Question about Cars & Trucks
Where does orange wire to on off switch go?
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Thick wires at IGN SW .... Red(s) - supply power from the battery to the IGN switch ... Pink - ignition supply ... Orange - Accessory power ... Purple most RWD sometimes (Yellow most FWD) - Starter .. Did I miss any? It's been a while The thin wires on the IGN swich are for key sense and VATS (if applicable)
Posted on May 08, 2009
Look on the relay for the terminal numbers.
Terminal 30 goes to the battery positive.Red Wire
The two terminal 87 go to the fog lights.Black Wires
Match the color wire with what you have on the relay connection for the rest of the wires.
Terminal 86 should connect to your low beam headlight.
Terminal 85 should go to the fog light switch.
The fog light switch should connect to the terminal 85 and the other terminal on the switch will connect to ground.
Posted on Feb 04, 2010
Ford has substantially altered their 1978-86 electronic ignition test
procedure. Due to the sensitive nature of the system and the complexity
of the test procedures, it is recommended that you refer to your dealer
if you suspect a problem in your 1978-86 electronic ignition system.
The system can, of course, be tested by substituting known good
components (module, stator, etc.)
This system, which at first appears to be extremely complicated, is actually quite simple to diagnose and repair. Diagnosis does, however, require the use of a voltmeter and an ohmmeter. You will also need several jumper wires with both blade ends and alligator clips.
The symptoms of a defective component within the solid state system are exactly the same as those you would encounter in a conventional system. Some of these symptoms are:
- Hard or no starting - Rough idle - Poor fuel economy - Engine misses while under load or while accelerating
If you suspect a problem in your ignition system, first perform a spark intensity test to pinpoint the problem. Using insulated pliers, hold the end of one of the spark plug leads about 1 / 2 inch; (12.7mm) away from the engine block or other good ground, and crank the engine. If you have a nice, fat spark, then your problem is not in the ignition system. If you have no spark or a very weak spark, then proceed to the following tests.
Tell if you are talking about this ignition system...
Hope this help.
Posted on May 11, 2010
Tips for a great answer:
Jul 12, 2016 | Mazda Cars & Trucks
Jun 12, 2012 | Cars & Trucks
Oct 13, 2011 | 1996 Ford Explorer
Oct 03, 2011 | 1999 Ford Explorer
Jun 29, 2011 | Ford F-150 Cars & Trucks
Jan 27, 2010 | 1990 Ford Thunderbird
Nov 25, 2009 | 2002 Ford Mustang
Oct 31, 2009 | 1996 Ford Explorer
Nov 14, 2008 | 2000 Ford Taurus
Jul 22, 2008 | 2003 BMW 330
60 people viewed this question
Usually answered in minutes!