Question about Cars & Trucks
Posted by Anonymous on
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
starters are normally located at the rear of the motor usually hard to get too or see. should be on your bell housing in other words just in front of the gearbox/clutch
Posted on Dec 23, 2008
Check the passanger side floor board for moisture this could indicate a bad heater core. Then I would check the engine oil and make sure its not milky looking (head gasket). make sure when you fill it let it run with the cap open with you looking into the cap to be sure is circulating and not vapor locked (air pocket)
hope this helps
Posted on Feb 01, 2009
SOURCE: Water pump
Hello nedy...if you have the V6 engine, it will require the removal of the timing chain cover to access the water pump. The water pump is mounted to the engine block with 4 bolts. It is recommended that the bolts be replaced due to electrolysis (steel bolt in aluminum block) Replace all gaskets and o-ring seals as well.
While you are in there, you can inspect the timing chains, it has 3..and the chain tensioners. A Haynes repair manual would be helpful on this project and will have the correct torque specs.
Good luck...i hope this helps, please rate mr a fixya.
Posted on Jul 27, 2009
you first need to remove the big nut that is holding the wheel on the side that you are trying to replace first you must buy the right sized socket thet will fit the nut the while the vehicle is still on the ground take the hub cap off and the cater pin out and then put the socket on the nut using a halt inch tourge ratchet loosen and remove the nut then jack your vehicle up and remove the wheel and the bolts that are holdung the hub and then with a pickle fork that is the tool used for removing tie rod ends that is connected to your stirring and then after that remove your axle and then reverse the procces to put ti back together.
Posted on Sep 10, 2009
Its below the Dashboard, on the left side of your knee. You have to use a torch & locate it from under the Dashboard, Its roughly near to the Clutch Pedal.
Here, it looks like this: (The Black one is the Fuse box)
Posted on Jan 23, 2010
Tips for a great answer:
Sep 11, 2014 | 2005 Suzuki Grand Vitara
Feb 13, 2013 | Suzuki Vitara Cars & Trucks
Jan 13, 2012 | Chevrolet Chevrolet Cars & Trucks
Jan 12, 2011 | 2000 Suzuki Grand Vitara
Oct 04, 2010 | 2000 Suzuki Grand Vitara
Mar 02, 2010 | 2006 Suzuki Grand Vitara
Oct 14, 2009 | 2000 Suzuki Grand Vitara
Jun 21, 2009 | 2005 Suzuki XL-7
Aug 03, 2008 | 2003 Suzuki Vitara
44 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: