Question about Lexus RX 300
While being jumped the lights on dash will come on but when I try to crank it over does not make any sound or noise in attempt to turnover?
Could be a dead battery, bad connection on one of the battery cables, or the starter. Have you had the battery checked or charged ?
Posted on Jul 30, 2013
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Remove 3 - 4 screws on fender cover close to side marker light. Pull fender cover out a bit for you to use your other hand to reach side marker light. By twisting on one direction and here you go the light out. Replace new bulb and replace everything on reverse order.
Posted on Aug 18, 2009
VSC means Vehicle Stability Control.
It comes on when the sensor send a signal that the vehicle is not stable on the ground.....check the wheel balancing and alignment and the air pressure of your tires too.
Rate this solution.
Posted on Aug 23, 2009
SOURCE: I have 3 codes 1) P0500
The PO125 is an indication of an engine running too cold-as if the thermostat were stuck open.For some reason it often sets with the PO1135 even when the engine runs at normal temp.A scan tool will indicate exactly how hot the engine is,don't trust the dash gauge. The PO1135 is a heater circuit fault in the bank1 sensor1 air fuel ratio sensor or oxygen sensor. Bank 1 is the REAR bank on this car...that O2 sensor is not much fun.PO500 is a vehicle speed sensor fault-does the speedo work correctly?it is located in the transmission near the back of the case. once again the scan tool will read vehicle speed and can aid in further diagnosis.
Posted on Mar 30, 2010
SOURCE: 1999 lexus rx300 check engine
Your 306 code means you have a misfire on cylender 6. That may be the cause of the po 125. Inspecdt the coil, spark plug wire, and spark plug on cylender 6. With the age of the car I would replace all 3 items. If you want know how to test all 3 I can tell you process of elimination is the way to do it. Do you know how to find cylender 6
Posted on Oct 15, 2010
Tips for a great answer:
Dec 09, 2014 | 1999 Lexus RX 300
Sep 14, 2014 | Lexus RX 300 Cars & Trucks
Aug 23, 2011 | 1999 Lexus RX 300
Jul 16, 2010 | 2000 Lexus RX 300
Apr 13, 2010 | 1999 Lexus RX 300
Jan 07, 2010 | 1999 Lexus RX 300
Nov 06, 2009 | 1999 Lexus RX 300
Jan 21, 2009 | 1999 BMW 328 Series
Jan 05, 2009 | 1999 Lexus RX 300
131 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: