Cars & Trucks Logo

Related Topics:

Posted on Jul 30, 2013

My car is starting but not running, just stalls rite out. We changed fuel filter & pump has pressure. I was going to check fuses and noticed passenger floor board is soaking wet. What could this be.

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

  • Contributor 3 Answers
  • Posted on Jul 30, 2013
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Joined: Jul 30, 2013
Answers
3
Questions
2
Helped
85
Points
9

Check your spark plugs , wires , fuel filter ,and the get back to me

5 Related Answers

Anonymous

  • 623 Answers
  • Posted on Aug 16, 2008

SOURCE: Fuelpump problem 2000 Suburu outback

check fuel lines for leaks...
good luck

Ad

Anonymous

  • 408 Answers
  • Posted on May 19, 2009

SOURCE: STALLING PROBLEM TURNED INTO NO START 1990 MB 300 SL

hello,good day,first we are in fuel side,better to install a fuel gauge,to determine the right pressure, is not mention your fuel pump relay,this should also check,some occasion the power supply is missing,now if all is in order (fuel side) then your switching unit(transistor box) need tobe check,assuming your engine is 103 engine,ty

dennymulford

Dennis Mulford

  • 1055 Answers
  • Posted on Jun 06, 2009

SOURCE: 1998 GMC Sierra- runs rough then stalls when

had this problem on my neighbors 98 chevy truck with the same engine !!
it turnd out too be the fuel pressure regulator,you have too pull the upper intake too replace it!!

Anonymous

  • 69 Answers
  • Posted on Jul 06, 2009

SOURCE: 00 Cavalier won't stay running.

need to have it scanned to see what codes it has but sounds like a security system problem factory or add on if key has chip in it security prob very likely.hope i helped

Anonymous

  • 35 Answers
  • Posted on Jul 19, 2009

SOURCE: '87 300ZX(NON-TURBO) STALLS OUT/BOOGS DOWN

overhaul of carb needed, check the vaccum advancer for wear n tear, rapace f necessary fo

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Changing fuel filter how do I release the fuel pressure can I unplug the fuel pump I have easy access to it

Just take out the fuel pump fuse, then run engine until it stalls. That's about the same as disconnecting the fuel pump and run engine until it stalls. Just disconnecting the pump will not relieve pressure, as there is a check valve at the pump which holds pressure in the line.
When engine stalls, there will still be some fuel in the line, maybe with a small amount of pressure, so use a rag to catch the fuel spill when you take line off at the filter.
0helpful
1answer

My santa fe start and run 3 sec after stall but if i put it at 1500 rpm it always run. when stallihng its like i put the ignition off no esitation and i crank and run all the time but stall

suspect the fuel filter. if you replaced the fuel filter & still stall, use fuel pressure gauge to check the fuel system. (could be bad fuel pressure regulator or fuel pump.)
0helpful
1answer

Ford windstar stalling problems

possible pump but could be a problem pressure regulator
good pressure is 45-65 psi
0helpful
1answer
0helpful
2answers

No fuel up to injecter pump truck just stalled

Did you check for fuel pressure on the line from the tank while you had the filter off? Do you hear your fuel pump prime when you turn the ignition on? First I would listen for the hum of the fuel pump when you turn the key to the run position (not starting the engine) May have to get a helper and listen at the gas filler neck with the cap off. If you dont hear your fuel pump, check your fuses and relays. If the relay clicks when your helper turns the key on ( put your finger on the relay and ear down close to feel/hear the relay actuate)., and fuse is good, yet you do not hear the pump prime, I would say your fuel pump is shot.

If it is a diesel,check for fuel pressure coming off the direct drive pump hose while cranking the motor.

Mike
0helpful
2answers

Vehicle will start but then quickly stalls (within 5 to 10 secs). Fuel pump or fuel filter or?

I would start with the smallest and cheapest first, try replacing the fuel filter ensure it is placed in the direction of fuel flow, then see if that helps out before moving onto the pump.

Feedback appreciated.
0helpful
1answer

My automatic car acts like it is going to stall

Definitely sounds like a fuel problem. I'd change fuel filter and check fuel pump. If pump is running it could still be partially clogged. Try a fuel rail pressure test with a knowledgeable mechanic.
1helpful
1answer

2001 chevy venture stalled out and wont start up anymore

CHECK FUEL PUMP FUSE AND RELAY.IF ALL IS GOOD.CHECK FUEL PUMP PRESSURE.IF YOU GET NO PRESSURE OR LITTLE PRESSURE.CHANGE FUEL FILTER.IF NO CHANGE FUEL PUMP BAD OR YOU HAVE A RESTRICTED FUEL LINE.
1helpful
1answer

Key in ignition to on. Gauges fuel and temperature don't respond. All other electrical accessories do. Lights OK. Motor starts and stalls Vehicle is a 1996 Dodge Gran Caravan 3.8

CHECK THE DASH FUSE.IF ALL IS GOOD.YOU GOT A LOOSE GROUND WIRE OR A FAULTY DASH.BUT YOUR CAR STALLING COULD BE FUEL PROBLEMS.CHANGE FUEL FILTER AND CHECK FUEL PRESSURE.IT SHOULD BE 49 PSI.MAKE SURE YOU HEAR FUEL PUMP RUNNING WHEN YOU TURN ON IGNITION SWITCH.IF NOT.CHECK FUSE AND RELAY.IF THEY BOTH ARE OK.FUEL PUMP IS FAULTY.
Not finding what you are looking for?

54 views

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...