Question about Cars & Trucks

1 Answer

Show me a picture were the thermal cooling sensor is located in a 1999 Chevy Tahoe

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.


    An expert that got 20 achievements.


    An expert that got 10 achievements.

  • Cars & Trucks Master
  • 21,873 Answers

Should be near the thermostat housing where the upper radiator hose connects. Sometimes it is on one of the cylinder heads.

Show me a picture were the thermal cooling sensor - 55e2f874-f4dd-415c-976f-e27774bc19b8.gif

Posted on Jul 29, 2013


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 1450 Answers

SOURCE: location of oil pressure sensor

it is in the valley of engine behind back of engine you can get it out with a thin walled oil sender socket.

Posted on Jan 15, 2009

  • 2 Answers

SOURCE: cooling fan switch/or sensor

The Coolant temp Sensor is located right under the top radiator hose (on the engine side), with a little black connector!, You might have to remove th etop hose to get to it with a deep socket and extension!.
Also Dont Forget to blled the coolant system by the bleeder valve uptop right near/above the coolant sensor!.(10MM Mini socket w/ extension IIRC!)

Posted on Sep 28, 2009

  • 6927 Answers

SOURCE: were bank 1 sensor 2 located on a 1997 tahoe

bank 1 is the drivers side,and it is the down stream sensor,the one after the cat,converter,If this was helpful,please let us know,thank you.

Posted on Jan 03, 2010

  • 752 Answers

SOURCE: where are the knock sensors located on a 02 chevy

It is usually below the the cylinder head on the passenger side towards the back of the engine. It has a white single mushroom shaped connector.

Posted on Jan 30, 2010

  • 58 Answers


Knock sensor can be found on top of the engine block, there are two you ´d have to remove the intake manifold to get to them,

Posted on Feb 19, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where is the ignition control module for the 1999

I think it is beneath the coils. Parts store may be able to show you on a locator chart.

Sep 28, 2014 | 1999 Chevrolet Tahoe

2 Answers

1997 chevy tahoe wont start

could be fuel pump or even crank or cam , timing sensor. Did it start running strange before this?

Jul 04, 2014 | 1999 Chevrolet Tahoe

1 Answer

99 chevy tahoe driver side window not working why?

athe side window may be binding in its track, overloading the motor and causing burnout or opening of the thermal breaker

Oct 26, 2012 | 1999 Chevrolet Tahoe

2 Answers

I've been having some problems with my Low Coolant Light flashing off and on,and after I get home and wait for my radiator and engine to cool down,I check my radiator and it's full of coolant! Is a...

Coolant level sensor failures are common. It is located in the radiator tank on the right (passeger) side of the radiator. it looks like the picture below. Also, there has been a lot of problems with the connector for these sensors. (see picture) AutoZone stocks BOTH of these parts. Inspect the connector for breakage, corrosion and insulation peeling off of the wires. If there are no problems found with the connector, then you can probably just replace the sensor.


Jul 04, 2011 | 1999 Chevrolet Lumina

1 Answer

My 1999 Chevy Tahoe wont start unless i spray starting fluid into the air intake but once it starts it runs fine, The fuel filter is brand new in it too, if it is the fuel pump how much will it cost me?

It is not a fuel pump problem.
It a cold start valve problem. It didn't open. There are 2 things to check.
1- The cooling thermal sensor is not sending the proper signal to the ECU to turn on the cold start valve.
2- The bad solenoid inside the cold start valve causing it not operational.
Case 1 you can easily replace the thermal sensor.
Case 2 checking this requires professional skill to confirm if there is a signal at the valve during the start.
Good luck

Aug 04, 2010 | 1999 Chevrolet Tahoe

1 Answer

How 2 fix a broken cooling system connector on a 1998 chevy tahoe

how can i replace the cooling system connector to my tahoe 1999?
I already purchased a new cooling system connector.
Should I pull out the hose from the old cooling system connector unscrew the old one, screw the new cooling system connector and insert the new one?

May 23, 2010 | 1998 Chevrolet Tahoe

1 Answer

I have a 99 chevy tahoe 4x4 5.7 i need to know were the camshaftnsencer is locate

The cam sensor is located inside the distributor and is held in place by two 15 torx screws.

Dec 21, 2009 | 1999 Chevrolet Tahoe

1 Answer

Where is the distributor located on a 1999 5.3L chevy vortec engine

There is no distributor. Firing is controlled by the computer which gets signals from crankshaft position sensor and camshaft position sensor for firing and timing.

Apr 29, 2009 | 2000 Chevrolet Tahoe

2 Answers

Location of oil pressure sensor on a 2003 chevy tahoe

it is in the valley of engine behind back of engine you can get it out with a thin walled oil sender socket.

Jan 15, 2009 | 2003 Chevrolet Tahoe

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

80608 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

15387 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides