Question about Cars & Trucks

Open Question

95 chevy g20 headlights and high beams won't turn on

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 6 Answers

SOURCE: saab 95 headlights dont work high work and drive lights stay on

IF THE BULBS ARE OK CHECK THE HEADLIGHT MODULE(IT LOOKS LIKE A RELAY, ORANGE CASE I THINK) TRY WIGGLING IT,IM PRETTY SURE THATS IT. THEY GO BAD ALOT ON SAABS. IT SHOULD BE IN THE ENGINE CONPARTMENT

Posted on Jan 30, 2009

  • 75 Answers

SOURCE: 1993 Chevy Silverado truck headlights high beam only works no low

dimmer switch has gone bad need to change your dimmerswitch

Posted on Apr 01, 2009

  • 54 Answers

SOURCE: 95 chevy g20 idles too high, how do I turn idle down?

i would first check for a vacuum leak because this is considered a newer vehicle and does not have an idle screw, so I would get some "brake kleen" and mist it at each vacuum hose, if the idle changes then change that hose it means there is a leak, and that should sove your problem, if it doesnt , I would then check /replace the idle air control valve as this is the motor that controls the idle

Posted on May 26, 2009

alicantecoli
  • 22095 Answers

SOURCE: headlight trouble on sunfire 2003 with 2.2ecotech

sounds like either a wiring loom is shorting across somewhere ??where ----best of british to finding it

Posted on Aug 05, 2009

GM Elec
  • 1000 Answers

SOURCE: 95 G20 Chevy van: ABS light stays on, pulls right when braking

You actually have two separate problems. The brake pull to the right is indicating the left side brake is not working properly. You will want to remove the left front wheel, collapse the caliper piston and make sure the caliper is floating freely on its mounts.
With the piston collapsed you should be able to slide the caliper inboard and outboard of the rotor. If not, you will want to remove the attachment pins, clean and lubricate the pins. If they are grooved or worn you will have to replace them.
The second issue of the ABS light is indicating the system has detected an electrical sensing or control problem. Take the vehicle to your local Auto Zone or Advance Auto and ask them to scan the vehicle for trouble codes. They will scan it for you at no charge.
Chances are you will find a wheel speed sensor problem at one of the wheels.
Write the codes down and respond back, we can start diagnosing the problem,
Good luck, let me know.
Regards,

Posted on Aug 31, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2008 chevy malibu and the headlight won't turn on but the high beam will turn on, what can I do to get my headlights to turn on?


It could be that your low beam filament has burnt out. These are the most commonly used and tend to burn out after a year or two, although the high beam filament will still be good.

Feb 03, 2015 | Cars & Trucks

1 Answer

On a 1995 chevy g20 van aren't all four headlights suppose to be active on high beams?


mostly no. there are two beams circuits A high beam (2 globes one each side) and a low beam circuit ( 2 bulbs one on each side) The globes should be A4 bulbs which have 3 pins on the back One pin is high beam and the other pin is for low beam while the middle pin is the earth pin for both sides.

Dec 25, 2013 | Cars & Trucks

1 Answer

My night time headlights won't turn on. All the other lights including High Beams work.


Have you checked to see if the bulbs are burnt out or if the low beam fuses are Blown?

Apr 09, 2013 | 2003 Dodge Caravan

1 Answer

I have a 95 chevy s10 pickup and the headlights went out, I still have high beams and running lights. What should I look for?


I would check the dimmer switch for power in both high and low beam circuits if you know for a fact the headlight bulbs are good.

Dec 20, 2012 | Cars & Trucks

1 Answer

95 Chevy lumina van, heat on won't turn off. A/c


Hi wodermom26,

Your Lumina APV is a clone of the Pontiac Transport and Oldsmobile APV's which all have identical Heater & A/C controls. The Heater & A/C controls usually wear out mechanically causing no control of temperature. This is a difficult repair and is best made by a dealers ASE Certified Technician. A/C may require re-charging and or possible replacement of the hoses which carry the refrigerant as they become porous and leak. Additionally, the Compressor and its Clutch may possibly require replacement.

The High beams are controlled by pushing the Turn Signal switch forward toward the Instrument panel and have a momentary "Flash to Pass" function by pulling the Turn Signal Lever upward toward the steering wheel and return to Low Beam upon release of the turn signal Lever. If neither function of the Beam selector lights the High Beams it is pssible that the Headlamp bulbs are burned out or open connections in the wiring harnesses. Do you have an owners manual for your Lumina? If so it has information regarding the Multi-Functions of the Turn Signal Lever.

Rapid Robert

Sep 25, 2011 | 1995 Chevrolet Lumina Apv

1 Answer

I have a 2003 grandprix and the headlights and the back lights and interior light panel don't turn on but when i put the high head lights it turns on but not the back or interior panel lights.


it could be a blown fuse, you may find that the HIGH & LOW beam lights are on separate fuses the back & panel lights could be on the same fuse as the LOW beam or they may have there own fuse,check the fuses in the fuse box........hope this helps......cheers.

Sep 13, 2011 | 1985 Chevrolet Sportvan G20

1 Answer

My 95 ford windstar headlights won't turn on..but my high beams and parking lights work


I had the same problem with my 98 and the signal lights switch on the steering column was bad

Jun 13, 2011 | 1998 Ford Windstar

1 Answer

95 chevy g20 idles too high, how do I turn idle down?


i would first check for a vacuum leak because this is considered a newer vehicle and does not have an idle screw, so I would get some "brake kleen" and mist it at each vacuum hose, if the idle changes then change that hose it means there is a leak, and that should sove your problem, if it doesnt , I would then check /replace the idle air control valve as this is the motor that controls the idle

May 26, 2009 | 1995 Chevrolet G20

3 Answers

Chevy S/10 headlights


headlights are on a circuit breaker--not a fuse. so if you have a high amp draw situation--the breaker will get hot and turn the lights out then cool off and reconnect(a safety feature so you may have headlights a least part of the time). You need to look for reasons for a high draw. bad headlights themselves are the most popular cause as well as corroded connecters. Hope I helped

Apr 06, 2009 | 1994 Chevrolet S-10

2 Answers

Low beam headlights on 95 honda civic dx


Im just curious if you found a fix for this issue because I'm curently having the same problem with 98 civic?

Jan 19, 2009 | 1995 Honda Civic

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...