Question about 2003 Toyota 4Runner

1 Answer

Why won't my truck go accellerate over 60 mph

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Toyota Master
  • 12,223 Answers

You must make a TUNE UP +and RUn the scanner/computer . you can have some part faulty like: ignition coil+pcm+bcm+sparkplug+wires for sparkplug+sensor(s),etc see the diagram attached. The electronic vehicle right now is very complicated.
God bless youWhy won't my truck go accellerate over 60 mph - 58340ec4-e167-4151-8160-639de452b148.jpg

Posted on Jul 30, 2013

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Trans won't shift only manually 6 cyl also won't go over 40 mph. 2002 hyundai santa fe


this sounds like a timing belt problem.
http://www.youtube.com/watch?v=nyB6syDyP0o
This is what could happen if not replaced.

Mar 07, 2013 | 2001 Hyundai Santa Fe

1 Answer

2006 Crown Victoria won't go over 40 mph


What have you checked so far ?
Fuel pressure ?
Exhaust restrictions ?

Jan 31, 2013 | 2006 Ford Crown Victoria

1 Answer

Won't shift into overdrive


Should be in overdrive & converter locked
at 42mph or about-- unless your flooring the gas

Internal Solenoid Problem or Valve Body Dirty

Jan 23, 2013 | 1991 Mercury Cougar

1 Answer

Engine cranks but car won't start and the rotor doesn't move


Pull the distributor out. Probably the gear on the bottom has broken away from the distributor shaft.

Jun 28, 2012 | Cars & Trucks

1 Answer

Engine stalls at 30mph upon hitting accellerator, then coasts to a stop. then won't restart. starter works, engine turns over, but won't fire up. next morning car starts fine. next week...


you may have to check the fuel pump function for pressure and volume when this happens as it could be a bad pump,you could have it checked when working as it could show up something but more likely should be done when it stops running.

May 19, 2011 | Ford Crown Victoria Cars & Trucks

1 Answer

Shift problems with 94 eldorado touring coupe


I'd check & lube all kickdown cables in the area of the throttle body, as well as follow any to transmission and lubricate well there too. It almost sounds like something may be seized and holding into lower gear.

Aug 19, 2009 | 1994 Cadillac Eldorado

1 Answer

Car accelerates without pressing gas pedal


I had a similar problem with a K5 Blazer, where the gas pedal had a plastic pivot point in the linkage. After about 60K miles, the pivot developed a burr that locked the gas pedal open and kept the vehicle about 60 MPH. If I kicked the pedal to knock it off the burr, it would then slow down. Try it...

Feb 24, 2009 | 2001 Buick Regal

Not finding what you are looking for?
2003 Toyota 4Runner Logo

145 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8729 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...