Question about 1997 Acura RL

Open Question

Reset srs light after fitting new battery - 1997 Acura RL

Posted by on

  • Renee Kazempour
    Renee Kazempour Nov 13, 2014

    Hi Michael Martin, I want to help you with your question, but I need more information from you. Can you please add details in the comment box? Did this happen, or you want to reset it? I am not really sure what you mean by this.

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Reset srs light after replacing seatbelt


To reset the SRS light on an Acura Integra, pull down the SRS service connector. Unplug this connector so you have access to jump the harness. Start with the ignition OFF. Jump the SRS plug. Turn the ignition ON. The SRS light will come on then off.------------------------------------------------------------------------------
autel maxidas ds708

Jan 14, 2013 | 2007 Ford Explorer Sport Trac

1 Answer

Srs lite on after new turn signal switch installed


same as mine needs reseting did you disconect the battery if not it will show as a fault i forgot to disconect mine and the srs light is on all the time can buy a reset tool from ebay for less than taking it to garage and getting them to do it hope this helps

Aug 24, 2012 | 2000 Volvo S80

1 Answer

How to rest srs light


Hi.

If the SRS light is on it means that a problem with the SRS has been detected and an error code has been stored in the relevant computer modules. If there is no fault the SRS light will go off after disconnecting battery terminals for five minutes (make sure you have stereo code if needed). Most of the times the light cannot be reset unless the fault causing the problem is fied (e.g. defective SRS sensor). The best thing to do is a code scanning that will also reset the light, followed with troubleshooting and repair of the problem that is triggering the SRS warning.

Regards.


Ginko

Oct 15, 2011 | Cars & Trucks

1 Answer

Battery was low and put in new battery,problem SRC Light stays on how can I reset the SRC light?


I'm guessing you mean the SRS light, yes. When you have a bad battery the battery voltage can drop below 10 volts. The SRS unit detects this voltage loss and set a DTC (diagnostic trouble code) for an internal SRS unit failure. You have to erase the DTC memory. You'll need an SCS service connector tool (P/N 07PAZ-0010100) You can order one from your local honda dealer. Don't worry its not more than $10. Then you'll have to find the MES 2pin connector located in the upper right hand corner of the drivers underdash fuse box. It can be gray, green or yellow in color. 1.)Turn the ignition switch off. 2.)Unplug the MES connector from the fuse box and plug your SCS special tool into the MES connector. 3.) Turn the ignition switch on. 4.) The (red) SRS light in the dash will come on for 6 seconds and then go off. Remove the SCS tool from the MES (2P) connector within 4 sec. after the SRS light went off. 5.) The SRS light comes on again. Reconnect the SCS tool to the MES (2P) connector within 4 seconds after the SRS light came on. 6.) The SRS light goes off. Remove the SCS tool from the MES (2P) connector within 4 sec. 7.) The SRS light indicates that the memory is erased by blinking twice. 8.) Turn the ignition switch off and wait ten seconds. You may have to do this procedure a few time to get the steps correct. If this sounds to complicated I'm sure your local Honda dealer would be happy to reset the light for you for no charge. Just let them know that the battery was recently replaced and you think that the SRS light came on due to low battery voltage. -Hope this helps:)

Jan 13, 2010 | 1997 Honda Civic

3 Answers

How to reset srs light on 1996 e320 mercedes benz


try disconecting negative battery terminal for a few seconds

Aug 23, 2009 | 2005 Mercedes-Benz Mercedes Benz E320 Cdi

1 Answer

2001 ml 320 SRS light came on after battery went low from key on. Dealer playing games.


Take your car to an independent Mercedes Benz Mechanic Let your dealer know you will no longer be using him for you cars service.
The SRS is for your airbag system and is unable to deploy on a low battery have your NEW mechanic reset this when your battery is charged

Jul 07, 2009 | 2002 Mercedes-Benz C-Class

1 Answer

Reset srs light sorento 2004


Same problem here. Truck is at dealer now. Said I need a new Battery and Alternator, and of course leads and connectors and.......
$600. The nickle and dime game is now beginning. Time to sell if anyone will buy it.

May 06, 2009 | 2004 Kia Sorento

2 Answers

Srs light needs to be reset


Here's a quick check list for most common cost of SRS / Air bag problem.

Dirty contacts on driver and passenger seat belt buckles

Dirty contacts on seat belt connectors (under seats)

Dirty contacts on driver and passenger sides weight sensors (under seat)

Seat covers

Weight on passenger seat
(Example: grocery package trigger SRS / Air Bag light on the way home.)

I recommend you to pass an vacuum over the contacts and use CRC electronic parts cleaner to rule out connectivity problem.

I DO NOT recommend disconnecting the negative battery connector to clean the code(s).

Without the code(s) the dealer will takes "BILLABLE" time to reproduce the problem.

======

Please rate my answer if it is useful to you.

Cheers,

Mustgo

Apr 15, 2009 | 2000 Volvo S70

4 Answers

My srs light had been on


I have my srs light that just turned on. I have a c320 2002 how do I reset so that the light can come off

Jul 03, 2008 | 2002 Mercedes-Benz C-Class

Not finding what you are looking for?
1997 Acura RL Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Acura Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you an Acura Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...