluster and check for bulbs being out, or a shorted wire. Do the dials and gauges still work, and is there a dimmer on your model. I remember the older Ferrari's' having a dial type dimmer, you may have moved it to the lowest setting that would make them appear off.

Jul 12, 2011 | 2004 Ferrari 360 Modena

1 Answer

Engine management light has come up on ferrari 360. apparently disconnecting the battery in the bonnet may resolve this? how is this done, i am at work, will have a look when i get home. is it straight...


you need an OBII scanner to rest the lights. the scanner will read the faults (in codes) some can be critical, others are just minor nuances but are track by OBC. Disconnecting battery is only going to add another fault - that used to be "old school fix". Have a competent shop scan it for you, alot will do it for free.

Feb 22, 2011 | 2004 Ferrari 360 Modena

1 Answer

Ferrari 360 will not rev above about 1500 rpm. Cold weather around 40 degrees F, but even after the car idled for 10 minutes warmed up to 200 degrees F engine temp the car would not rev above 1500. When...


without my greasy hands under the bonnet its hard to say but dont be scared of it just because it say ferrari on the front its still made by fiat and uses a lot of common parts ,now what i would do here is to test the mass air flow sensor with my automotive tester to see what happening and if the voltage is varying as it reved up before i start to even think about changing anything ,if this sensor is faulty then its not measuring the right air flow which will not allow petrol to be injected through the injectors hence its not picking up and i think it may be the cold weather thats affecting the sensor in some way ,remember warming up the engine will not make the sensor warm as it still has cold air being drawn in through the inlet pipe

Jan 24, 2011 | 2003 Ferrari 360 Modena

1 Answer

How to change a timing belt on 2003 ferrari 360 spider


The 360 has an access panel behind the seats. To get to the panel the interior trim behind the seats has to be entirely removed. Assuming that you have changed belts before, as an interference engine with tight tolerances, you can not be off one notch without destroying the engine.
the tensioner pulleys should be replaced with the belts. you can spin the bearings to check them but after all the work getting there I would replace them. tension is set through eccentrics.

Dec 01, 2010 | 2003 Ferrari 348 Spider

1 Answer

2003 Ferrari 360 spider convertible issue


The most common reason for this is low hydraulic fluid. The noise is probably the pump running while empty. When fluid id present it dampens that noise. Behind the rear seat is the combination motor/pump/reservoir. With the top in the DOWN position, fill the reservoir with ATF and cycle the system a few times as far as it will go. Repeat until the reservoir will take no more fluid. If that works, it is only a patch fix. You must now inspect the lines, motor and cylinders for leaks. The fluid does not evaporate. If it is low, you have a leak. Karl at topgunwon.com

Jan 01, 2010 | 2003 Ferrari 360

1 Answer

2002 360 Modena Spider water leak???


possibly heater hoses or engine coolant hoses get them looked at A>S>A>P as your repair billcould be horrendous,check that the clamps are tight should be straightfoward fix,get any knowledgable friend to look for the answer if youre not sure dont drive it tillits fixed or youll cook the engine

Oct 25, 2009 | 2002 Ferrari 360

2 Answers

Hi i got a ferrari challenge 360 in my shop the gear box work fine when the engine is off but can not put first gear or reverse when the engine unning let me know if somebody met the problem before


i think ,the problem is the clutch system,i resolve same problem in others cars, first purge the hydraulic clutch system,if not resolve you have to change the disc, pressure plate and reverse bearing

Feb 03, 2009 | 2003 Ferrari 360 Modena

3 Answers

Ferrari 360 dead battery


Correct, the battery is in the passenger footwell under the aluminum plate. It is perfectly fine to charge the battery here, but it is not recommended to jump start. Also, it is possible to get in the trunk without having power. There is an emergency release pull tab under the drivers side dash. Quite easy to use, actually I normally use this in lieu of the normal electric release.

Dec 14, 2008 | 2004 Ferrari 360 Modena

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

145 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...