Question about 1996 Honda Accord

1 Answer

How to remove the clutch peddle off a 96 accord

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.


    An expert that got 20 achievements.


    An expert that got 10 achievements.

  • Honda Master
  • 12,223 Answers

Go to translate the web with your browser get the topic and fix it.
God bless you

Posted on Jul 31, 2013

2 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 105 Answers

SOURCE: changed clutch on 1994 honda accord and when

sounds like you need to blead out the hydraulic clutch fluid. the resivour is located next to the brake fluid resivour drivers side corner. blead through the slave cylinder on the transmission and check for leaks

Posted on Oct 30, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How do you disconnect the clutch master cylinder from the clutch pedal

IF you look at at the clutch peddle, there is a rod coming from the clutch cylinder, that is attached to the clutch peddle arm by a pin , remove the pin, remove the line from the master cylinder, remove the bolts holding the cylinder to the fire wall, and the cylinder will be free to remove.

Jun 03, 2017 | Cars & Trucks

1 Answer

Bleeding 1995 honda accord clutch

make sure their is fluid to bleed usually when the fluid level is up you press down on the clutch fully extending it repeatedly their is a relief valve under the chassis but pumping the clutch usually works

Jul 30, 2012 | Honda Cars & Trucks

1 Answer

I need to get the clutch cable off a 1997 vw cabrio.How do i get the cable off the clutch pedal

After disconnecting the cable from the engine compartment remove the lower panel on the driver side. Press clutch peddle to floor then reach around the steering wheel column on the gas peddle side. you will feel a plastic guard. reach under guard you will feel the cable on top of clutch peddle. pull cable up and toward back of car.

Feb 13, 2011 | 1999 Volkswagen Cabrio

1 Answer

The clutch peddle went to the floor when i pushed the clutch peddle in

Check the floor by the clutch peddle if it is wet (you may need to look at the very top of the peddle)than you problem is the clutch mastercylinder

Jan 31, 2011 | 1994 Nissan Pickup

1 Answer

I pressed on the clutch peddle and it snapped to the floor. Its a 96 ford f-150, 6 cyl. 5 speed stndrd. Throw-out bearing?

check your clutch booster fluid be sure to pull the cup out if fluid is low may be bad slave cylinder

Nov 05, 2010 | 1996 Ford F150 Regular Cab

1 Answer

On my 96 accord the brake light dont work i have checked the fues and the bulbs do u have any advice and can anyone tell me how to test the brake light switch

The brake light switch is located at the break peddle..........To test you have to remove and do a resistance check.When the button on the switch is in you shouldn't get any restance but with the button out as if the brakes were applied you should...........Hope this helps you out.

Oct 12, 2010 | 1996 Honda Accord

1 Answer

I have a 96 Honda Accord that is idleing rough

could be your clutch is not fully disengauging or on its last leggs check if you can ajust the freeplay at the clutch cylinder thats if your car is a manual

Nov 11, 2009 | Honda Accord Cars & Trucks

1 Answer

Changed clutch on 1994 honda accord and when pressed down clutch peddle stay in, then also where is clutch oil located?

sounds like you need to blead out the hydraulic clutch fluid. the resivour is located next to the brake fluid resivour drivers side corner. blead through the slave cylinder on the transmission and check for leaks

Oct 29, 2009 | 1994 Honda Accord

1 Answer

There is no perssure in the clutch how do I fix

may also have air bleed clutch, or pressure spring collapsed or dislodged

Oct 28, 2009 | 1993 Honda Accord

1 Answer


Either your clutch plate is warped through a lot of work, starting/stopping/then pulling away again, or your thrust bearing is going ( to test for this, take out of gear, listen for a rumble, it may not be evident to the ear, if not then depress the clutch peddle and any rumble will noteicably dissapear).
I would bet it is a warped clutch plate u which will will require removal

May 06, 2009 | 1991 Honda Accord

Not finding what you are looking for?
1996 Honda Accord Logo

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts


Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides