Question about GMC Sonoma

1 Answer

I drove up into my drive way, popped the hood to check if my air filter was dirty. And now it will not start. It started up fine earlier. I checked my air filter and correctly put all the bolts back to where they were supposed to be. All it does now is a fast click when I try to start it....

Posted by on

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 16 Answers

I know it sounds weird but check if you disconnected and wires that you didnt mean to

Posted on Dec 05, 2013

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

fknstart
  • 404 Answers

SOURCE: hi my 1993 chysler lebaron

if it keeps happening ge it checked ,try driving on a rough road to see if its a loose wire

Posted on Jan 06, 2009

  • 7 Answers

SOURCE: how can i reset {turn off} the check engine light?

Remove front drivers side tire. Battery is behind plastic inner fender towards front. pop the plastic clips remove inner fender plastic to get access to battery. carefully remove both battery terminals and leave set about20 min. put back on and start car before reassembling inner fender. light should be out.

Posted on Apr 21, 2009

SOURCE: 1.8t engine stumbles when under load.

Have it scanned with a scan tool, check the gap on the plug or see if the righr plugs where used.

Posted on Jul 19, 2009

  • 11122 Answers

SOURCE: I have a 1999 chevy express 1500 van with 5.7L

check fuel pump[operation-pressure] if good recheck pressure on fuel rail by distributor[access valve ] for pressure after filter if good than check pressure regulator may have debris or needs replacement

Posted on Jun 08, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What makes a engine sputter and quit and then not start? Plenty of gas. Just changed gas filter.


Did you check for OBD Codes?

Did you have a shop drive it with scanner,
& see if all the Emission Monitors have run?

Ever do any Preventative Maintenance, or just
drive your vehicles until you have problems !

Did you check for fuel pressure at the motor & spark ?

Battery Dead or worn out !

No one can guess at your vehicle issues-- without it-- to
do some testing,always been that way

Sep 21, 2014 | 2006 Mazda Tribute

1 Answer

After i filled my 2004 hyundai xg350 last nite and parked for half hour then drove hime ,it stalled ,but rstrated right away,but kind of jerked a little bit, when applying gas. after that i drove home...


Hello,
Absolutely, a dirty fuel filter could cause that. You may also check your air filter, a dirty air filter can cause a bad fuel/air mix ratio, which can have similar results to a dirty fuel filter.

I hope this helps you.

Feb 02, 2011 | 2004 Hyundai XG350

1 Answer

Car tach jumps and cover of air filter blew off.


It sounds like the engine "backfired" and blew the cover off. This and having the tach "jumping" means that the engine timing is erratic. This can be caused by the crankshaft position sensor or the ignition module. It could also be cross firing at the coil pack,if so equipped. Make sure all of the wiring to these components is good.

May 24, 2009 | 2002 Jeep Grand Cherokee

1 Answer

Truck doesnt start


dip your tank with a wire. if quarter tank indeed fuelpump or safety valve not opening in supply under hood. Check connection. Valve is on all modern cars for fire hazard. Check the valve by takening it out and testing it. Could be wire harnes problem also. Or filter blocked.

Apr 16, 2009 | 1998 Chevrolet S-10 Pickup

3 Answers

No power, jerking bad 1998 cavalier


Possible dirty fuel filter. I'd start there first, as it's the cheapest route, and quite possibly replacing the filter will solve your problem.

Dec 16, 2008 | 1998 Chevrolet Cavalier

3 Answers

2003 focus engine died.


have you checked your fuel filter, and air filter?

Sep 07, 2008 | 2003 Ford Focus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...