Question about Cars & Trucks

Open Question

My vw polo 1.2 2003 has a high idle speed problem

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

SOURCE: VW POLO EMISSIONS FAILED

YOU COULD TRY SOME FUEL SYSTEM CLEANER TO CLEAN ALL THE CARBON DEPOSITS OR U MAY NEED TO REPLACE LAMBADA SENSOR OR YOUR CATALYST

Posted on Sep 19, 2008

Ad
  • 1 Answer

SOURCE: Where is the blower located in a VW 1996 Polo - stopped working!

the blower is in a vertical position under the passenger side dash far left. just twist to unluck and pull out

Posted on Feb 21, 2009

  • 1 Answer

SOURCE: VW Polo Classic 1997 IDLE Problems

Hello, VW polos 1.0, 1.4. 1.6, suffer from carbon bulid up in the throttle bodys causing bad idling, esp the Bosch Mono-Motronic (Throttle Body Injection systems), a good clean with carb cleaner should repair the problem, also engine temp sensor replacement and idle speed control valve replacement can help idle problems.

Posted on Apr 19, 2009

smhb1
  • 146 Answers

SOURCE: crankshaft sensor for vw polo where is the

Crankshaft sensor is located on the right side of the cylinder block behind or under the starter. It is fitted into the rear crankshaft oil seal hausing

Posted on Sep 12, 2010

  • 1 Answer

SOURCE: vw polo 1 litre has idling problems it keeps revin...

im also havin a problm with 99 polo 1.6 it revs high low high low and if da tank is below 1/4 it dies of while driving iv changed tank unit,trottle body, sensor nd after i changd tank unit da foat reads opsite way sum1 plz help me

Posted on Feb 18, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Vw polo erratic idle


Most likely a vacuum leak. Are there no stored faults?

Mar 25, 2014 | 2006 Volkswagen Polo 1.9

1 Answer

Where is the idle speed control valve on vw polo 1998 classic located


There is no idle speed control vale if it is Bosch mono motronic. idle speed is controlled by throttle actuator, ( electric motor) that is on the left hand side of the throttle body.

Jan 09, 2013 | 1987 Volkswagen Jetta

2 Answers

Vw polo heater blower only works on full power


all speeds go through the resistor except high that is why it will work on high you are bypassing the resistor if you are sure the resistor is good it has to be the blower spped switch on the dash

Sep 24, 2012 | 2004 Volkswagen Polo 1.4

1 Answer

Replace throttle sensor on a 1999 Toyota Avalon


throttle body not always the problem i had a vw polo did exactley the same in the end it was the ignition leads that was causing it replaced with new never did it again

Aug 25, 2012 | Cars & Trucks

1 Answer

P1581 code can not preform basic idle on a vw polo 2003 how can we fix this problem


P1581 Idle Speed Contr.Throttle Pos. Basic Setting Not Carried Out,i suspect that this is a dealer only software job or a fault on the ECU which i have had before and the dealer wanted to fit a new one so i fitted a unit from scrapyard complete with transponder and chip for the donor vehicle key

May 02, 2011 | Volkswagen Polo Cars & Trucks

2 Answers

Vw polo 1 litre has idling problems it keeps reving to around 800 rpm then droping to around 400/500 all the time engine being cold or warm makes no difference. It's a w reg with 50000 miles


im also havin a problm with 99 polo 1.6 it revs high low high low and if da tank is below 1/4 it dies of while driving iv changed tank unit,trottle body, sensor nd after i changd tank unit da foat reads opsite way sum1 plz help me

May 20, 2010 | Cars & Trucks

4 Answers

My vw polo keeps cutting out. when it slows down


try cleaning your battery terminals and tightening them. if that doesnt solve the problem your battery or alternator may be dying, some auto parts stores will do a charging system check for free that will tell you if one or the other is bad.

Feb 08, 2010 | 2006 Volkswagen Jetta

1 Answer

54 plate 1.2 vw polo juddering when idle


100% sure it shows one of your cylinder compression is weak, please do a compression test to isolate the problem and get the head/pistons checked . This is a known problem with VW/Skoda 1.2 3 cylinder mills..

Apr 27, 2009 | 2002 Volkswagen Golf

1 Answer

Where is the blower located in a VW 1996 Polo - stopped working!


the blower is in a vertical position under the passenger side dash far left. just twist to unluck and pull out

Jan 03, 2009 | 2001 Volkswagen Golf

6 Answers

VW Polo Classic 1997 IDLE Problems


Hello, VW polos 1.0, 1.4. 1.6, suffer from carbon bulid up in the throttle bodys causing bad idling, esp the Bosch Mono-Motronic (Throttle Body Injection systems), a good clean with carb cleaner should repair the problem, also engine temp sensor replacement and idle speed control valve replacement can help idle problems.

Sep 02, 2008 | 1987 Volkswagen Jetta

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

47 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...