Question about Nissan Pulsar

1 Answer

Battery wont jump start

Treid to jump start a 1988 Nissan pulsar but hooked the wrong terminals + - now nothing Where is the fuse I need to look at..?

Posted by on

  • Loupylick Jul 30, 2013

    I've checked the fuses under the dash and engine bay

  • Loupylick Jul 30, 2013

    But not even the ignition lights are on

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

U might need a new battery u couldv grounded urs out

Posted on Jul 30, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 142 Answers

SOURCE: Jump Started, Now More Problems

If you are lucky, it probably burnt a/or some fuses somewhere (probably higher amperage fuses, or a Maxi fuse (large fuse), or it might have burnt a fusible link (which looks like a normal wire and varies on locations depending on vehicles but is designed to melt and prevent current flow in the event of a current overload)

But, you also might have fried some electronic modules...

Posted on Aug 19, 2008

ginko
  • 19396 Answers

SOURCE: nissan pulsar wont start

Replace the sparks plugs, if the car is failing on one cylinder it will be hard to start.
Check the air intake and the air filter, if air filter is dirty replaced, only to test the car try starting with intake open and no air filter, if it starts it is an air intake problem.
Check the fuel filter and check that fuel have pressure, if fuel has no pressure it is either a faulty pump or an obstructed pipe.

Common cause for car not starting is distribution, with distribution rotor you often have to replace distributor cap or coil.
If it is electronic distribution you have to scan distribution module.

If you have an anti theft system, this can also cause the car not to start, usually you unlock anti theft with car key.

If it is none of the above, it can be a car computer problem, the car computer module (ECU) can be scanned using a code reader at any good garage, in this case the mechanic will get error codes from car ECU and be able to troubleshoot further the problem.

Posted on Aug 28, 2008

dnd_toolbox
  • 18 Answers

SOURCE: 1989 dodge ram 50 2.6l won't start after jumping other day, fuse?

Greetings!

When the battery terminals were replaced, be sure to check that all the wiring was correctly installed. (Pos+ to Pos+ and Neg- to Neg-, etc.)

Sounds like something got missed and the ignition system is not working... be sure to check the main fuses and replace any that are blown.

Cheers, Jay

Posted on May 09, 2009

  • 1 Answer

SOURCE: nissan pulsar 88 turns over but wont spark

check the sparkplugs

Posted on Jun 07, 2009

MARWAT
  • 124 Answers

SOURCE: no spark from 1988 nissan pulsar

BOT MA MAY B ,,,, BUT FIRST CHECK FUSEZ ,,,,, HAVE CHECKED POINT ?

Posted on Jul 23, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Roommate hooked battery up backwards on a 1988 nissan truck. sparks and smoke now just clicks but wont start.


At a minimum you probably blew a few major fuses - at worst you may have fried the ECM and/or other electronic component required to run the vehicle.

Nov 07, 2015 | Nissan Cars & Trucks

1 Answer

94 Nissan maxima i went to park it earlier it wouldn't go into park so i turned off left i nuetral keys wouldn't release so left them. later tried to start it and now car wont start


why dont you try and disconnect the battery terminals and see if you can shift it. and if not hook terminals back up. when you say it wont start are you inferring that the battery may also be dead? if so then you definitely will need to have a jump and once you jump it please make sure you let it run for a bit so that you can build up a charge ) the next thing i would dry to do if this also fails is check how you steering wheel lock is set up. i have had issue with my camaro with situation similar to yours. let me know how you make out

Nov 04, 2015 | 1994 Nissan Maxima

1 Answer

1993 nissan pick up won't start


Possibly a bad connection on the positive side coming from the battery or a weak ground. Check where the leads join the terminal clamps. Has the battery been verified as good? It doesn't take a lot of amps to run lights but it does to turn over the engine. Jump starting it does not require a fully charged battery.

May 01, 2017 | 1993 Nissan Pickup

1 Answer

Hi my 2004 pulsar had a flat battery now it wont start


HI and welcome to FixYa!

If the battery is dead I strongly suggest that you have a battery charging. Don't jump the battery while the car's battery connector is attached. This may damage the car's computer. Charging the battery can resolve the issue.

Hope this helps and thank you for using FixYa! Have a good one!

Feb 22, 2011 | 1990 Nissan Pulsar

1 Answer

1988 Nissan Pulsar will not engage clutch. Engine


You need to replace the clutch and pressure plate --your clutch is worn out. Plus other parts like throw-out bearing ,pilot bearing and may even need the flywheel machined flat.
You need to take it to a shop or if you are mechanicaly minded could do it your yourself,

Nov 15, 2009 | 1988 Nissan Pulsar

1 Answer

No spark from 1988 nissan pulsar


BOT MA MAY B ,,,, BUT FIRST CHECK FUSEZ ,,,,, HAVE CHECKED POINT ?

Jul 22, 2009 | 1988 Nissan Pulsar

1 Answer

Nissan pulsar 1988 wont go into gear I can put the gear stick in the right gear but does nothing wont reverse or drive, its automatic and has a reconditioned engine in it


try checking your transmission oil (i had the same problem but after $30 it was fixed) it might had drained out. if your transmission oil is fine then consult a mechanic preferebly an automatic transmission specialist. may be your transmission needs a rebuild.

May 20, 2009 | 1988 Nissan Pulsar

1 Answer

Nothing on the dash board works


Have a look at the main wire that comes from the battery, sometimes they run from the battery to a conector that corodes and then you loose all the power to the fuse box, that same bad conection can cause the alternator not to charge the battery and than you replace the alternator not fixing the route cause

Nov 14, 2008 | 1988 Nissan Pulsar

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

78 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...