Question about Cars & Trucks

Open Question

1985 volvo 240 hazards lights work turn signals don't

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: TURN SIGNAL, BRAKE & HAZARD LIGHTS

No Turn Signal Operation (blinker)The turn signal lights in your car are a basic electrical system that controls the front and rear blinker lights to alert the intended direction of the vehicle. We have listed some of the most common problems and repair troubleshooting tips below:
Troubleshooting Procedure
To start troubleshooting this problem:

  • Turn the key to the on position (do not start engine)
  • Inspect the system fuse located in the fuse panel and replace if needed. If you cannot find the location of the blinker fuse consult your owner's manual or an online repair manual
  • When a blinker flasher fails it can cause blinker lights to say on, not blink, or not go on at all. To test the blinker system flasher, remove the flasher unit and insert a jumper wire between the two terminals. If blinker stays on in both directions without blinking, replace the flasher. If you cannot find the location of the blinker flasher consult your owners manual or an online repair manual.
  • 1b7f814.jpg

Posted on Jul 09, 2009

polarcycle
  • 1392 Answers

SOURCE: My turn signals/hazard lights aren't working, fuse--Chevy Tahoe

look for your short somewhere in the wiring harness.

Posted on Jul 23, 2009

  • 107 Answers

SOURCE: 1991 Volvo 240 backup lights do not work

The 240 was always a bit susceptible to poor electrical connections in the taillights. Check all the connections at the taillights thoroughly and then work back through the wiring. The other major possibility is that the reverse-engaged switch (is engaged by gear shift) has failed. I can't remember off the top of my head, how to get at a Volvo's switch but a bit of poking around the gearstick should probably find it for you.
Hope this helps - please message me if you require extra info/help Sherwin

Posted on Sep 02, 2009

  • 4 Answers

SOURCE: 99 Chevy Tahoe... Rear turn signals, brake lights, and hazards

I had this problem, and to be honest, it happened to the left side about a week later...it's the board that the bulbs plug into...it's a very common problem with this model. So popular that you can normally get the socket board off the shelf at a parts store! it's extremely simple to replace, and I replaced all the bulbs at the same time!

Posted on Oct 11, 2009

  • 1 Answer

SOURCE: 1999 Camry Turn signals and hazard lights not working.

located on the firewall panel on the left side of the floorboard on the drivers side

Posted on Mar 27, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1985 LeSabre flashers work turn signals don't need location of turn signal switch or are they one of the same


You mean turn signal flasher? No, the hazard flasher and turn flasher on older cars were separate. Often, the hazard flasher was right of the steering column (under the dash), and the turn flasher was left of the column. Look for two similar canisters. Turn the hazard lights on and locate the hazard flasher by feel or hearing. The turn flasher will be the other one. They both may be retained by metal clips.

Sep 16, 2015 | Cars & Trucks

1 Answer

The hazards and turn signals wont work. I have checked, the fuse, hazard switch, turn signal relay, turn signal switch and bulbs, all has power and ground. Still the lights do not work. What else can it...


Must agree with the others most likely thing is the flasher unit. If the seat belt reminder light isn't working its a good sign the units failed. They both use the same flasher which is why the seat belt light changes speed when you turn the indicators on. Hope you find the problem soon.

Apr 02, 2014 | 1993 Volvo 240

1 Answer

2000 tacoma flashers don't work but turn sig do work!


The hazard switch gets power from the horn fuse which is hot all the time, and from the turn signal fuse which is hot when the key switch is on. The turn signal switch gets power from the hazard switch and both use the same flasher.
So if the turn signals work but the hazard switch does not power the lights, and both fuses have power, I would say the problem is inside the hazard switch.

Feb 19, 2013 | Cars & Trucks

1 Answer

Hazard warning light don't work


Its possibe that ypou have independient FLASHER device, one for hazard and one for turn signal; check backside of fuse panel and replace it.

Aug 28, 2012 | 1993 Plymouth Voyager

1 Answer

How to fix turn signal on 86 Chevy Astro Van


you don`t say but do the lights work either on the front/back on both sides.if not then it may be a fuse that needs replacing or need a bulb replacement.if the lights work but don`t flash then it sounds like a signal flasher problem.the flasher is located in the fuse panel under the dash on the drivers side.if the hazard flashers work then turn them on to find the hazard flasher by the fuse panel then you will know what the signal flasher looks like and change the signal flasher.make sure you change the one for the signals and not the hazard one.if the hazards work then i would say the signal switch is good as the hazards work through the same switch.

Apr 21, 2011 | Chevrolet Astro Cars & Trucks

2 Answers

Turn signals and hazard light not working


Sounds like the falsher unit itself is bad.
Looks sort of like a small relay, in the fusebox. Turn signals and emergency lights use the same flasher.

Jun 26, 2009 | 1996 Volvo 960

1 Answer

85 Chevy k10 pickup: Working headlights, but no park/tail or turn/hazard lights.


one of your bulb is blown one bulb will shut the rest off check all your bulbs.

Jun 03, 2009 | 1985 Chevrolet Chevy

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

46 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...