Question about Cars & Trucks
Posted by Anonymous on
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
its a pitcock facing the cab bottom of the radiator, plastic flat. once you find the pitcock just put a bucket underneath and turn it.then refill. if you want to flush(run fluid thru to clean it out) the radiator id suggest taking it in. you dont have to flush it every time you change the coolant out.
Posted on Mar 28, 2009
JUST COMPLETED THIS JOB TODAY. MAKE SURE THE ENGINE HAS COOLED DOWN . IT TOOK APPROX 2 1/2 HRS. DISCONNECT THE NEGATIVE POST ON THE BATTERY. JACK UP PASSENGER SIDE FRONT AND SUPPORT ON JACK STANDS. REMOVE PASS. FROUNT TIRE. DRAIN RADIATOR INTO CONTAINER FOR PROPER DISPOSAL OR REUSE. USING FLOOR JACK PROVIDE SLIGHT TENSION ON OIL PAN WITH A SHORT 2 X 4 WOOD PIECE TO PROTECT OIL PAN. LOOSEN 3 ENGINE MOUNT BOLTS ON PASS. SIDE OF ENGINE COMPARTMENT. ALLOW APPROX 1" BETWEEN SHOULDER OF BOLTS AND MOUNT. LOWER ENGINE UNTILL BOLTS ARE SET ONTO MOUNT. REMOVE ENGINE SPLASH SHIELD INSIDE WHEEL WELL OF REMOVED TIRE. LOCATE WATER PUMP AND LOOSEN 3 PULLEY MOUNTING BOLTS (THIS IS WHILE BELT IS ON PULLEY) REMOVE SURPENTINE BELT AND CONTINUE TO FULLY REMOVE THE PUMP PULLEY. IT WONT COME OUT AS THE PUMP & PULLEY HAVE TO COME OUT TOGEATHER. REMOVE 5 WATER PUMP BOLTS AND CAREFULLY WORK WATER PUMP OUT BETWEEN THE ENGINE AND VEHICLE FRAME. CLEAN ALL MATING/GASKET SURFACES AND BOLTS. USING A SMALL AMOUNT OF TACKY SEALENT TO INSURE THE NEW WATER PUMP SEAL STAYS IN PLACE, THE INSTALL IS PRITTY MUCH THE REVERSAL OF REMOVAL.
GOOD LUCK, REMEMBER TO TIGHTEN ALL BOLTS TO MFR SPECS AND BLEED THE AIR OUT OF THE COOLANT AS REQUIRED.
Posted on Apr 29, 2009
The drain is located on the passenger side of the radiator at the bottom. Turn it counterclockwise to open. It is plastic so be careful if you decide to use tools to turn.
Posted on Jul 23, 2009
If you have a 3.3 or 3.8 engine the PCV valve is located on the back valve cover and un screws counter clockwise careful its only plastic
Posted on Apr 09, 2010
Tips for a great answer:
Nov 01, 2016 | Dodge Cars & Trucks
Aug 06, 2014 | 2007 Dodge Caravan
Jul 05, 2011 | 2005 Dodge Caravan
Apr 23, 2010 | 2005 Dodge Caravan
Apr 09, 2010 | 2005 Dodge Caravan
Oct 14, 2009 | 2005 Dodge Caravan
Jul 04, 2009 | 2005 Dodge Grand Caravan
Jun 14, 2009 | 2005 Dodge Grand Caravan
May 13, 2009 | 2005 Dodge Grand Caravan
May 23, 2018 | Cars & Trucks
68 people viewed this question
Usually answered in minutes!