Question about Ford ZX2

1 Answer

Where is the fuel rail on my food zx2? Pictures please

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.


    An expert who has answered 20 questions.

  • Contributor
  • 29 Answers

...and why does a mouse when he walks?...and what is the difference between a duck?... yes, please send pictures!!!!

Posted on Jul 31, 2013


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Leak at fuel rail on volvo 960

take a lead from your battery .then reach under the inlet manifold. remove the 10mm bolt and copper washers one each side of that bolt. that is the feed line from your fuel rail to the cold start injector .now remove each of the ten mil bolts holding on your fuel rail . now remove the clips holding the injectors to your fuel rail. place some clothes under the fuel rail and lift off . care needed due to fuel wear eye protection due to fuel pressure..

Dec 01, 2013 | 1995 Volvo 960

1 Answer

Symptoms bad fuel injector,

If your fuel injection system has a fuel rail to deliver fuel to the injectors, you will have to remove it before you can remove the injectors.
First disconnect the fuel line at the end of the fuel rail. If there is another lune at the other end remove it too. (always be careful, some of these lines are under pressure).
Remove the screws or bolts which ever is holding the rail in place, if the wiring travels over the rail disconnect it first.
With everything disconnected, pull the rail away from the injectors. Most of the rails are just pressed on to the top of the injector tops, once you've removed the screws the rail should come off easily.
If your vehicle doesn't have a fuel rail then you have to disconnect the clips to each injector. Each injector will have a clip either at the top or at the top on the side that connects to the wire harness. Most fuel injector wiring plugs are held in place by a springy wir. To remove this wire, put a flat head screwdriver between the wire spring and the clip and CAREFULLY pull it away (don't loose it).
With everything off, you are are ready to remove the injectors (it is recommended that you use an injector puller) it is important that you don't break anything or let dirt and debri fall inside of the port wholes of the engine.
With the injector puller you just slide it under the injector and pop it right out.
To put the new injectors in just do the same as removing the in reverse. Remember to be careful and don't force anything.

I hope this helps for you.
Sorry if all thre pictures don't show.

May 11, 2013 | 2006 Saturn ION

1 Answer

Replacing plugs on 2003 Escort ZX2

Instructions1 Pop the hood and locate the fuel rail on the intake manifold. Connect the fuel pressure gauge to the Schrader valve at the end. Push the manual relief valve on the gauge to relieve the fuel pressure in the system.
2 Place a drain pan underneath the center of the engine, on the driver's side by the firewall. Locate the fuel filter, which is on the firewall on the driver's side, toward the backside of the engine.
3 Disconnect the fuel lines running to and from the fuel filter using the pliers and then unbolt the filter from its mounting bracket using the 3/8-inch ratchet and socket. Remove the old fuel filter and discard it.
4 Set the replacement fuel filter in place. Make sure the arrow on the filter is pointing toward the engine and away from the gas tank. Secure it in the fuel filter bracket using the ratchet and then reinstall the fuel lines using the pliers.
5 Start the engine and make sure everything is running correctly.

Apr 02, 2012 | 2001 Ford Escort ZX2

2 Answers

Cranks for a long time to start up when it has sat for a while.suspect fuel pressure not staying in feul i have to drop tank to replace feul pump?

Check the Fuel Pressure at the fuel rail with a gauge first

Before you start replacing a fuel pump make sure
the other systems on your car are working correctly

Spark Plugs
Old Gas Filter
Old Air Filter
Dirty MAF Sensor
Old O2 Sensors
Clogged Exhaust Converter
Vacuum Leaks

Apr 24, 2011 | 2001 Ford Escort ZX2

2 Answers

My zx2 wont start.i changed the fuel pump.

maye it wasnt the fuel pump it probaly was the fuel filter

Dec 17, 2010 | 1998 Ford Escort

1 Answer

I just changed my manual transmission on my ford escort 2002 zx2. Went to start it and it turns over, but it is not getting fuel. I checked the fuel shut off, all fuses and relays and it still won't start....

on the end of the fuel rail is a vacumn operated valve that will only allow fuel through when it gets a vacumn ,is this pipe fitted ?? have you broke it whilst putting the gearbox in ,when you wiggle woggle the box to get the spigot shaft through the clutch and into the spigot beating

Nov 21, 2010 | 2002 Ford Escort

1 Answer

How to bleed the air out of the fuel system after replacing the fuel filter

you really shouldnt have to, but there is a schrader valve( looks like a bike tire valve) on the fuel rail under the hood

Nov 10, 2010 | 2001 Ford Escort ZX2

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

23 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

80417 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

5687 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides