Question about 2010 Toyota Yaris

Open Question

2010 toyota yaris remove rear light complete

I have a toyota yaris made in 2010. I want to replace the nearside rear light assembly which is cracked. how do I do it?

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1986 Answers

SOURCE: How do you replace rear tail light assembly?

Open the trunk and along the bottom of the tail light, there should be a Philips screw securing a cover piece. (your car may or may not have this piece)
With the cover off, there will be another 2 screws securing the bottom of the tail light assembly. Remove the screws and pull the bottom out and the top is held in by two retainers that should just slide right out

Posted on Oct 13, 2009

Ad
  • 246 Answers

SOURCE: 1997 toyota landcruiser colorado rear axle oil

You need to have your seal replaced. I would recommend installing new bearing while you're at it. Check here: http://www.autozone.com/autozone/catalog/parts/partsShelf.jsp?displayName=Differential+Seal+-+Rear&currentPage=1&categoryDisplayName=Drivetrain&navValue=11201715&itemId=1715-0&parentId=12-0

Posted on Nov 01, 2009

  • 4793 Answers

SOURCE: HI , JUST WANT TO ASK HOW COULD I REMOVE THE

on the front hinges ther are two spring clips use long nose pliers to remove and slide out pin.put on cover and REPLACE pins/clips.(spring clips look like washers)

Posted on Feb 24, 2010

MNfisherman
  • 11896 Answers

SOURCE: How do you replace the

remove the screws in the tail light housing. Either there will be 4 screws on the outside holding the housing, or there will be two plastic wing nuts on the inside behind the rear liner. Oce the screws or nuts are removed, then you can gently pry off the plastic tail light lens.

Posted on Oct 27, 2010

tgv1501
  • 870 Answers

SOURCE: My horn is not working

Your car is now and you better call your dealer and ask them to help you and it should be for free.

Posted on Dec 18, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My toyota yaris 2010 model speedometer is resing zero even the car is in motion, and the hand break light not switching off even if the hand break is lowerd.


Have the codes read. For the speedo, most likely the output speed sensor on the transmission. Check the brake fluid for the light

Jun 25, 2016 | 2010 Toyota Yaris

1 Answer

I need to remove valve cover on 2010 yaris


There are lots of good videos on YouTube. You may also find help on the Yaris forum:http://www.yarisworld.com/forums/archive/index.php/t-26502.html

Apr 17, 2015 | 2010 Toyota Yaris 1.0

1 Answer

How do i replace the fuel pressure regulator


Replacing fuel pressure regulator on Toyota Vitz, Yaris and Eco:
1. Remove rear seat.
2. Remove rear service hole cover.
3. Remove fuel pump and vapor pressure connector.
4. Start the engine till it stops on it own and switch the ignition to OFF.
5. Remove the tube joint clip, wrap a piece of cloth around it and pull out the main tube.
6. Pinch the fuel emission tube connector clip and pull it out.
7. Remove the 8 bolts and fuel tank vent tube set plate.
8. Remove the fuel pump assembly.
9. Remove the O ring from fuel pump assembly.
10. With help of screw driver remove the fuel pump locking plate.
11. Remove the fuel pump regulator with screw driver a bit force fully.
12. Assemble the fuel pump assembly in the reverse sequence of dis assembly.


25433541-jyg5ye5nncykpnrf0tfxcyn2-4-0.png
Hope that it works. Thank you for visiting Fixya.

Feb 15, 2015 | 2000 Toyota ECHO

1 Answer

Recently purchased a Toyota Yaris 2010 1.3 Engine shuts down periodically ...P/S light come on. Car shuts down ...takes another 10 minutes then starts up via ignition


Electric motor power steering is notoriously unreliable , even on newer car's , found that Toyota has a recall on some vehicles of the year , follow this link to check if your vehicle is affected
Toyota announces recall of some Yaris and Verso models for power steering...

Nov 07, 2014 | 2010 Toyota Yaris

1 Answer

Remove near side rear lights cover how do I do this


The rear side lights are held in place by screw/bolts that are accessed by opening the rear tail gate. They are on the inside near the edge. Usually a black 10mm bolt with a Philips "+" head. There are 2. Remove the and the light will come out as the full assembly. The cover is part of the light assemble and not be replaced.If it is cracked or broken the whole lamp assembly will need the be replaced.

j

Sep 25, 2014 | 2004 Toyota Yaris

1 Answer

How to change the front and rear fuel fillter on my 2010 toyota yaris


Okay, the yaris has only one filter which is inside the fuel tank. It's a non serviceable part. Sometimes you can clean it out if you use really good gas.

Jun 09, 2014 | 2010 Toyota Yaris

1 Answer

How to change the rear fuel filleter on a 2010 yaras


Here you can find a guide to fix and change almost everything on your car. http://microimageonline.com/forums/showthread.php?4232-YARIS-REPAIR-TECH-TSB-FILES

Jun 09, 2014 | 2010 Toyota Yaris

1 Answer

Changing headlight on toyota yaris nearside


that is covered in the operators guide in the glove box.
lost that>?
rtm , read the manual, its here free every day.


Mar 22, 2014 | Toyota Yaris Cars & Trucks

1 Answer

How do i deactivate srs so i can replace front seatbelts on 2005 yaris


Disconnect the battery negative terminal.
1. Wait at least 90 seconds after the ignition switch is
turned off and the negative (-) terminal cable is
disconnected from the battery before starting the
operation.
(The SRS is equipped with a back-up power source, so
if work is started within 90 seconds of disconnecting
the negative (-) terminal cable of the battery, the SRS
may be deployed).
2. Do not directly expose the steering pad, front
passenger airbag assembly, center airbag sensor
assembly, front airbag sensor, front seat inner belt
assembly, seat position sensor, occupant
classification ECU, front seat side airbag assembly,
side airbag sensor, curtain shield airbag assembly,
rear airbag sensor or front seat outer belt assembly to
hot air or flames.

Feb 26, 2013 | 2005 Toyota Yaris 1.3

1 Answer

How to replace the stop light bulb at top of rear window in my 2008 Toyota Yaris.


you cannot ,simple answer its a led light complete dealer only 80+euros plus tax

Jan 05, 2011 | 2008 Toyota Yaris Sedan

Not finding what you are looking for?
2010 Toyota Yaris Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8266 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...