Question about Cars & Trucks

Open Question

Pt cruiser not ready can't pass emissions test

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 104 Answers

SOURCE: wont complete scan to pass emission test

When you rest your codes there is a series of tests your ECU has to go through before you can pass emissions. this is done some people can reset the code and go before its sets the code again. on the 96 you can have 2 tests not complete for it to pass. basicly you have to drive the car a couple days for the tests to pass.

check the readiness tests wait until only 2 have not passed. then you should be good.so drive and check.

Michael
ASE certified
PLZ rate.

Posted on Feb 09, 2009

Ad
  • 8 Answers

SOURCE: 1996 doge intrepid wont pass emission test because IM monitors ar

Just maybe your O2 sensors are not operating properly. They may be requiring your engine to heat them up to get upper temperature readings but not lower. You can easily diagnose these and all other sensors and problems by purchasing a Hains manual at your local Auto Zone or Advance auto store which will greatly aide you in diagnosing all your auto needs. And the fault symptom index at the beginning of the book will ease your troubles with professional one on one advice with step by step instructions. Its like having your own ASE certified mechanic at your finger tips. Good luck.

Posted on Mar 05, 2009

  • 139 Answers

SOURCE: cannot pass inspection. emissions.

go to a place like autozone or pepboy autoparts
tey will the code retriver myth have a factory code
that service is free,if they are code they will explane
wath next

Posted on Apr 20, 2009

  • 69 Answers

SOURCE: emissions test comes up not ready - can't pass inspection

Under the hood, there is a fuse block. I believe it is on the driver's side of your vehicle. Open that box, and pull the "ECU" fuse. Leave the fuse out for at least 5 minutes. Put the fuse back in, start the car, and let it idle for at least another 5 minutes. Do not drive the car, touch the gas, or even look at the gas pedal for these 5 minutes, as the ECU is remapping itself. This will properly reset the ecu and clear the codes. After this you may drive the car.

Posted on May 28, 2009

  • 1 Answer

SOURCE: OBII readness "not ready"

what kind of car is it
some cars montier take
a while to get ready
try driving on the freeway, if it's doesn't get ready
then try driving in the city, some montier get ready
if the car is driven in the city stop and go

Posted on Jul 30, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 pt has a new alt that test ok but wont charge


2005 pt ???? pt cruiser ? Probably the transistor inside the PCM - engine computer that controls it !
How to test an alternator Chrysler Dodge Jeep

They sell a by-pass kit , external regulator .

May 20, 2017 | Cars & Trucks

1 Answer

2007 pt cruiser alarm goes off in cold weather


Batteries voltage fluctuates with temperature. Your battery could be discharging due to the cold to the point where the alarm doesn't see enough power to be on and ready, like in standby mode. I'd recommend getting your battery tested. You may need to charge or replace it.

Feb 20, 2015 | 2007 Chrysler PT Cruiser Touring Hatchback

2 Answers

Engine Check light


Take it to autozone or another place like it and have them read the codes and tell us what they are.

Jun 19, 2013 | 2011 Jeep Wrangler Sport

1 Answer

2004 PT Cruiser Turbo won't pass smog test because computer monitors haven't completely reset after battery failure. It's been driven 235 miles and only 2 monitors remain unset (oxygen and


The system has to see a wide range of conditions before a smog test can be done. On most brands you have to drive at least 50 miles, at various speeds including stop and go, let it idle for 5 - 10 minutes, and run at freeway speed for at least 25 miles. It also has to reach normal operating temp of 195 degrees.

Apr 22, 2013 | 2004 Chrysler PT Cruiser

1 Answer

Wont pass smog due to malfuntion indicator light on a pt cruiser 2005 everything pass but failed this what can we do to fix it


YOU NEED TO HAVE VECHICLE CODE SCAN FOR FREE AT ANY AUTO PARTS STORE THEY WILL GIVE YOU THE CODE THAT CAUSING CHECK ENGINE LIGHT TO FLASH.ITS MORE LIKELY EVAP LEAK THAT WILL CAUSE YOU TO FAIL SMOG TEST.

Sep 12, 2011 | 2005 Chrysler PT Cruiser

1 Answer

What does it mean when the emissions light comes on in your instrument panel? the emissions light came on tonight while driving home I checked my gas cap to make sure it was closed tight and made sure that...


It could be emission related- the gas cap may be on tight but how about when you filled up before?And the cap can actually be bad - meaning it allows to much fuel vapour to escape. Your cap actually has to pass a pressure test during a drive-clean inspection. If your not due for a e-test then you may remove the gas cap and bring it to a drive-clean facility for a pressure test, usually it`s a no cost.If your cap passes then the problem can be related to your emission system on your car which consists of valves, solenoids and plastic vapour lines. Your auto repair shop can diagnose this for you. Either way you are not in any danger if you continue to drive your car.

Feb 18, 2011 | 2005 Chrysler PT Cruiser

1 Answer

What are the typical symptoms of a bad egr valve on a pt cruiser?


A vacuum leak at the egr valve can cause rough idle and almost stalling condition.

A non functioning egr valve that is plugged up won't affect driveability, but NOx will be in the exhaust at normal operating temperature which may not be good for an emissions test if they test for that in your area.

Good luck on this repair.

Nov 20, 2010 | 2003 Chrysler PT Cruiser

1 Answer

2005 Convertible PT Criser, Turbo


Emission devices in vehicles sold in the US are covered for 8 years. This is federal law. Talk to the service manager at your local dealer. A misfire will cause emissions to go up so it should be covered.

Mar 05, 2010 | 2005 Chrysler PT Cruiser

1 Answer

Did not pass state inspection (vehicle)


First the fault codes,
U110C is No Fuel Level Bus Message
U0155 is No Cluster Bus Message.
Unfortunatly you have to be able to communicate with the instrument cluster with your scanner to diagnoise and I do not think an aftermarket scanner can do this.




Mar 02, 2010 | 2005 Chrysler PT Cruiser

1 Answer

Wont complete scan to pass emission test


When you rest your codes there is a series of tests your ECU has to go through before you can pass emissions. this is done some people can reset the code and go before its sets the code again. on the 96 you can have 2 tests not complete for it to pass. basicly you have to drive the car a couple days for the tests to pass.

check the readiness tests wait until only 2 have not passed. then you should be good.so drive and check.

Michael
ASE certified
PLZ rate.

Feb 09, 2009 | 1996 Chevrolet Blazer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...