Question about Cars & Trucks

Open Question

Drivers seat won't do anything has a code b3920 2007 srx cadillac '

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 3 Answers

SOURCE: Replacing front turn signal bulb on 2006 Cadillac SRX

wow i feel sorry for you because Cadillac designed this bulb to be a don't get to bulb but OK here's what you do take the bottom cover off or skid plastic panel under neath the front end theirs little plastic clips holding it on just get come dikes and don't cut them but just use it to help pull them out. after you get that off use a flash light and locate your light housing you should see two screws holding the house in i think those screws are 8mm i cant remember remove those two screws and be careful the metal from the bumper cuts you pull the light housing out and remove all the screws around the housing and open the housing up replace the bulb and make sure your contact to the bulbs clean and then reassemble the way you took apart. if you cant get it well then best bet is take it somewhere i know Cadillac charges an arm and a leg so you can go somewhere else.

Posted on Jan 25, 2009

Ad
techbuster
  • 5081 Answers

SOURCE: rear liscese plate bulbs on 05 cadillac srx

First you have to take out the one and only screw in the rear hatch door - it's where the hand pull down is you use to close the hatch.
Then you have to pop all the plastic clips all the way around the plastic door panel, trying not to pull them out from the frame . If you do pull out the white plastic plugs from the frame you better make certain you take them off the plastic housing and insert them back into their frame holes - or you will never get the housing back on.

Once you have the housing loose disconnect the inside tail gate light wire to remove the whole thing. Then you have to remove 7 to 8 nuts from the back of entire License plate, back up bulb housing using a deep socket to get in there. Work it loose from the rear of the car and it will come out just enough to work on the lights.
This is tricky since the screw mounts don't give you much room to work with.

Once you have the license plate and back up bulb frame loose you will see the two housings for the license plate bulbs on top.

Slide out the license plate bulb lens and twist the bulb connection to remove the bulbs.
Replace both of them - you don't want to do this again in a month when the other one blows.

OPTIONAL:
Once you take out the bulbs you might see that the housing is melted where the bulb wanted to burn through. Drill two small holes one is each end of the housing before I put everything back together to release some of the heat.


Reverse the whole process to put everything back together. It's not easy.
Make sure you insert the cables through the opening for the hatch handle or it will kink and not work properly.

The bulbs come in a two pack of cost $4.95 .

Posted on Nov 24, 2009

  • 396 Answers

SOURCE: Wiring diagram for 2009 Cadillac SRX

Try your dealer parts counter.

Posted on Jan 16, 2010

  • 59 Answers

SOURCE: the front drivers seat eletric

Thre's three motors or more that move your seat the one that controls foward/back went bad or harness under seat came apart.

Posted on Mar 17, 2010

  • 8 Answers

SOURCE: How do access the fuse

Usually there are clips where the seat meets the floor at the front of the seat. You have to push very hard then lift to release the seat from the clip. There are usually two clips. It is hard to get the seat to release and equally as hard to get back in. Good Luck

Posted on Dec 31, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the gas tank on a 2006 srx cadillac


Take a look at this video on changing the filter on an STS. Looks to be under the back seat. Follow the pipes from the filter.

Replacing fuel filter in just few minutes on Cadillac STS Cadillac SRX...

Jan 05, 2016 | Cadillac Cars & Trucks

1 Answer

Remove center seat belt in second row 2005 Cadillac srx


Remove the rear lower seat. Remove bolts holding belts to floor pan of vehicle.

Mar 06, 2015 | 2005 Cadillac SRX

1 Answer

How do I lower the backseats in my 2005 Cadillac SRX so they lay flat


Could be a switch under or around the trimming of the seat. if you cant figure it out take it to the dealer they will be happy to help you.

Sep 21, 2014 | 2005 Cadillac SRX

1 Answer

My 2010 Cadillac SRX trunk won't open with the doors unlock from inside the car, from the remote and from the touch pad button under the license plate. Please someone let me know if they know the


sounds like a fuse is bad for that circuit..check and replace if bad..in an emergency to gain acess to the trunk, remove the back seat by taking the base out first then the back of it..remove the noisebarrier(fiberboard or batting) and the trunk is accessible by a smaller person who can trip the lock from inside manually..good luck and reposr please..

Jan 17, 2013 | 2010 Cadillac SRX

1 Answer

How do access the fuse boxes under the back seat in a 2007 cadillac srx?


Usually there are clips where the seat meets the floor at the front of the seat. You have to push very hard then lift to release the seat from the clip. There are usually two clips. It is hard to get the seat to release and equally as hard to get back in. Good Luck

Dec 31, 2010 | 2007 Cadillac SRX

1 Answer

2007 Cadillac SRX Heated Seat Gets Too Hot on on Side. When the Seat heater is turned on, it gets way to hot and starts to burn the left leg. Is There anything that can be done, perhaps a regulator or...


evidently cadillac does not have a 5/50k warranty like many other cars, yet folks continue to buy them.
i would take it to a dealer and have them check the thermostat for the seat, it has to have a circuit to turn it off to keep it from burning up and that system also controls the temperature, like in the electric blanket and toaster in your house. this is a dealer thing.

Dec 12, 2010 | 2007 Cadillac SRX

1 Answer

The front drivers seat eletric is stuck in the forward position all other buttons work on the seat except to move it back 2006 srx 3.6l


Thre's three motors or more that move your seat the one that controls foward/back went bad or harness under seat came apart.

Mar 16, 2010 | 2006 Cadillac SRX

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

81 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...