Question about 2005 Chrysler PT Cruiser

1 Answer

How to replace the O2 sensor in a 2005 PT Cruiser?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 52 Answers

Your upstream o2 sensor is located behind motor and manifold and need an o2 senor socket and racket plus extension to remove and then your downstream 02 sensor is on the side of Cat convertor (drive side)and same process to remove and replace

Posted on Oct 09, 2013

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 615 Answers

SOURCE: '05 PT Cruiser O2 sensor problems.

I had a similar problem with my car. It turned out the O2 sensors were fine and the issue was a leak in the throttle body causing the engine to run lean. If you have an ODB2 scanner you can look at fuel trims, etc and will be able to tell.

Posted on Mar 28, 2010

66 chrgr
  • 1011 Answers

SOURCE: where is the crank sensor located on 2005 chrysler pt cruiser?

the crank sensor is located on back right side of engine by were the trans. bolts up.is the no start when could or hot?

Posted on Jan 25, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Upstreram o2 sensor 2001 pt cruiser


its the o2 sensor behind motor on top of exhaust manifold. very easy to get to.

Jun 21, 2014 | 2001 Chrysler PT Cruiser

1 Answer

Check Engine light on and off - P0031 and P0037


the sensor heater circuits have to be diagnosed; you probably didn't need to replace them.

Mar 14, 2013 | 2005 Chrysler PT Cruiser

1 Answer

2005 PT Cruiser showing P0456 and P0522. Cranks but wont start.


The sensor that is most likely causeing the problem is the low oil pressure sensor. It is telling the cpu that you have a problem that unless you correct it, the motor will suffer serious damage from insufficient lubrication.Have the oil pressure checked with a manual gauge then replace the sensor unit if faulty.

Feb 23, 2013 | 2005 Chrysler PT Cruiser

1 Answer

What is the cost to replace the 02 sensor on my 2006 pt cruiser?


O2 sensor is not bad cost wise. If there is a hole just patch it. Tis would be the cheapest fix. They sell muffler repair kits at auto parts stores.

Aug 18, 2012 | 2006 Chrysler PT Cruiser

1 Answer

2005 PT Cruiser fuel gauge is wrong suddenly. Put gas in and still shows empty


2005 PT cruiser, i replaced the cam sensor with a aft market sensor my fuel gauge started reading wrong, and it didn't fix my problem so i replaced the cam sensor with a factory sensor it fix my running problem but the fuel gauge still reads wrong, with a full tank of gas the gauge reads 3/4 tank,

Feb 28, 2011 | Chrysler PT Cruiser Cars & Trucks

1 Answer

How do I replace a 2005 pt cruiser camshaft sensor


Camshaft sensor sit in the end of the cylinder head, drives side, just unscrew both little bolt's from sensor, remove sensor, and install new cam sensor, no reprogramming needs to be done.

Sep 09, 2010 | 2005 Chrysler PT Cruiser

1 Answer

'05 PT Cruiser O2 sensor problems.


I had a similar problem with my car. It turned out the O2 sensors were fine and the issue was a leak in the throttle body causing the engine to run lean. If you have an ODB2 scanner you can look at fuel trims, etc and will be able to tell.

Mar 28, 2010 | 2005 Chrysler PT Cruiser

2 Answers

2005 Pt Cruiser idles rough at stop lights/ poor gas mileage.


i hav a 2003 pt cruiser 2.2 crd touring it wont go over 3000 revs engine light cums on. error code p0243 i hav replaced wastegate solenoids cleaned egr valve cud it be the mass air flow sensor that has a problem thanx

Sep 18, 2009 | 2005 Chrysler PT Cruiser

1 Answer

Where is the crank sensor located on 2005 chrysler pt cruiser?


the crank sensor is located on back right side of engine by were the trans. bolts up.is the no start when could or hot?

Dec 13, 2008 | 2005 Chrysler PT Cruiser

Not finding what you are looking for?
2005 Chrysler PT Cruiser Logo

312 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...