Question about Cars & Trucks
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Check the brake light switch under the dash at the brake peddle and make sure its working if it does not close when you depress the brake peddle the lights will not work You may hve to remove the lower cover for the dash to get at the switch
Posted on Sep 03, 2009
This sounds like the reverse switch has gone bad. The switch is located on the side of your transmission and will have 3 wires sticking out of it
Posted on Sep 14, 2009
yes there is. Above the brake pedal there is a switch tat turns the lights on when you press the pedal. It is tough to replace due to the lack o room to put your hands. but is an inexpensive part.
Posted on Oct 06, 2009
Testimonial: "i have already replaced that switch and still no lights, thanks though, i appreciate your time and help"
The first objective is to figure out which bulb you need. I had to replace the bulb for the largest light which was a Sylvania 3157. The next objective is to remove the dang plastic carpet holder/net clip. Recognize that it is a two part piece. Use a flathead screwdriver for leverage. Pry the cap off by levering the screwdriver in the slot on the holder. Then go behind the carpet and pinch the plastic pin still holding the holder in place. Next,pry off the while plastic pieces from the two bolt/nuts you'll need to remove (see manual). Remove the nuts and give the two screws a push from the inside so you can see how the whole light casing comes off. Pry it off from the outside. On the backside of the bulb holder, turn bulb base counterclockwise and gently remove. Pull bulb upward and replace. Do not touch glass on new bulb with your fingers (wear non-powdered rubber gloves). Make sure the bulb snaps in place. Follow these instructions in reverse. Smile, you just learned something new and saved yourself some easy money.
Posted on Jan 09, 2010
Tips for a great answer:
Jan 29, 2015 | Nissan Cars & Trucks
May 31, 2014 | 2011 Nissan Micra 1.2
Oct 07, 2013 | Nissan Micra Cars & Trucks
Oct 21, 2009 | Nissan Se R Cars & Trucks
Oct 13, 2009 | 2002 Nissan Maxima
Sep 29, 2009 | Nissan Micra Cars & Trucks
Sep 13, 2009 | 2000 Nissan Altima
May 10, 2009 | 2002 Nissan Xterra
180 people viewed this question
Usually answered in minutes!