Question about Cars & Trucks
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: porsche key fob
If the key had gone faulty, the key code must be re programmed on the vehicle computer. This can be done only using a PIWIS tool, available at the dealer or at a qualified Porche garage.
Try also the following reset:
turn ignition on,
remove the transponder from the column
push any button on the fob within 6 seconds.
This procedure will reset the key synchronizing again with the vehicle computer.
Posted on Sep 13, 2008
SOURCE: key fob will not undo
If you don't have one that works for the vehicle now, you'll have to take it to your local dealer to have it programmed to the vehicle. Some will charge for this, some will do it at no charge.
If you do have a remote that is programmed and working for the vehicle, then the following steps will allow you to program another remote:
1. Enter vehicle and close all doors.
2. Put seatbelt on (or clip it into the buckle) to shut the warning buzzer off.
3. Put key in ignition, turn to run position but don't start it.
4. Press and hold the unlock button on the working key fob and hold for 4 seconds, then also press the panic button.
5. Release both buttons and you should hear a single chime to indicate it is in program mode. You have 30 seconds after the chime to program any additional remotes you want to program.
6. Press and release both the unlock and lock buttons simultaneously on the remote you are programming. You should hear another single chime.
7. Within 4 seconds after hearing the chime, press either lock or unlock button on remote that you are programming.
Posted on Oct 16, 2008
SOURCE: key fob wont work
the battery part just use a flat screwdriver, or if you are like my wife a butter knife, and pop off the back and go get a battery. You should not have to reprogram the remote. I just bought a 98 lincoln and the battery was dead in the remote also and all I did was replace the battery. hope this helps.
Posted on May 28, 2009
Your key fob needs reprogramming, and yes the alarm will go off when you open the door, but you have enough time to put the key in the ignition which will prevent the alarm sounding. Car is usable until you get the fob sorted by locking and unlocking using the key.
Posted on Jun 11, 2009
This does not sound like a fob fault - but a locking control module fault , either in the hardware or software of the unit. Get it checked at a Jaguar dealers. When unlocking using the key - as soon as the door is opened you should hear a chime sounding inside the car - this is a timer counting down to sounding the alarm. If you put your key in the ignition as soon as you open the door the alarm should not go off and the chime should stop. If it does not this again points to a fault in the locking controller.
hope this helps - good luck.
Posted on Jul 08, 2009
Tips for a great answer:
Dec 31, 2016 | Honda Cars & Trucks
Aug 21, 2011 | 2002 Lincoln Navigator
Sep 03, 2010 | Toyota Camry Cars & Trucks
May 23, 2010 | 1997 Land Rover Discovery
Nov 23, 2009 | 1997 Jeep Tj
Oct 03, 2009 | 1998 Volvo V70
Sep 06, 2009 | 1997 Lexus GS 300
May 28, 2009 | Chrysler Voyager Cars & Trucks
Mar 17, 2009 | Volkswagen Beetle Cars & Trucks
45 people viewed this question
Usually answered in minutes!