Question about 2000 Volvo S70

Open Question

Non-turbo model s70 - codes P0327 and P1671/P1672 and car will not respond to throttle until up to normal operating temperature

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
roy7777
  • 109 Answers

SOURCE: I have a 98 S70 turbo ~171000 mi. car will start

THE FIRST THING IS TO CHECK FIEL PUMP PRESSURE AND FILTHER AND THE RELAY IT IS IN FUSE BOX WITH A J and it is black and if it gets too hot engine will shut down and you will have to wait until relay cools 850,s and S70 models have this problem especially in th A/C CIRCUIT

Posted on May 05, 2009

Ad
emissionwiz
  • 76164 Answers

SOURCE: what transmission fluid do I use for 99 volvo s70 non-turbo

use Volvo ATF fluid or Mobil 3309 ATF, the Mobile 3309 may be cheaper.

Posted on Dec 20, 2009

  • 462 Answers

SOURCE: Do I need to remove the dash to remove a heater

Don't remember exactly , but I think it could be done without dash removal.
It's done from driver side footwell area , tight but possible.
You have to take out lower center consol side cover , next to the accelerator pedal and roll the carpet out of the way, and you will see the heater core case. Remove cover on the case (some have it on the side , some on the bottom).Two pipes going from firewall to the core have to be disconnected before core removal (will leak coolant , have some rags on the floor to absorbe it).
Slide heater core out , put new one in gently as the accelerator pedal is on your way , try to avoid damaging core a lot.
Always replace heater core pipes o-rings.

Posted on Jun 30, 2010

  • 127 Answers

SOURCE: 1998 volvo s70 distributor leeking

just remove distributer knock roll pin out holds bottom gear on remove bottom gear pull shaft out of dist. housing replace o-ring seal and reassemble, not really that hard

Posted on Mar 22, 2011

  • 1 Answer

SOURCE: Where is fuel filter on 1998 Volvo S70 non turbo?

the fuel filter is located underneath the rear passenger seat next to the canister box (the canister looks more like an air filter box housing. All you need is an 1/2 inch key to loosen one screw and pull on one end of the hose/tube to release it from the fuel filter. Pull opposite the unit. your best solution is to look to buy it on line so you have an idea as to what you are looking for then check against the info provided to you. I just did mine 15 mins. next to the rear tire. You will need to jack up the rear tire for easy access

Posted on Dec 30, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why is error code p0327


Code P0327 indicates that the readings from the #1 Knock Sensor circuit are too low, is outside of its operational window and malfunctioning. Symptoms
  • Check Engine Light will illuminate
  • Engine pings on accelration
  • Engine may be running hotter or colder than normal
  • In rare cases, the engine may not exhibit noticeable symptoms
Common Problems That Trigger the P0327 Code
  • Defective Knock Sensor
  • Defective Knock Sensor Circuit or connections
  • Defective EGR System
  • Malfunctioning Cooling System
  • Rich air/fuel ratio
Common Misdiagnosis
  • Knock Sensor replaced when cause of code P0327 was a cooling system problem
  • Knock Sensor replaced when cause of code P0327 was an EGR system malfunction

Sep 28, 2015 | 2005 Suzuki Forenza

1 Answer

What do I when my 98 volvo s70 2.4L engine has trouble codes po133 & po442?


Po133 is and oxygen sensor code. Replace the front oxygen sensor use a bosch or OE sensor only. P0442 is and evap system leak. Most common fault is a cracked hose at the evap cannister at the right rear of the car.

Mar 19, 2015 | 1998 Volvo S70

1 Answer

Fault code P1672


1808 coolant fan control 1 open or short to ground p1672 no signal /no communication. its had s3 front conversion so the double radiator fan is only running one fan

Jul 09, 2014 | 2004 Audi A3 2.0

1 Answer

What is code p1670 and code p1671 mean


First code is for an immobilizer problem. Clean the contacts for the antenna ring around the ignition switch first. Second codes is for the Cam position sensor. Could be caused by the sensor or a sticky VVT valve.

Jun 04, 2014 | 2000 Volvo S70

1 Answer

Show how to replace a throttle position sensor in a 1999 volvo S70 five speed non turbo 2.4 dohc


Throttle position sensor is part of the throttle body assembly. It is not sold as a separate part. You need to replace the throttle assembly. Remove the intake tube, remove the 4 bolts and disconnect the electrical plug. It will need to be programmed by someone withe the Volvo Vida software.

May 25, 2014 | 1999 Volvo S70

1 Answer

Diagnostic codes


Is this a turbo or non turbo?

Mar 29, 2014 | 2000 Volvo S70

1 Answer

Are ceramic pads and slotted rotors worth the extra money? I need to replace t-stat in my 2000 Volvo S70 GLT SE non-turbo, what temperature rating do i want for the new t-stat? Does this car have a PCV...


The ceramic pads are worth the extra money, due to the increase in the quality of the pads, slotted rotors, not so much. Original equipment is a 192 degree thermostat. If the car tends to run a little hot, a lower temperature one maybe considered. There is no PVC.

Mar 11, 2010 | 2000 Volvo S70

1 Answer

I have a 98 S70 turbo ~171000 mi. car will start


THE FIRST THING IS TO CHECK FIEL PUMP PRESSURE AND FILTHER AND THE RELAY IT IS IN FUSE BOX WITH A J and it is black and if it gets too hot engine will shut down and you will have to wait until relay cools 850,s and S70 models have this problem especially in th A/C CIRCUIT

Apr 20, 2009 | 1998 Volvo S70

1 Answer

Odometer does not work


This is a common problem with all models of volvo, with the non digital odometer  pre 1998,, there is a tiny nylon gear deep inside the odometer that needs to be replaced. Your dealer will not fix it, but will put in a new one for you as the cost of fixing in labour is more than a new one,, My solution is much cheeper,, I have
many low milage VOLVO odometer/instr clusters, a few hi'r km 1s


ODOMETERS FROM 1987-PRESENT
I have many pre 1998 Volvo instrument clusters, most with Very low milage, almost all in Km, I have most models of Volvo.

at these prices IT'S A GOOD IDEA TO HAVE AN EXTRA ONE , comes with detailed instructions -with pictures-on how to remove your old one and re-install

just for example
I have 4,, 1994-1997 850/s70/v70 /c70turbo with less than 10,000 km
2 1994-1997 850/s70/v70/c70 non turbo with less than 10,000 km
1 1990 740 -940 turbo with less than 4.000 kms

I also have many Volvo instrument clusters from 1987 to PRESENT with varied milage,,let me know what year and model and milage you are looking for,, I will have something close

WILL SHIP ANYWHERE IN N.AMERICA

Dec 12, 2008 | 1994 Volvo 850

Not finding what you are looking for?
2000 Volvo S70 Logo

Related Topics:

75 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volvo Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Volvo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...