Question about Cars & Trucks

Open Question

2013 vw BEETLE exterior PASSENGER door handle removal

Posted by Anonymous on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 316 Answers

SOURCE: How do I remove the door panel on my 2003 VW Beetle?

Disconnect your negative battery cable. Locate and remove the screws that hold your interior door handles in place (they may be hidden by snap in, or snap on clips). Remove the interior door handles, then disconnect the wire clips to the switches. Your panel is held in place by snap in clips; use a small pry bar to pull them from the door (try to get as close to, or directly under the clips to prevent them from tearing out of the door panel). Once the clips are pulled, pull the panel upward to remove it from the door.
Install in reverse.

Posted on May 25, 2009

motorhead427
  • 24 Answers

SOURCE: Need instructios to repair 1997 Toyota Camry Broken Exterior Door Handle

Two 10mm bolts, or nuts, hold the handle on from inside the door. dont forget to remove actuating rod from old handle. probably clip is broke also.

Posted on May 30, 2009

  • 1986 Answers

SOURCE: door panel removal

You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door

Posted on Aug 14, 2009

  • 1986 Answers

SOURCE: need to remove inner rear passenger side door

On the inside trim, you can remove screws (these screws may be covered by filler pieces or may be visible, or they may require you pry a plastic piece off that covers the screws) that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you need to pull back the weather seal and then you can access the bolts securing the outer handle

Posted on Nov 05, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Replace left front fender


Replace left front fender - Fixya

www.fixya.com/cars/t26028082-replace_left_front_fender
Dec 29, 2015 - replace left front fender - Hyundai Motor 2003 Elantra question. ...Question about Hyundai Motor 2003 Elantra. Open Question ... How do i remove left front fender clip on a Lincoln ls 2002? Jan 04, 2015 ' 2002 Lincoln LS.

Replace 2003 hyundai elantra front passenger outside door ...

www.fixya.com/cars/t17348691-replace_2003_hyundai_elantra_front
Mar 26, 2013 - Question about Hyundai Motor 2003 Elantra. Open Question.Replace 2003 hyundai elantra front passenger outside door handle. Need to replacebroken exterior door handle on front passenger .... replace left front fender.

Dec 29, 2015 | Hyundai Motor 2003 Elantra

1 Answer

VW Jetta 2012 exterior handle will not open door; however, interior handle will open the door.


Remove the inner door panel and make sure the actuator rod for the exterior handle is still engaged. If it is then the handle itself needs to be replaced.

Oct 29, 2013 | Cars & Trucks

1 Answer

How to tighten passenger side exterior door handle on a 2007 honda accord sedan


There should be retainer nuts on the inside. You would have to remove the inner door panel to access.

Jun 30, 2013 | 2007 Honda Accord Sedan

1 Answer

How do I replace the front passenger window on a 1999 vw beetle?


U have to remove door panel,then roll handle down to where u can see ththe part that holds the window,remove bolts,never have put new glass in a door,but, i'm sure u will have to remove window tracks,with tracks reremoved,the glass is sure to fit in top and slide in i would think?i could explain it better,on phone or in person!

Sep 03, 2012 | 1999 Volkswagen Beetle

1 Answer

1989 VW GTI - Broken Passenger Exterior Door Handle


open the door and remove the door panel there is a small metal rod that goes from the outer handle to the latch mechanism that holds the door shut look to see if it has just come undone or if the small retainer clip has broken or came off either way it's a fairly straight forward repair

Feb 11, 2010 | 1989 Volkswagen GTI

2 Answers

Need instructios to repair 1997 Toyota Camry Broken Exterior Door Handle


Two 10mm bolts, or nuts, hold the handle on from inside the door. dont forget to remove actuating rod from old handle. probably clip is broke also.

May 30, 2009 | 1997 Toyota Camry

2 Answers

How do I remove the door panel on my 2003 VW Beetle?


Disconnect your negative battery cable. Locate and remove the screws that hold your interior door handles in place (they may be hidden by snap in, or snap on clips). Remove the interior door handles, then disconnect the wire clips to the switches. Your panel is held in place by snap in clips; use a small pry bar to pull them from the door (try to get as close to, or directly under the clips to prevent them from tearing out of the door panel). Once the clips are pulled, pull the panel upward to remove it from the door.
Install in reverse.

May 25, 2009 | 2003 Volkswagen New Beetle Convertible

1 Answer

My driver side door handle is broken on a 2003 VW new beetle. How can I fix it?


remove the inside door trim and remove the weatherproof plastic that covers the holes in the door behind the trim.
You should have access to the door handle nuts and rods to remove the handle.
re assemble in the reverse order and make sure the weatherproof plastic is put back on and sealed or your door may let water enter the car via the door

May 12, 2009 | 2000 Volkswagen Passat 4Motion

1 Answer

Diagram for replacing exterior door handles


ok. first u remove the door panel(s), with the window rolled up, u will be able to see the back side of the exterior door handle. there will be three bolts, they are size 10metric. there is also a rod attached to the handle held in place by a plastic clip, remove the rod, then remove the three bolts. from the outside remove the exterior door handle being careful not to scratch painted surface. Repeat for the other door(s). Repeat this for installation.

Dec 14, 2008 | 1997 Toyota Camry

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

468 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...