Question about Cars & Trucks

Open Question

2013 ram 2500 remote start

My factory remote start starts the vehicle and within a few seconds it turns right back off on its own. The dash reads "remote start disabled, start vehicle to reset". It used to work but not anymore. No changes. Fob battery changed and it still does the same thing.

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 84 Answers

SOURCE: how do you change battery in key fob on 2002 vw golf

No problem. The key fob is two pieces. The key part and the remote. Open the key as you would to sue it. Where the key flips open you can see a small recess about where the line of the trunck switch. This is where the key separates. You can pull it off or pry it with a small screwdriver. Once separated with remote part in your hand this also splits in 2. In the same area you split the key off insert the screwdriver in this recess and the fob will open giving you access to the battery. Also can be done by hand. It is a little tight so you will have to force which is normal. No screws just clipped. Make sure the battery is positioned in the right way and that you have 3 volts when you test the battery. 2.7 volts will make the remote not work or act funny.

Posted on Nov 01, 2008

  • 1 Answer

SOURCE: the battery in my VW key fob is dead, now I cant start the engine

No. VW has made it nearly impossible to solve any key-related problems without a costly visit to the dealership. Battery must be replaced, and I assure you. the dealership will advise you that the ONLY place that you can find that particular battery is from the dealership. They like it that way.

Posted on Jan 20, 2009

  • 1 Answer

SOURCE: daytime running lights are not working on my 2005 equinox

Just had same problem. After ruling out easy checks like parking brake switch, and park shift selector switch, It was a burned out resistor that is located inside the front left fender. Take off the front tire, remove the inner fender liner, the ceramic resistor is towards the front. It crumbled when I removed it, Could only get replacement from dealer for about $65.

Posted on Jan 30, 2009

rockitman187
  • 2559 Answers

SOURCE: My key fob remote will not unlock car doors but will start car

Here you go.If you can't read it I can email it to you.
c2293a3.jpg

Posted on Aug 04, 2009

  • 1810 Answers

SOURCE: reset the security system after changing the batter - diesel Ram

insert key turn to on position alarm should silence
once bat conected start truck

Posted on Jan 22, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Park lights come on in a2008 gmc 2500 hd diesel when left parked not running factory remote start just died also any suggestions


lights stay on for short time after turning off vehicle or when you hit lock or unlock on fob as to auto start either fob battery died --fob malfunction--or you have a check engine code --have vehicle scanned because a pending trouble code may not light up on dash but will disable remote start --if it is a fob problem and you lost programming need to go to a dealer to flash the remote start

Jul 07, 2016 | GMC Cars & Trucks

1 Answer

Auto start shuts off within 10 seconds?


you have 2 choices
get car serviced,
or
read below. (pick one?)
sure, this is easy, (system logic not)
but you forgot to say , car starts with key, and runs perfect.
right. for get remove start toy.
certified , = warranted, or some bs.?

runs perfect means zero if the CEL glows running,
does car run perfectly you in seat starting with key and driving?
my guess you mean car stalls, 10second (ONLY ) remote started.
sure.
"engine light" means not running right, on all cars 1988 to now.

the XBM remote start will never work , with any errors from
ECU
PCM
BCM
or TCM
ever.
or if it sees doors ajar or alarms of any kind
by logic and federal laws.
scan it 1st and correct all DTC errors first.
that is what to do. if you are savvy and have a scan tool.
$10 to $100 tool, sold in all autostores usa.

think for 1 second how dangerous this FEATURE, can be.
hummmmmmm (a driverless moving car...)

why not read the FSM book on the 2013?
it covers most the logic, there.

quoted, so you can learn "complexity extreme"
verbatim
the following table below is a list of possible causes for the inoperative Remote Start System. If any of the following conditions exist, the Remote Start System will not work. Use this information as a guide to the diagnosis of the Remote Start System. ABORT BATTERY VOLTAGE HIGH BATTERY VOLTAGE LOW BRAKE PRESSED COOLANT TEMPERATURE HIGH CRANK NO START DRIVER DOOR AJAR PASSENGER DOOR AJAR LEFT REAR DOOR AJAR RIGHT REAR DOOR AJAR TRUNK/LIFTGATE AJAR HOOD AJAR NO HOOD SWITCH (INOPERATIVE) FUEL LEVEL LOW EXCESSIVE GLOW PLUG TIME (DIESEL ONLY) FAILED COUNTER REACHED (START) HAZARD LAMPS (SWITCH PRESSED) IGNITION IN RUN/START IGNITION NOT IN LOCK IGNITION SNA (SIGNAL NOT AVAILABLE FROM OTHER MODULE) INVALID KEY KEY IN IGNITION LOW RPM SHUTDOWN MIL ON NO AUTOMATIC TRANSMISSION NORMAL TIME OUT CUSTOMER ACCESS NORMAL TIME OUT RUN MODE (15 MINUTES) NOT CONFIGURED NOT ENABLED NOT IN PARK OR NEUTRAL NOT PROGRAMMED OIL PRESSURE LOW PANIC MODE (ACTIVATED) POWER LOSS RKE OFF MESSAGE RPM TOO HIGH (EXCEEDS 2500) START COUNTER REACHED VEHICLE SPEED HIGH VTA ALARMING If all of the previous items checked OK, and the remote starting system will not operate, refer to the REMOTE START POOR PERFORMANCE diagnostic procedure.

good luck running the engine in your garaged
and everyone eating carbon monoxide in the home.
good luck with that....."the silent killler"

Feb 19, 2016 | 2013 Jeep Grand Cherokee

1 Answer

Truck runs fine then dies while driving then will start back up and run ok.


About 56,700 results (0.76 seconds) Search Results

    GMC Sierra 1500 Questions - Truck suddenly stops running ...

    www.cargurus.com > Questions > GMC > Sierra 1500

    CarGurusJul 11, 2013 - Truck suddenly stops running, acting like it's out of fuel. ... start it and let it run until it dies then check the pressure and shut the key off. ... Was running fine and then turned off as if the ignition was turned of. .... Well mine was a loose battery connection that just shut down the vehicle completely while driving.

    1998 1500 5.2 Shuts Off Randomly - CarGurus

    www.cargurus.com > Questions > Dodge > Ram 1500

    CarGurusAug 29, 2011 - I let it sit for a second then tried to start it back up and it wouldn't start.... 2006 ram 1500 randomly dies while driving 13 answers ... truck started outrunning fine but would randomly die. wait a few ... Used GMC Sierra 1500".

    GMC Sierra 1500 Questions - started stalling and dying ...

    www.cargurus.com > Questions > GMC > Sierra 1500

    CarGurusJul 28, 2008 - The truck starts and dies. Have to give a little gas to keep running.While driving have to 2 foot it so it won't die. Wants to die when I come to a ...

    Engine Dies and Then Starts Right Back Up

    www.justautorepair.com/chevrolet/blazer/stalls-starts-up

Feb 04, 2016 | 1997 GMC Sierra

1 Answer

Remote starter comes only briefly and shuts off


Factory Remote Starter Quits After 5 Seconds - Diesel Place ...

www.dieselplace.com/.../340832-factory-remote-starter-quits-after-5-sec...

Nov 23, 2009 - 11 posts - ‎8 authors
On my 2007.5 Duramax, the factory remote has been working fine ... I tried this morning again with the remote starter while sitting in the truck and same thing, turned off ....2008 Silverado 2500 HD CCLB Duramax 6 Spd Allison 4X4 Z71 ... shut off engine", basically its doing it foryou as your not in the truck to ... check engine light on wont shift
7 posts
Oct 28, 2011
remote start
11 posts
Oct 14, 2008
More results from www.dieselplace.com

Factory Remote Start Problem - 1999-2006 & 2007-2013 Chevrolet ...

www.gm-trucks.com/forums/topic/114985-factory-remote-start-problem/

Jun 12, 2010 - 10 posts - ‎8 authors
Factory Remote Start Problem - posted in 1999-2006 & 2007-2013 ... Sounds like you may have an intermittant code coming in and the dealer should be able to pull it out.2008 Sierra SLT ECSB Z71, Corsa Touring, and GMPP CAI .... the remote start button again the truck WILL shut off and the only way to ... Burning smell, white smoke - 2014 / 2015 / 2016 ...
15 posts
Jan 11, 2014
2008 Silverado Electrical Issue
15 posts
Aug 19, 2012
Making Factory Remote Start Run Longer
15 posts
Dec 21, 2010
2000 Sierra, Starts Then Dies - Code 1631
7 posts
Dec 4, 2008
More results from www.gm-trucks.com

Jan 05, 2016 | 2008 Chevrolet Silverado 2500HD

1 Answer

My 2001 dodge ram key fob was stolen. can i reprogram?


Try this....
ATTENTION: You MUST HAVE one working remote to add one more to the system. If you do not have one working remote right now then these instructions will not work. You will have to have a Locksmith or dealership use a computer to program the first remote for you.


1. Turn ignition to run position (as far as you can go without starting engine).
2. Using any Working remote, press the UNLOCK button for 4 to 10 seconds.
3. Within the specified 4 to 10 seconds, continue pressing the UNLOCK buton and press
the PANIC button for 1 second and release both buttons at the same time. A chime will
sound within 3 seconds to indicate that the vehicle has entered remote programming
mode.
4. Within 30 seconds of the chime, press any button on all remotes to be programmed
including previously programmed remotes. A chime will sound after each remote is
programmed.
5. Turn ignition to OFF and remove key.
6. Test all remotes.

Jan 06, 2014 | 2009 Dodge Ram 2500

1 Answer

In the 2003 ram 1500 laramie 5.7 does the check engine light come on when you turn the key on


It is normal for all the lights on the dash to blink when turning the key ON for the first time. However, the light should turn off after few seconds. If it does not, you should better get the codes read.

May 09, 2013 | 2007 Dodge Ram 2500 Mega Cab Laramie

2 Answers

MY DODGE RAM HAS A FACTORY INSTALLED REMOTE START BUT THE REMOTE STOPED WORKING I CHANGED THE BATTERY BUT STILL DOES NOT WORK ANY DEAS WHY


Oreilly Automotive stores have a little device the picks up a signal from a remote. Maybe your local parts store will have one. This will verify that your key F.O.B. is working. After that....fuses or possibly a frequency switch in the key FOB got bumped when you changed batteries. Otherwise, catastrophic failure....sorry.

May 09, 2010 | 2007 Dodge Ram 2500 Mega Cab Laramie

1 Answer

2004 Dodge Ram Diesel. Check engine light comes


You will need to have a diagnostic test on this vehicle which will then provide you some error codes.Then once you get the error code you can start looking where the fault is.Hope this helps.

Dec 08, 2009 | 2004 Dodge Ram 2500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...