Question about 2002 Ford Crown Victoria

1 Answer

I HAVE AN '02 CROWN VIC, VEHICLE SHAKES AROUND 60 MPH AND UP, WORSE WHEN GOING UP HILLS, CHECK ENGINE LIGHT IS NOT ON, CHARGING SYSTEM GAUGE IS CHARGING BUT NOT TO PAR

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Night Owl:

    An expert who has answered 10 or more questions between 12 midnight and 6am on the same day.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 130 Answers

Check your vehicle's suspension and uneven or
wear out tires.
That may be the cause of the problem.

Posted on Dec 04, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

michigan man
  • 3533 Answers

SOURCE: vehicle shaking like it is missing real bad

when was the last tune up done and fuel filter was changed?
there is no spark plug wires I had to replace the boot for the number one cylinder on a 2000 expedition that was also having the same problem if the check engine light is on take it to auto zone and they will put it on a tester free of charge and I hope and pray that it is not the problem like the one I am working on right now I am replacing the upper and lower intake gaskets

Posted on Jan 12, 2009

  • 1 Answer

SOURCE: Whole truck sputters shakes when going up a hill

on our 1997 it was a misfire and one of the ignition coils needed replaced.

Posted on Jan 17, 2009

  • 114 Answers

SOURCE: shakes at 60 mphexplorer xlt

Tires would be the 1st place to check. If you seem to feel it more in your legs then it is likely the front, if felt more in seat bottom then could be a rear tire. Depending on how severe the vibration is there could be a tire developing a tread seperation and should be checked right away. A simple balance of the tire and wheel assemblies may be all that required also but when on a balancer they should be able to tell if the tire has a more severe problem.
Driveline components could cause vibrations also however if the above sounds like it fits then check that 1st.

Posted on Mar 23, 2009

  • 2 Answers

SOURCE: 1988 Ford Crown Vic Strange Idle (Getting Worse)

i am trying to install an aftermarket temperature guage with capillary tube into my 1988 crown victoria ltd 5.0 efi. where does the capillary tube mount?

Posted on Oct 06, 2009

dttech
  • 4803 Answers

SOURCE: my overdrive light is flashing

If your overdrive light is flashing, it is trying to tell you that there is a transmission failure. You will have to scan your powertrain control module to find out what is wrong.

Posted on Feb 20, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Stalling


first scan for engine code.Codes P0600, P2105, P2107.
throttle body is common problem with ford
second connect fuel pressure gauge and drive
General Specifications
Item Specification Fuel tank capacity 71.9L (19 gal) Fuel Pressure Hot restart 448-482 kPa (65-70 psi) Key ON Engine OFF (KOEO) 140-415 kPa (20-60 psi) Key ON Engine Running (KOER) 170-280 kPa (25-40 psi)

Mar 23, 2014 | 2006 Ford Crown Victoria

1 Answer

2002 chevy s10 temperature gauge jumping around, feels like automatic transmission slipping at speeds above 60 mph


Do you have an OBDII scanner to check the real temperature? Want to make sure it's not overheating. If it's normal, could be your temperature sensor starting to go out, or ignition switch. Any check engine lights? If so, get the code for me, can go from there. At a constant speed, you sure it wasn't a misfire instead? Check your trans fluid, make sure it's full. I was just in Tahoe, pretty sad not much snow at all.

Feb 04, 2014 | Chevrolet S 10 Cars & Trucks

1 Answer

AC compressor went out on 02 crown vic, car got hot. Replaced compressor, but now the coolant temp gauge does not register on dash.


Can you tell if the engine is warming up normally ? Do you know for a fact the cooling system is full ? The compressor should not have had any effect on the cooling system other than maybe the drive belt which runs the water pump.

Jan 18, 2014 | Ford Crown Victoria Cars & Trucks

1 Answer

Mi pick up shakes goin around 60 mph.


can you give more information. Shakes only around 60 mph? does it stop when going faster? any noise? is it a vibration you are feeling? is it felt in the steering wheel or throughout the vehicle? any info may help solve your problem

Oct 23, 2013 | Cars & Trucks

2 Answers

I have a 96 crown vic intercepter that is hesitating when i push on the gas.also the check engine light is flashing


When the check engine light is flashing, it means that the system has detected a misfire condition that can cause damage to the catalytic converter if not repaired. Try to drive the vehicle as little as possible until the problem can be addressed. Look for bad coil pack or shorted injector or driver

May 18, 2011 | 1996 Ford Crown Victoria

1 Answer

07 lexus rx 350 with check engine light code p0304


Hi, did you ever get an answer? I have the same issue. Thanks.

Mar 23, 2010 | 2007 Lexus RX 350 FWD

1 Answer

1988 Ford Crown Vic Strange Idle (Getting Worse)


i am trying to install an aftermarket temperature guage with capillary tube into my 1988 crown victoria ltd 5.0 efi. where does the capillary tube mount?

Jun 27, 2009 | 1988 Ford Crown Victoria

1 Answer

Check engine light flashing


if it shaking it could be suspension. tires bent axel and rim. but that wouldnt cause to lose power...
fuel air spark ratio isnt right. that is just what it sounds like.
ignition time could be off.
in proper fuel adjestment in the carb/ or if fuel injected..
thats a breif idea of what i got from it..

May 29, 2009 | 2002 Chevrolet Express

1 Answer

Engine cuts out , does not throw a code


I also have a 2001 Crown Vic that developed a problem similar to this. It would lope and buck at around 40-45 MPH. I too changed the plugs, then changed the coil boots. It still missed. So I bought 1ea. new coil. After changing the new coil with three old ones, the missing stopped.

Jun 05, 2008 | 2001 Ford Crown Victoria

Not finding what you are looking for?
2002 Ford Crown Victoria Logo

105 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...