Question about Isuzu Pickup
Isuzu npr 1994 where the transmission module is locaed ?
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: are there any thing to
The exhaust brake may be what you're looking for. The operation is usually by way of a stalk control or maybe a switch mounted on the dash in easy reach of the driver. When its active it works when you release your foot from the gas pedal and restricts the gas being exhausted from the engine, thereby slowing down without the use of the brake. Don't try to use it to stop! Its there for mountaines terain and steep hills....Over use can over heat the engine and cause cylinder head damage.
Posted on Oct 02, 2010
Testimonial: "someone else told me the same thing i wanted to be sure thanks very much"
Transmission control module The TCM is located on the driver's side under the dash.To the left of drivers side column,there are two connectors on module.The TCM is located on the drivers side under the dash up next to the kick panel.
The tranny control module (TCM) is behind the left side of dash, above kick panel. -------------
This will help.Thanks.Helpmech.
Posted on Jan 05, 2011
SOURCE: 1991 isuzu npr prime fuel system
normally the primer is on the filtre and bleed screw there too
what i normally do is fill the fuel filtre with clean diesol and fit and then prime if you r have=ing real difficulty you could open pipes going to injectors and turn over ttill you see the diesol coming from pipes ,but normally just prime it it should start
Posted on Nov 01, 2012
SOURCE: 1999 isuzu npr how do
Use a paper clip to connect terminals #4 & #11 of the DLC (OBDII) 16 pin connector located near the driver side kick panel. Turn the ignition to the ON position, DO NOT START. The CHECK TRANS light on the dash will flash any stored trouble codes. Codes will be repeated three times each. Flashing will continue until the jumper wire (paper clip) is removed. Here is an image of the DLC:
Posted on Nov 02, 2012
Tips for a great answer:
Apr 02, 2017 | Isuzu Cars & Trucks
Jan 27, 2017 | Isuzu Cars & Trucks
Sep 25, 2016 | Isuzu Cars & Trucks
Jun 09, 2016 | Isuzu Cars & Trucks
May 04, 2016 | Isuzu Cars & Trucks
Oct 18, 2015 | Isuzu Cars & Trucks
Jul 20, 2015 | Isuzu Cars & Trucks
Sep 28, 2013 | Isuzu Trooper Cars & Trucks
Feb 19, 2009 | 1994 Isuzu Rodeo
277 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: